-
Toshiba Toshiba Network Camera - page 1
NETWORK CAMERA Model: IK-WR14A Quick Start Guide and Important Safeguards This guide describes the hardware installation. Refer to the user's manual (PDF le) contained in the CD-ROM for settings, operations and other information. The application Adobe Reader is needed to view PDF les. If you do not have this application, download it from ...
-
Toshiba Toshiba Network Camera - page 2
2 2 Introduction FCC (USA)-INFORMA TION NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment genera ...
-
Toshiba Toshiba Network Camera - page 3
3 Thank you for purchasing the IK-WR14A Network Camera. Before using the camera, read this quick start guide carefully to ensure correct usage. After reading this quick start guide, save it for future reference. The design, specications, software, and quick start guide contents are subject to change without prior notice. T erms and T rademarks l ...
-
Toshiba Toshiba Network Camera - page 4
4 4 T able of Contents Introduction 2 FCC (USA)-INFORMA TION ....................................................................................... 2 T erms and T rademarks .............................................................................................. 3 T able of Contents............................................................. ...
-
Toshiba Toshiba Network Camera - page 5
5 Important Safeguards 1. Read Instructions Read all the safety and operating instructions before operating the product. 2. Retain Instructions Retain the safety instructions and user's manual for future reference. 3. W arnings Comply with all warnings on the product and in the user's manual. 4. Follow Instructions Follow all operating an ...
-
Toshiba Toshiba Network Camera - page 6
6 6 12. Lightning For additional protection on this camera during a lightning storm, or when it is left unattended and unused for long periods of time, unplug it from the wall outlet and disconnect the power supply and cable system. This will prevent damage to the camera due to lightning and power-line surges. If lightning occurs, do not touch the ...
-
Toshiba Toshiba Network Camera - page 7
7 Important Safeguards (Cont.) CAUTION T O REDUCE THE RISK OF ELECTRIC SHOCK. DO NOT REMOVE COVER. NO USER SER VICEABLE P ARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. The lightning ash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" ...
-
Toshiba Toshiba Network Camera - page 8
8 8 Notes on Use and Installation l Do not aim the camera at the sun Never aim the camera at the sun even with the camera power off. l Do not shoot intense light Intense light such as a spotlight may cause a bloom or smear . A vertical stripe may appear on the screen. However , this is not a malfunction. l T reat the camera with care Dropping or su ...
-
Toshiba Toshiba Network Camera - page 9
9 9 Setting the Network Camera Environment Items needed for network camera monitoring l Administrator's personal computer The personal computer that allows setting, operating, monitoring and other functions with the network camera is called the "administrator's personal computer" in this guide. * The personal computer for viewin ...
-
Toshiba Toshiba Network Camera - page 10
10 10 l IK-WR14A l W aterproof Connector & Bushing l A V Out cable l W arranty Card l Quick Start Guide and Important Safeguards l Gasket, T orx Wrench, Silica Gel and tape, Hex Nut , Screws and Anchors Package Contents l CD-ROM l Alignment Sticker/Mounting Plate ...
-
Toshiba Toshiba Network Camera - page 11
1 1 1 1 Physical Description Cover screws Side Opening Cover Dome Cover Replace the side opening cover with the supplied bushing if you want to route cables from the side of camera. The 1/2" (12.7mm) protection conduits and tubing are not supplied. Camera Base NO TE ...
-
Toshiba Toshiba Network Camera - page 12
12 l Front View CAMERA BASE l Rear View IR LEDs (SR-LED) Focus Button Light Sensor Lens Status LED Mounting screws Micro SD/ SDHC Card Slot Recessed Reset Button DIP switch Audio/Video Out (Printed "A V Out") 10/100BaseT Ethernet Socket MIC In (Printed "Audio In") Microphone Video Output internal external NTSC 60Hz P AL 50Hz 1 2 ...
-
Toshiba Toshiba Network Camera - page 13
13 Hardware Installation Bottom of the Camera First, use the supplied torx wrench to detach the dome cover from the camera base. Then, follow the steps below to install the camera; either to a ceiling or to a wall. Connect the appropriate power cables and external devices such as sensors and alarms, to the general I/O terminal block. Cabling Assemb ...
-
Toshiba Toshiba Network Camera - page 14
14 14 14 1 . Disassemble the components of the waterproof connector into parts (A) ~ (E) as shown above. And Hex Nut is including in the accessory separately . 2. Place the screw nut (E) as shown. 3 . Feed the power cables through the waterproof connector (F --> E --> D --> B --> A) as the ill ust rat io n sh ows . T hen con nec t the p ...
-
Toshiba Toshiba Network Camera - page 15
15 NO TE 4 3 o O g B b G br BR 1 2 3 4 5 6 7 8 o: white/orange stripe O: orange solid g: white/green stripe B: blue solid b: white/blue stripe G: green solid br: white/brown stripe BR: brown solid 3. Y ou will need an RJ45 crimping tool to attach the Ethernet wires to a connec- tor . When done, connect the cable to the camera’s Ethernet socket . ...
-
Toshiba Toshiba Network Camera - page 16
16 l Installation should be done only by qualied personnel and conform to all local codes. l Install this camera on a rm and solid part of the ceiling or wall. If installed improperly or on a weak surface, the camera could fall causing injury and damage. 1 5 A B 2 3 C AU T I O N ...
-
Toshiba Toshiba Network Camera - page 17
17 POWE R COLLIS ION LIN K RE CEIV E P AR TITIO N 1 2 3 4 5 POWE R COLLIS ION LIN K RE CEIV E P AR TITIO N 1 2 3 4 5 POW ER COL L ISION LIN K RE CEIV E PAR TITIO N 1 2 3 4 5 POW ER COL L ISION LIN K RE CEIV E PAR TITIO N 1 2 3 4 5 17 Network Deployment l When using a PoE-enabled switch The camera is PoE-compliant, allowing transmission of power and ...
-
Toshiba Toshiba Network Camera - page 18
18 POW ER COL LIS ION LINK RE CEIV E PAR TITIO N 1 2 3 4 5 AC24V or DC12V adapter UL Listed Class 2 power supply (not supplied) 18 18 1 2 Ethernet switch (not supplied) General Connection (without PoE) 1. Connect the camera to an Ethernet switch via LAN cable. 2. Connect the power cable from a power unit (not supplied) to the appropriate port of th ...
-
Toshiba Toshiba Network Camera - page 19
19 19 19 Installation Wizard 1. Install the "Installation Wizard" under the Software Utility directory from the CD- ROM. 2. The program will analyze your network environment. After your network is analyzed, please click on the "Next" button to continue the program. 3. The program searches for other Network Cameras on the same ne ...
-
Toshiba Toshiba Network Camera - page 20
20 20 For more information on camera conguration, please refer to use r's manual on the CD-ROM. 1. Access the Network Camera from the network. 2. Retrieve live video through Internet Explorer ® . Retrieving Images ...
-
Toshiba Toshiba Network Camera - page 21
21 21 Adjusting the Lens Based on the live image retrieved from the camera, adjust the camera lens by performing the following: T o adjust the viewing angle 1. T urn the lens module left and right. 2. Loosen the tilt adjustment screws on both side of the camera and then turn the lens module up and down. Upon completion, tighten the screws. 3. T urn ...
-
Toshiba Toshiba Network Camera - page 22
22 22 Dome cover 1. Attach the dome cover to the camera and aligning with the mounting holes. 2. Y ou will nd a silica gel bag attached to the dome cover . Remove the supplied sili ca gel from the aluminum foil bag, and replace it t o new silica gel with supplied double-sided tape. (Please replace the silica gel with a new one if you open the do ...
-
Toshiba Toshiba Network Camera - page 23
23 23 Access the Network Camera from the browser interface, and click the conguration button onthe main page. Then click the following: Audio and Video Image Zoom and Focus T o adjust the z oom factor and focus range 1. Use the Zoom slide bar to nd an optimal view of the area of interest where you want to adjust its focus. Click and drag the ...
-
Toshiba Toshiba Network Camera - page 24
TOSHIBA AMERICA INFORMA TION SYSTEMS, INC. Surveillance & IP V ideo Products 9740 Irvine Boulevard, Irvine, CA 92618-1697 Phone Number: (877) 855-1349 625016700G ...
У вас вопрос, касающийся Toshiba Toshiba Network Camera?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Toshiba Toshiba Network Camera, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Toshiba Toshiba Network Camera со всей вероятностью он захочет поделиться методом ее решения.