Инструкция обслуживания Boca Research None

14 страниц 0.42 mb
Скачать

Перейти на страницу of 14

Summary
  • Boca Research None - page 1

    Muon Liquid Handling System User Guide C. Johnson, S.P. Cottrell et al Version 0.2 - 1 - ...

  • Boca Research None - page 2

    Contents 1 Getting Started 3 1.1 Layout of the liquid handling system 3 1.2 Layout of the in situ sample stick 4 1.3 Layout of the pump 4 2 General procedures 6 2.1 Sample loading 6 2.1.1 Loading Vessel 1 6 2.1.2 Loading Vessel 2 6 2.2 Evacuation of the system 6 2.2.1 Removing air from Vessel 1 7 2.2.2 Removing air from Vessel 2 7 2.2.3 Removing ai ...

  • Boca Research None - page 3

    1 Getting S t arted This manual describes the liquid handling system and the in situ sample cell as use d on the DEVA instrument with the “RF” spect rometer, for either norm al muon spins relaxation or RF resonance experiments. 1.1 Layout of the liquid handling sy stem The Muon Liquid Handling System has been designed to facilitate the in situ ...

  • Boca Research None - page 4

    1.2 Layout of the in situ sample stick The liquid sample stick is designed to fit into the DEVA f low cryostat, details of which can be found in the DEVA manual. It consists of a shapol target cell 30 mm x 30 mm with a mylar window upon which may be mounted an RF coil. Two stainless steel capillaries provide a mean s of flowing liquid into and out ...

  • Boca Research None - page 5

    Roughing/ Turbo switch Off/Run switch Pressure reading Turbo control panel Turbo Pump Rotary Pump Figure 2 The lay out of the fr ont panel o n the vacuum pump use d with the muon liqui d handlin g system. - 5 - ...

  • Boca Research None - page 6

    2 General procedures 2.1 Sample loading At this point, the system will be open to the atm osphere, ensure that valve V2 is closed to prevent air cond ensation in the cold trap. 2.1.1 Loading Vessel 1 • Open the tap on the right-hand side of Vessel 1. • Open tap A and valve V11. • The liquid should be poured into the system very slowly to avoi ...

  • Boca Research None - page 7

    2.2.1 Removing air from Vessel 1 Once the system has been pressuris ed, tap A on Vessel 1 can be opened. It is possible to bubbled helium gas through the sample liqui d against the non-retu rn valve, V13. If this is required, first ensure th at valves V 5, V7 and V8 are closed. Open valves V10 and V6, finally opening tap B slowly in order to regula ...

  • Boca Research None - page 8

    2.3 Freeze-Pump-Thaw cycle Using this system it is possible to o perat e freeze-pump-thaw cycles on sam ple liquids held in any of the three vessels. Procedur es appropriate to ea ch vessel are outlined below. 2.3.1 Sample in Vessel 1 • All taps and valves should be closed. • Open valve V2 and tap A on Vessel 1, and freeze the sample liquid by ...

  • Boca Research None - page 9

    2.3.3 Sample in Vessel 3 • All taps and valves should be closed. • Open valves V2 and V3 along with tap C on Vessel 3 and freeze the sample liquid by slowly raising a dewa r of liquid nitrogen around it. • When it has been determined that the liquid ha s completely frozen switch the pump to roughing mode and open valve V1. • Switch the pump ...

  • Boca Research None - page 10

    2.4.2 Vessel 3 to sample cell The transfer of liquid from Vessel 3 to the sample cell is brought about by the difference in pressure between that in the Vessel and a vacuum in the cell. However, in order to control the transfer of liquid th e pressure difference shou ld be as small as possible but not so low that the liquid starts to boil. • Swit ...

  • Boca Research None - page 11

    2.4.4 Recovery of liquid in sample cell to Vessel 1 The liquid in the sample cell cannot be recovered to Vessel 1 using the liquid handling rig as presently configured. 2.4.5 Recovery of liquid in sample cell to Vessel 2 The liquid in the sample cell can be r ecovered to Vessel 2 using the following procedure. • Vessel 2 should be under vacuum al ...

  • Boca Research None - page 12

    • All the liquid may not return in a single pass and repea ting the evacuation procedure may be required. However, some liquid m ay be present in the system and care should be taken during evacuation that th e trap does not become blocked. The liquid may also be encouraged to leave the sample cell by using a small amount of gas. • Close valve V ...

  • Boca Research None - page 13

    3 Example Experiment The paramagnetic signal in liquid n-hexane is difficult to observe because the muonium polarisation is found to decay on a microsecond time scale, which is further reduced by the presence of dissolved oxygen. A series of commi ssioning experim ents were carried out using n-hexane in order to gauge the ability of the liquid hand ...

  • Boca Research None - page 14

    0.0 0.5 1.0 1.5 2.0 2.5 3.0 11.0 11.5 12.0 12.5 13.0 13.5 Initial asymmetry (%) Time ( µ s) 0.0 0.5 1.0 1.5 2.0 2.5 3.0 11.0 11.5 12.0 12.5 13.0 Initial asymmetry (%) Time ( µ s) 1.5 2.0 2.5 3.0 0.0 0.5 1.0 11.0 11.5 12.0 12.5 13.0 13.5 Initial asymmetry (%) Time ( µ s) a) b) c) Figure 1 Muonium precessi on signal at 2G in n- hexane after a) 4, ...

Производитель Boca Research Категория Heat Pump

Документы, которые мы получаем от производителя устройства Boca Research None мы можем разделить на несколько групп. Это в частности:
- технические чертежи Boca Research
- инструкции обслуживания None
- паспорта изделия Boca Research
- информационные брошюры
- энергетические этикетки Boca Research None
Все из них важны, однако самую важную информацию с точки зрения пользователя мы найдем в инструкции обслуживания Boca Research None.

Группа документов, определяемая как инструкции обслуживания, делится также на более подробные типы, такие как: Инструкции монтажа Boca Research None, инструкции обслуживания, короткие инструкции или инструкции пользователя Boca Research None. В зависимости от потребностей, Вам необходимо поискать требуемый документ. На нашем сайте Вы можете просмотреть самую популярную инструкцию использования изделия Boca Research None.

Похожие инструкции обслуживания

Полная инструкция обслуживания устройства Boca Research None, как должна выглядеть?
Инструкция обслуживания, определяемая также как пособие пользователя, или просто "руководство" - это технический документ, цель которого заключается в использовании Boca Research None пользователями. Инструкции пишет, как правило технический писатель, языком, доступным для всех пользователей Boca Research None.

Полная инструкция обслуживания Boca Research, должна заключать несколько основных элементов. Часть из них менее важная, как например: обложка / титульный лист или авторские страницы. Однако остальная часть, должна дать нам важную с точки зрения пользователя информацию.

1. Вступление и рекомендации, как пользоваться инструкцией Boca Research None - В начале каждой инструкции, необходимо найти указания, как пользоваться данным пособием. Здесь должна находится информация, касающаяся местонахождения содержания Boca Research None, FAQ и самых распространенных проблем - то есть мест, которые чаще всего ищут пользователи в каждой инструкции обслуживания
2. Содержание - индекс всех советов, касающихся Boca Research None, которое найдем в данном документе
3. Советы по использованию основных функций устройства Boca Research None - которые должны облегчить нам первые шаги во время использования Boca Research None
4. Troubleshooting - систематизированный ряд действия, который поможет нам диагностировать а в дальнейшем очередность решения важнейших проблем Boca Research None
5. FAQ - чаще всего задаваемые вопросы
6. Контактные данные Информация о том, где искать контактные данные производителя / сервисного центра Boca Research None в данной стране, если самостоятельно не получится решить проблему.

У вас вопрос, касающийся Boca Research None?

Воспользуйтесь формуляром, находящимся ниже

Если с помощью найденной инструкции Вы не решили свою проблему с Boca Research None, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Boca Research None со всей вероятностью он захочет поделиться методом ее решения.

Перепишите текст с картинки

Комментарии (0)