-
AEG SCT81800S0 - page 1
SCT81800S0 EN User manual ...
-
AEG SCT81800S0 - page 2
CONTENTS 1. SAFETY INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 2. CONTROL PANEL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 3. DAILY USE . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ...
-
AEG SCT81800S0 - page 3
1. SAFETY INSTRUCTIONS In the interest of your safety and to en- sure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. To avoid unnecessary mis- takes and accidents, it is important to ensure that all people u sing the appli- ance are thoroughly familiar with its op ...
-
AEG SCT81800S0 - page 4
WARNING! Any electrical component (p ower cord, plug, compressor) must be replaced by a certified service agent or qualified service per- sonnel to avoid hazard . 1. Power cord must not be length- ened. 2. Make sure that the power plug is not squashed or damaged by the back of the appliance. A sq uashed or damage d power plug ma y overheat and caus ...
-
AEG SCT81800S0 - page 5
• The appliance must not be located close to radiators or cookers. • Make sure that the mains plug is a c- cessible after the installation of the ap- pliance. • Connect to potable water supply only (If a water connection is foreseen). 1.6 Service • Any electrical work required to do the servicing of the appliance should be carried out by a ...
-
AEG SCT81800S0 - page 6
9 Alarm indicator 10 Child Lock function 11 Minute Minder function 12 DYNAMICAIR function 2.2 Switching on To switch on the appliance do these steps: 1. Connect the mains plug to the pow- er socket. 2. Press the appliance ON/OFF button if the display is off. 3. The alarm buzzer could operate af - ter few seconds. To reset the alarm r efer to " ...
-
AEG SCT81800S0 - page 7
The Timer start to flash (min). At the end of the countdown the Minute Minder indicator flashes and an audib le alarm sounds: 1. Remove any drinks contained in the freezer compartment. 2. Press OK button to switch off the sound and terminate the function. It is possible to deactivate the function at any time during th e countdown: 1. Press the Mode ...
-
AEG SCT81800S0 - page 8
To switch on the function: 1. Press the Mode button until the cor- responding icon appears. The Holiday indicator flashes. The fridge temperature indicator shows the set temperature. 2. Press the OK button to confirm. The Holiday indicator is shown. To switch off the function: 1. Press the Mode button until the Hol- iday indicator flashes. 2. Press ...
-
AEG SCT81800S0 - page 9
The maximum amount of food that can be frozen in 24 hours is specified on the rating plate , a label located on the in- side of the app liance. The freezing process lasts 24 hours: dur- ing this period do not add other food to be frozen. 3.3 Storage of frozen food When first starting-up or after a period out of use, before putting the products in t ...
-
AEG SCT81800S0 - page 10
3.8 Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be placed at different heights. 3.9 Positioning the sliding box The sliding box can be pla ced at differ- ent heights. Do make these adjustments proceed as follow: 1. lift the shelf with the sliding box up - wards and out of the holders in the ...
-
AEG SCT81800S0 - page 11
3.11 DynamicAir The refrigerator compartment is eq uip- ped with a device that allows for rapid cooling of foods and more uniform tem- perature in the compartment. This device activates by itself when nee- ded, for example for a quick tempera- ture recovering after door opening or when the ambient temperature is high. Allows you to switch on the de ...
-
AEG SCT81800S0 - page 12
• the maximum quantity of food which can be frozen in 24 hrs. is shown on the rating plate; • the free zing process takes 24 hour s. No further food to be frozen should be added during this period; • only freeze top quality , fresh and thor- oughly cleaned, foodstuffs; • prepare food in small portions to ena- ble it to be rapidly and comple ...
-
AEG SCT81800S0 - page 13
After cleaning, reconnect the equip ment to the mains supply. 5.2 Replacing the carbon air filter To get the best performance the carb on air filter should be changed once every year. New active air filters can be purchased from your local dealer. Refer to "Installation of the carbon air fil- ter" for the instructions. The air filter is a ...
-
AEG SCT81800S0 - page 14
Problem Possible cause Solution The appliance is noisy The appliance is not sup- ported properly Check if the applianc e stands stable (all the four feet should be on the floor) The appliance does not operate. The lamp does not oper- ate. The appliance is switched off. Switch on the appliance. The mains plug is not connected to the mains socket cor ...
-
AEG SCT81800S0 - page 15
Problem Possible cause Solution Water flows on the rear plate of the re- frigerator. During the automatic de- frosting process, frost de- frosts on the rear plate. This is correct. Water flows into t he refrigerator. The water outlet is clog- ged. Clean the water outlet. Products prevent that wa- ter flows into the water collect or. Make sure that ...
-
AEG SCT81800S0 - page 16
6.1 Replacing the lamp The appliance is equipped with a long- life LED interior light. Only service is allowed to replace the lighting device. Contact your Service Center. 6.2 Closing the door 1. Clean the door gaske ts. 2. If necessary, adjust the door. Refer to "Installation". 3. If necessary, replace the defective door gaskets. Contact ...
-
AEG SCT81800S0 - page 17
3. Connect the wire coloured brown to the terminal either marked with the “L“ or coloured red. 4. Check that no cut, or stray strands of wire is present and the cord clamp D is secure over the outer sheath. 5. Make sure the electricity supply volt- age is the same as that indicated on the appliance rating plate. 6. Switch on the appliance. The ...
-
AEG SCT81800S0 - page 18
• Loosen the middle hinge . • Remove the lower door. • Loosen and remove the low er pin. On the opposite side: • Tighten the lower pin. • Install the lower door. • Tighten the middle hinge. • Install the spacer. • Install the upper door. • Tighten the upper pin. 7.5 Ventilation requirements 5 cm min. 200 cm 2 min. 200 cm 2 The air ...
-
AEG SCT81800S0 - page 19
x x If necessary cut the adhesive sealing strip and apply it to the appliance as shown in figure. 1 2 Install the appliance in the niche. Push the appliance in the direction of the arrow (1) until the upper gap cover stops against the kitchen furniture. Push the appliance in the direction of the arrow (2) against the cupboard on the opposite side o ...
-
AEG SCT81800S0 - page 20
I I Attach the appliance to the niche w ith 4 screws. Remove the correct part from the hinge cover (E). Make sure to remove the part DX, in the case of rig ht hinge, SX in opposite case. E E B D C Attach the covers (C, D) to the lugs and the hinge holes. Install the vent grille (B). Attach the hinge covers ( E ) to the hinge. 20 www.aeg.com ...
-
AEG SCT81800S0 - page 21
G H Connect the appliance laterally to the kitchen furniture sidewall: 1. Loosen the screws of the part (G) and move the part (G) till the furni- ture sidewall. 2. Tighten the screws of the part (G) again. 3. Attach the part (H) to the part (G). Disconnect the part s (Ha), (Hb), (Hc) and (Hd). ca. 50 mm ca. 50 mm 21 mm 90° 90° 21 mm Install the p ...
-
AEG SCT81800S0 - page 22
Ha Hc Push the pa rt (Hc) on the part (H a). Ha Hb 8 mm Open the appliance door and the kitchen furniture door at an angle of 90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes. Ha K 8 mm Remove the brackets an d mark a dis- tance of 8 mm from the outer edge of the door wher ...
-
AEG SCT81800S0 - page 23
Hb Place the small square on the guide again and fix it with the screws sup- plied. Align the kitchen furniture door and the appliance door by adjusting the part (Hb). Hb Hd Press the part (Hd) on the part (Hb). Do a final check to make sure that: • All screws are tightened. • The sealing strip is attached tightly to the cabinet. • The door o ...
-
AEG SCT81800S0 - page 24
CLICK! CLICK! SSSRRR! SSSRRR! BRRR! BRRR! HISSS! HISSS! BLUBB! BLUBB! CRACK! CRACK! 24 www.aeg.com ...
-
AEG SCT81800S0 - page 25
9. TECHNICAL DATA Dimension of the recess Height 1780 mm Width 560 mm Depth 550 mm Rising Time 25 h Voltage 230-240 V Frequency 50 Hz The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. 10. ENVIRONMENT CONCERNS Recycle the materials with th e symbol . Put the packaging in ap ...
-
AEG SCT81800S0 - page 26
26 www.aeg.com ...
-
AEG SCT81800S0 - page 27
ENGLISH 27 ...
-
AEG SCT81800S0 - page 28
www.aeg.com/shop 222358291-A-052013 ...
У вас вопрос, касающийся AEG SCT81800S0?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с AEG SCT81800S0, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с AEG SCT81800S0 со всей вероятностью он захочет поделиться методом ее решения.