-
Orion HCCA 10.2 - page 1
subw oofer 10.2 10.4 12.2 12.4 15.2 15.4 HCCA 10.2 10.4 12.2 12.4 15.2 15.4 HCCA ...
-
Orion HCCA 10.2 - page 2
T ABLE OF CONTENTS Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Practice Safe Sound™ . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 Installation . . . . . . . . . . . . . . ...
-
Orion HCCA 10.2 - page 3
INTRODUCTION Thank you for your purchase of the Orion HCCA SubW oofers. These woofers represent a combination of incredible performance and value. The HCCA series subwoofers feature a massive 4" voice coil and triple stacked magnet assembly to maximize excursion and output. Capable of maintaining their balance at exceptionally high output leve ...
-
Orion HCCA 10.2 - page 4
TOOLS OF THE TRADE Listed are the majority of the tools required to perform the installation. Having the proper tools will make the installation much easier . It is very difficult when you get half way through the installation and discover that you require a specific tool to get yourself through a particular part of the installation. Some of these ...
-
Orion HCCA 10.2 - page 5
5 1. Paper dust cap - moisture and UV resistant. 12. V oice coil gap vents. Part of the enhanced voice coil cooling system (forced convection - aluminum heat sinking -shorting rings to reduce inductive heating). 2. T all, wide, balanced, NBR Foam (high density expanded polyester foam) surround for linear controlled long excursion using a T ri Radiu ...
-
Orion HCCA 10.2 - page 6
6 RE-CONE KIT A re-cone kit is available for these speakers and can be obtained from your dealer . The part number for each model is listed below . WIRING CONFIGURA TIONS The following illustrations provide guidelines on properly connecting your HCCA Orion woofer to an Orion amplifier for maximum power and performance using common parallel, and ser ...
-
Orion HCCA 10.2 - page 7
7 Parallel—One Speaker (dual 2 ohm voice coils) One dual 2 ohm voice coil woofer with voice coils in parallel results in a 1 ohm load to the amplifier . 1. Connect the speaker in parallel by connecting the two positive (+) terminals together and the two negative (-) terminals together . 2. Wire the positive (+) terminals of the woofer to the posi ...
-
Orion HCCA 10.2 - page 8
8 Parallel—T wo Speakers (dual 4 ohm voice coils) T wo dual 4 ohm voice coil woofers with voice coils in parallel and the two woofers in parallel results in a 1 ohm load to the amplifier . 1. Connect the speaker in parallel by connecting the four positive (+) terminals together and the four negative (-) terminals together . 2. Wire the positive ( ...
-
Orion HCCA 10.2 - page 9
9 Parallel—One Speaker (dual 4 ohm voice coils) One dual 4 ohm voice coil woofer with voice coils in parallel results in a 2 ohm load to the amplifier . 1. Connect the speaker in parallel by connecting the two positive (+) terminals together and the two negative (-) terminals together . 2. Wire both positive (+) terminals of the woofer to the pos ...
-
Orion HCCA 10.2 - page 10
10 Series-Parallel—T wo Speakers (dual 2 ohm voice coils) Note: V erify and ensur e that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. T wo dual 2 ohm voice coil woofers with voice coils in series and then parallel the two series woof ...
-
Orion HCCA 10.2 - page 11
11 Series-Parallel—Three Speakers (dual 4 ohm voice coils) Note: V erify and ensur e that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Three dual 4 ohm voice coil woofer with voice coils of each woofer wired in series and then parall ...
-
Orion HCCA 10.2 - page 12
12 Series—One Speaker (dual 2 ohm voice coils) One dual 2 ohm voice coil woofer with voice coils in connected in series results in a 4 ohm load to the amplifier . 1. Connect the woofer in series by connecting the negative (-) of one terminal to the positive (+) terminal of the other coil. 2. Wire the positive (+) terminal of the first coil to the ...
-
Orion HCCA 10.2 - page 13
13 Series-Parallel—Four Speakers (dual 4 ohm voice coils) Note: V erify and ensur e that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Four dual 4 ohm voice coil woofers should be wired with the voice coils on each woofer in series an ...
-
Orion HCCA 10.2 - page 14
14 Series-Parallel—Four Speakers (dual 2 ohm voice coils) Note: V erify and ensur e that the woofer wiring is connected as shown with the negative connection from the first woofer coil connected to the positive connection of the second woofer coil. Four dual 2 ohm voice coil woofers should be wired with the voice coils on each woofer in series an ...
-
Orion HCCA 10.2 - page 15
15 2 Amplifiers—One Speaker (dual 2 ohm voice coils) One dual 2 ohm voice coil woofer with each voice coil connected to an individual amplifier , resulting in a 2 ohm load to each amplifier . 1. Connect one of the speaker’ s voice coils to the first amplifier by connecting the positive (+) terminal and the negative (-) terminal from the speaker ...
-
Orion HCCA 10.2 - page 16
2 Amplifiers—One Speaker (dual 4 ohm voice coils) One dual 4 ohm voice coil woofer with each voice coil connected to an individual amplifier , resulting in a 4 ohm load to each amplifier . 1. Connect one of the speaker’ s voice coils to the first amplifier by connecting the positive (+) terminal and the negative (-) terminal from the speaker to ...
-
Orion HCCA 10.2 - page 17
ENCLOSURE DESIGN This section gives the basic description for a sealed enclosure. Orion HCCA woofers are designed for sealed enclosures and vented enclosures. Sealed enclosures are generally considered the most versatile for all music types and are the easiest to build. They will also give high power handling with a wider range of frequencies. The ...
-
Orion HCCA 10.2 - page 18
HCCA 10.2 & 10.4 Sealed Enclosure Recommendations c b —Bo x P ar ts— Bo x Shape – Square Pr ism 1 T op , 1 Bottom depth (c) = 14.5 in. width (b) = 13.5 in. thic kness = 1.0 in. 1 F ront, 1 Bac k height (a) = 11 in. width (d) = 11.5 in. thic kness = 1.0 in. 2 Sides height (a) = 11 in. depth (c) = 14.5 in. thic kness = 1.0 in. —Driver Mou ...
-
Orion HCCA 10.2 - page 19
HCCA 10.2 & 10.4 V ented Enclosure Recommendations —Bo x P ar ts— Bo x Shape – Square Pr ism 1 T op , 1 Bottom depth (c) = 15.5 in. width (b) = 14.5 in. thic kness = 1.0 in. 1 F ront, 1 Bac k height (a) = 11.5 in. width (d) = 12.5 in. thic kness = 1.0 in. 2 Sides height (a) = 11.5 in. depth (c) = 15.5 in. thic kness = 1.0 in. —Driver Mo ...
-
Orion HCCA 10.2 - page 20
HCCA 12.2 & 12.4 Sealed Enclosure Recommendations c b —Bo x P ar ts— Bo x Shape – Square Pr ism 1 T op , 1 Bottom depth (c) = 16 in. width (b) = 16 in. thic kness = 1.0 in. 1 F ront, 1 Bac k height (a) = 14.5 in. width (d) = 14 in. thic kness = 14 in. 2 Sides height (a) = 14.5 in. depth (c) = 16 in. thic kness = 1.0 in. —Driver Mounting ...
-
Orion HCCA 10.2 - page 21
HCCA 12.2 & 12.4 V ented Enclosure Recommendations —Bo x P ar ts— Bo x Shape – Square Pr ism 1 T op , 1 Bottom depth (c) = 20 in. width (b) = 15.5 in. thic kness = 1.0 in. 1 F ront, 1 Bac k height (a) = 14 in. width (d) = 13.5 in. thic kness = 1.0 in. 2 Sides height (a) = 14 in. depth (c) = 20 in. thic kness = 1.0 in. —Driver Mounting? ...
-
Orion HCCA 10.2 - page 22
22 HCCA 15.2 & 15.4 Sealed Enclosure Recommendations c b —Bo x P ar ts— Bo x Shape – Square Pr ism 1 T op , 1 Bottom depth (c) = 20 in. width (b) = 18 in. thic kness = 1.0 in. 1 F ront, 1 Bac k height (a) = 15.5 in width (d) = 19 in. thic kness = 1.0 in. 2 Sides height (a) = 15.5 in depth (c) = 20 in. thic kness = 1.0 in. —Driver Mounti ...
-
Orion HCCA 10.2 - page 23
23 HCCA 15.2 & 15.4 V ented Enclosure Recommendations —Bo x P ar ts— Bo x Shape – Square Pr ism 1 T op , 1 Bottom depth (c) = 18 in. width (b) = 21 in. thic kness = 1.0 in. 1 F ront, 1 Bac k height (a) = 15.5 in. width (d) = 19 in. thic kness = 1.0 in. 2 Sides height (a) = 15.5 in. depth (c) = 18 in. thic kness = 1.0 in. —Driver Mountin ...
-
Orion HCCA 10.2 - page 24
SPECIFICA TIONS Directed Part Number 27302 27304 27307 Model Number 10.2 10.4 12.2 Thiele/Small Parameters Fs (free-air resonance, Hz) 30.78 32.49 22.56 V as (equivalent compliance, cu. ft. 0.564 0.564 1.847 V as (equivalent compliance, liters) 15.98 15.98 52.33 Qms (Q, mechanical) 3.63 3.63 2.99 Qes (Q, electrical) 0.42 0.46 0.36 Qts (total driver ...
-
Orion HCCA 10.2 - page 25
SPECIFICA TIONS (CONT’D) Directed Part Number 27309 27312 27314 Model Number 12.4 15.2 15.4 Thiele/Small Parameters Fs (free-air resonance, Hz) 23.98 23.72 24.73 V as (equivalent compliance, cu. ft. 1.847 4.01 7.23 V as (equivalent compliance, liters) 52.33 113.68 113.68 Qms (Q, mechanical) 2.99 2.99 2.99 Qes (Q, electrical) 0.42 0.46 0.52 Qts (t ...
-
Orion HCCA 10.2 - page 26
NO WARRANTY THIS PRODUCT IS SOLD "AS-IS " DIRECTED ELECTRONICS (hereinafter " SELLER ") MAKES NO WARRANTY of any kind (express, implied or otherwise) in connection with this Product. THIS PRODUCT IS SOLD AS-IS, AND YOU THE PURCHASER ASSUME THE ENTIRE RISK AS TO ITS QUALITY AND PERFORMANCE. ANY IMPLIED WARRANTY OF MERCHANT ABILIT ...
У вас вопрос, касающийся Orion HCCA 10.2?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Orion HCCA 10.2, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Orion HCCA 10.2 со всей вероятностью он захочет поделиться методом ее решения.