-
Smeg DF410SF7 - page 1
INSTRUCTION MANUAL G G U U I I D D E E F F O O R R U U S S I I N N G G T T H H E E D D I I S S H H W W A A S S H H E E R R A A N N D D T T H H E E W W A A S S H H I I N N G G P P R R O O G G R R A A M M S S ...
-
Smeg DF410SF7 - page 2
Contents 1 1. Safety and operati ng instructions ___________________________ 2 2. Installation an d hook-up ___________________________________ 5 3. Description of t he controls _________________________________ 9 4. Operating inst ructions ___________________________________ 16 5. Cleaning and maintenance _______________________________ 26 6. Trou ...
-
Smeg DF410SF7 - page 3
Safety instructions 2 1. Safet y and operating instructions THIS MANUAL FORMS AN INTEGRAL PART OF THE APPLI ANCE: IT MUST ALWAYS BE KEPT INTACT TOGETHER WITH THE DISHWASHER. BEFORE USING THE APPLIANCE, CAREFULL Y READ ALL THE INSTRUCTIONS CONTAINED IN THIS MANUAL. INSTALLATION MUST BE PERFORMED B Y A QUALIFIED TECHNICIAN, IN COMPLIANCE WITH THE REG ...
-
Smeg DF410SF7 - page 4
Safety instructions 3 OBSOLETE APPLIANCES MUST BE RENDERED UNUSABLE. CUT OFF THE MAINS POWER CORD AFTER UNPLUGGI NG IT FROM THE WALL OUTLET, AND MAKE SAFE ANY COMPONENTS WHICH MIGHT BE DANGEROUS FOR CHILDREN (LOCKS, DOORS, ETC.). THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE 2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT ( W ...
-
Smeg DF410SF7 - page 5
Safety instructions 4 LEANING OR SITTING ON THE DISHW A S HER DOOR WHEN OPEN M A Y CAUSE THE APPLIANCE TO OVERTURN, PUTING PEOPLE AT RISK. NEVER LEAVE THE DISHWASHER DOOR OPEN; PEOPLE MIGHT TRIP OVER IT. DO NOT DRINK THE WATER RESIDUES WHICH MAY BE PRESENT INSIDE THE DISHES OR DISHWASHER AT THE END OF THE WASHING PROGRAM AND BEFORE THE DRYING CYCLE ...
-
Smeg DF410SF7 - page 6
Installation instructions 5 2. Installation and hook-up Remove the polystyrene bask et retainers. Position the appliance in the desired place of installation. The back or sides of the dish washer may be placed up a gainst walls or other furniture units. If the dishwasher is installed near a heat source, fit the special insulating panel to prevent o ...
-
Smeg DF410SF7 - page 7
Installation instructions 6 CONNECTING TO THE WATER SUPPLY Connect the intake hose to a cold water supply with ¾” gas thread, inserting the filter A supplied w it h the dishwasher. Take care to screw the hose firmly into place with your h ands and then complete b y tightening about ¼ of a turn with pliers. In dishwasher s equipped with the ACQU ...
-
Smeg DF410SF7 - page 8
Installation instructions 7 2.2 Electrical connection and precaution s CHECK THAT THE VOLTAGE AND THE FREQUENCY OF THE MAINS MATCH THE RATINGS ON THE NAME PLATE OF THE APPLIANCE POSITIONED ON THE INNER EDGE OF THE DOOR. THE PLUG ON THE SUPPLY CORD AND THE CORRESPONDING SOCKET OUTLET MUST BE OF THE SAME TYPE AND MEET THE REGULATIONS IN FORCE. THE PL ...
-
Smeg DF410SF7 - page 9
User instructions 8 FOR GREAT BRITAIN ONLY: THIS APPLIANCE MUST BE E ARTHED. Fuse replacemen t If the mains lead of this appl iance is fitted with a BS 1363A 13amp f used plug, to change a fuse in this type of plug use a n A.S .T .A. ap proved fuse to BS 1362 type and proceed as follo w s : 1. Remove the fuse cover A and fuse B . 2. Fit replacement ...
-
Smeg DF410SF7 - page 10
User instructions 9 3. Description of the controls 3.1 Front panel All the dishwasher controls are groupe d on the front panel. 1 ON/OFF BUTTON 2 SELECTION PROGRAM BUTTONS (P1…P5) 3 "3/1" OPTION BUTTON 4 DELAY PROGRAM BUTTON 5 START/STOP BUTTON 6 POWER ON LIGHT 7 PROGRAMS INDICATOR LIGHTS 8 INFORMATION DISPLAY 9 RECESSED DOOR HANDLE 3.2 ...
-
Smeg DF410SF7 - page 11
User instructions DURATION CONSUMPTION PROGRAMME, NUMBER & SYMBOL LOAD CROCKERY AND CUTLERY PROGRAM PROGRESS 10 MINUTES WAT ER LITRES (1) POWER KWh (2) 1 SOAK Pans and dishes awaiting a further wash Cold prewash (**) 5 0,02 2 QUICK Dishes with light dirt Wash at 38°C Cold rinse Rinse at 58°C (**) 13 0,70 3 ECO (*) EN 50242 Wash immediately af ...
-
Smeg DF410SF7 - page 12
User instructions 11 3.3 Washing programs The dishwasher is equ ipped with a control panel and an INFORM A TIO N DISPLAY (9) from which it is possible to carry out all the power switch- on, switch-off and programming operations. Before starting a washing program make sure that: • The water supply tap is open. • The correct amount of detergent h ...
-
Smeg DF410SF7 - page 13
User instructions SELECTION PROGRAM The program selection is possible through the relative buttons (2) . By pressing the relative butto n of desired program (see tab le) it will lid up the relative pilot light to confirm t hat the operation di d occurred on the DISPLAY (9) will appear a program duration forecasting (“ h.m m ”). START PROGRAM At ...
-
Smeg DF410SF7 - page 14
User instructions 13 TO CHANGE A PROGRAM To change the running pr ogram it is necessary: • to interrupt the running progra m (see “ I NTERRUPTING A PROGRAM ”); • select the new program; • to press again the ST A RT/STOP button (5) to make start the new program. STOPPING A PROGRA M To stop a program in progress, it must first be interrupte ...
-
Smeg DF410SF7 - page 15
User instructions DELAYING THE PROGRAM (on some mode ls only) (available in all programs except the soak pro gram) The PROGRAM DELA Y butt on (4) can be pressed to delay the start of the program by up to 12 hours . This means that the dishwasher can be operated at the time of day of your choice. The first time the PROGRAM DELAY button (4) is presse ...
-
Smeg DF410SF7 - page 16
User instructions 15 TO SAVE ON ENERGY! … AND PROTECT THE ENVIRONMENT • Always try to run the dishwasher fully loaded . • Do not wash the dishes in running water. • Use the washing progr am that is most appropriate for each type of load. • Do not carry out any preliminary rinsing. • If available, connect the dis hwasher to a hot water s ...
-
Smeg DF410SF7 - page 17
User instructions 16 4 . Operating instructions Once the dishwasher h as been correctly installed, prepare for us e as follows: • Adjust the water softening system; • Add the regenerating salt; • Add the rinse aid and deterge nt. 4.1 Using the water softening system The amount of scale contain ed in the water (water hardness inde x) can cause ...
-
Smeg DF410SF7 - page 18
User instructions 17 • Do not use table salt as it contains insoluble substances which, over time, may damage the water softening system. • When necessary, refill the r ege nerating salt container before starting the washing program . In this way, the excess saline solution will be immediately remove d by the water; the prolonged presence of sa ...
-
Smeg DF410SF7 - page 19
User instructions WATER HARDNESS TABLE WATER HARDNESS German Degrees (°dH) French Degr ees (°dF) SETTING 0 - 4 0 - 7 Setting N. 1 NO SALT 5 - 15 8 - 25 Setting N. 1 16 - 23 26 - 40 Setting N. 2 24 - 31 41 - 60 Setting N. 3 32 - 47 61 - 80 Setting N. 4 48 - 58 81 - 100 Setting N. 5 Contact your local w a ter board for information on the har dness ...
-
Smeg DF410SF7 - page 20
User instructions 19 ADDING THE RINSE AID The rinse aid he lps the dishes dry faster and prevents the formation of scale deposits and staining; it is automatic all y added to the water during the final rinse c ycle, from the container situated on the inner side of the door. To add rinse aid: • Open the door. • Rotate the container cap anticlock ...
-
Smeg DF410SF7 - page 21
User instructions 20 ADDING THE DETERGENT To open the detergent dispenser cap, l ightly press the button P . Add the detergent and clos e the cap carefully. During the washing cycle, the disp enser will be opened automatically. • When a program with hot prewash is selected (see program table), extra detergent must be placed in the cavity G/H (dep ...
-
Smeg DF410SF7 - page 22
User instructions 21 • "3/1" Products If you wish to use detergents which already contain salt and rinse aid, check whether your dis hwasher is fitted with the " 3/1 option button " on the " Controls description " page and then ref er to the section which explains how to use this funct ion. If the button is not provi ...
-
Smeg DF410SF7 - page 23
User instructions WARNING! • Make sure that the dishes are secu rely in place so that they cannot tip over or obstruct the rotati on of the spray arms during the washing cycle. • Do not place very small obj ects in the baskets as these could fall and obstruct the spray arms or the wash pump. • Containers such as cups, bowls, glasses and pots ...
-
Smeg DF410SF7 - page 24
User instructions 23 4.4 Using the baskets The dishwasher has a capacit y of 10 place-settings , including serving dishes. LOWER BASKET The lower basket receives the full force o f the lower spray arm, and should therefore be use d for the “t oughest” items with a heavier degree of soiling. All types and combinatio ns of loads are permitted, pr ...
-
Smeg DF410SF7 - page 25
User instructions 24 CUTLERY BASKET The cutlery should be arrang ed in an orderly manner inside the basket, with the handles pointin g downwards. Take care during loadi ng to avoid injury from the knife blades. T he basket is suitable for all types of cutlery, except those l ong enough to interfere w i th the upper spray arm. Lad les, wooden spoons ...
-
Smeg DF410SF7 - page 26
User instructions 25 LOADING THE UPPER BASKET Load plates facing for ward; cups, bowls etc. must always be faci ng downwards. The left-hand si de of the basket can be loaded with two layers of cups an d glasses. On the right plates and s aucers can be slotted verticalli into the forks. Loading examples: ADJUSTING THE UPPER BA S KET The upper basket ...
-
Smeg DF410SF7 - page 27
User instructions 26 5. Cleaning and maintenance Before carrying out any work, a lways unplug the appliance from the electrical supply or switch off the all-pol e disconnection device. 5.1 General warnings and recommendations Avoid the use of acidic or abrasi ve detergents. Clean the outer surfaces and door-linin g of the dishwasher regularly using ...
-
Smeg DF410SF7 - page 28
User instructions 27 CLEANING THE SPRAY ARM, TRAVELLING VERSION To remove the TRAVELLING spray arm, take hold of it and raise it t o release both the spray arm and the pipe from the tank, then detach the spray arm from the pip e. Wash both the pipe and the spra y arm in running water, re-attach the spra y arm to the pipe and return the assembly to ...
-
Smeg DF410SF7 - page 29
User instructions GENERAL WARN INGS AND RECOMMEN DATIONS FOR CORRECT MAINTENANCE: • The filters should be cleaned under running water us ing a stiff brush. • When removing the filter , take care tha t there are no food re sidues on it. If any residue s fall into the washing pi t they might block hydraulic components, or foul the sp ray arm no z ...
-
Smeg DF410SF7 - page 30
User instructions 29 If the dishes are not being cleaned p roperly, check that: • the correct amount of det ergent has been ad ded; • there is regenerating salt in side the special c ontainer; • the dishes are being load ed correctly; • the selected program is suitable for the dish types and thei r degree of soiling; • all the filters are ...
-
Smeg DF410SF7 - page 31
User instructions 30 6. T roubleshooting The dishwasher is equ ipped with a self-diagnostics s ystem that is capable of detecting and sign alli ng a number of possible faults. TABLE OF FAULTS DETECTED BY THE SELF-DIA G NOSTICS SYSTEM FAULT DESCRIPTION E1 The anti-flooding system ( w h ere pr esent) has been tripped service. E2 The water level limit ...
-
Smeg DF410SF7 - page 32
User instructions 31 TECHNICA L DATA Width 447 ÷ 449 mm Depth measured flush w ith the outer edge of the control panel 600 mm Height from 850 mm to 870 mm Capacity 10 Standard place settings Water supply pressure min. 0,05 - max. 0,9 MPa (min. 0.5 – max. 9 bar) Electrical characteristics See rating plate ...
У вас вопрос, касающийся Smeg DF410SF7?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Smeg DF410SF7, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Smeg DF410SF7 со всей вероятностью он захочет поделиться методом ее решения.