-
Cannon CANTFS-03-NG - page 1
C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS CANTFS-03-NG CANTFS-03-LP Part No: F2902 Revision (C) - 2008 Cannon CANTERBUR Y ...
-
Cannon CANTFS-03-NG - page 2
2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteristics ❍ Cleaning Heater specifications 9 Installation instructions 10-15 ❍ Clearances ❍ Installation ❍ Gas connection ❍ Log installation ❍ ...
-
Cannon CANTFS-03-NG - page 3
3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor . (Details below or ...
-
Cannon CANTFS-03-NG - page 4
4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone. W arnings 1. Improper installation, adj ...
-
Cannon CANTFS-03-NG - page 5
5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment. 9. If removed, the glass window must be put back onto the unit prior to operating the ...
-
Cannon CANTFS-03-NG - page 6
6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position. There is a 5 second delay before the burner ignites. At this setting the burner is on ...
-
Cannon CANTFS-03-NG - page 7
7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7. On low burner setting it is more efficient to operate the fan speed on LOW . 8. If the burner ...
-
Cannon CANTFS-03-NG - page 8
8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs. If there is any excess carbon build-up on the lo ...
-
Cannon CANTFS-03-NG - page 9
9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.65 kPa. Gas regulator: Integral part of controller . Min. inlet pressur ...
-
Cannon CANTFS-03-NG - page 10
10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, and AS5601 the Australian Stand- ard for gas i ...
-
Cannon CANTFS-03-NG - page 11
11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Ri ...
-
Cannon CANTFS-03-NG - page 12
12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front. Refer figure 15. ...
-
Cannon CANTFS-03-NG - page 13
12 Position the four individually numbered logs in the following order on the burner head as shown in figures 15 - 18. The male locating pins in the burner head must engage with corresponding holes in the indi- vidual logs. a) Place log No.1 onto the 2 front left pins on the burner head, ensuring that the charring faces the front. Refer figure 15. ...
-
Cannon CANTFS-03-NG - page 14
11 Gas connection 10. Connect incoming gas supply pipe to 1 / 2 ” compression fitting at rear of appliance. For inlet position see figure 13. Log installation 11. The burner is contained within the burner chamber . Refer figure 14. 12. Carefully unpack the log set. Logs are numbered as follows: No 1 - Left front log No 2 - left back log No 3 - Ri ...
-
Cannon CANTFS-03-NG - page 15
10 Overall dimensions: Refer fig. 8. 1. This appliance is to be installed by a licensed ser vice person only . 2. This appliance shall be installed in accordance with the manufacturer’ s installation instructions, local gas fitting regulations, municipal building codes, electrical wiring regulations, and AS5601 the Australian Stand- ard for gas i ...
-
Cannon CANTFS-03-NG - page 16
9 Gas type: Natural or Propane gas, as indicated on data label. Gas consumption: 26 M J/hr input. Energy output: 21.45 MJ/hr (5.96 kW). Energy star rating: 4 stars. Heater type: Approved to AS4553/AG 103. Operating pressure: Natural gas: 0.75 kPa. (at the burner) Propane gas: 2.65 kPa. Gas regulator: Integral part of controller . Min. inlet pressur ...
-
Cannon CANTFS-03-NG - page 17
8 Flame characteristics The heater flame should be stable, no lifting from the burner and the logs should glow after approximately 15 minutes operation on HIGH setting. The heater is a fuel effect unit and is designed to operate with luminous flames and may exhibit slight carbon deposits on the logs. If there is any excess carbon build-up on the lo ...
-
Cannon CANTFS-03-NG - page 18
7 5. T o increase the fan speed to MED, press switch for MED setting. Refer figure 5. 6. T o increase the fan speed to HIGH, press switch for HIGH setting. Refer figure 6. 7. T o turn the burner to LOW setting, press switch for LOW setting. Refer figure 7. On low burner setting it is more efficient to operate the fan speed on LOW . 8. If the burner ...
-
Cannon CANTFS-03-NG - page 19
6 Operating instructions 1. Plug the power cord into the wall socket and turn on the power to the heater , see figure 1. Use of an extension cord is not recommended. 2. For control lay-out refer to figure 2 3. T o tur n heater on press switch to POWER ON position. There is a 5 second delay before the burner ignites. At this setting the burner is on ...
-
Cannon CANTFS-03-NG - page 20
5 7. Do not spray aerosols in the vicinity of this appliance while it is in operation. Do not place articles on or against this appliance. Do not use or store flammable materials near this appliance. 8. This heater is not intended for use in a marine environment. 9. If removed, the glass window must be put back onto the unit prior to operating the ...
-
Cannon CANTFS-03-NG - page 21
4 Please read this manual before installing and using the heater . What to do if you smell gas 1. T urn OFF the main gas supply . 2. Extinguish any open flame. 3. Open windows. 4. Do not touch electrical switches. 5. Do not use your telephone. 6. Call your gas supplier immediately from a neighbour’ s phone. W arnings 1. Improper installation, adj ...
-
Cannon CANTFS-03-NG - page 22
3 The Cannon appliance is warranted against defects in materials and work- manship for a period of one, (1) year from its date of original purchase, for residential use in Australia. W arranty ser vice, which includes par ts and labour for the replacement or repair of defective parts, is available through the CANNON distributor . (Details below or ...
-
Cannon CANTFS-03-NG - page 23
2 Contents Contents 2 W arranty 3 ❍ Distributor Safety warnings 4-5 ❍ What to do if you smell gas ❍ W ar nings ❍ Standards User instructions 6-8 ❍ Operating instructions ❍ Flame characteristics ❍ Cleaning Heater specifications 9 Installation instructions 10-15 ❍ Clearances ❍ Installation ❍ Gas connection ❍ Log installation ❍ ...
-
Cannon CANTFS-03-NG - page 24
C annon This heater is approved for use with Natural and Propane gases. Please leave instructions with the owner USER INSTRUCTIONS INST ALLA TION INSTRUCTIONS SERVICE INSTRUCTIONS FREEST ANDING MODELS CANTFS-03-NG CANTFS-03-LP Part No: F2902 Revision (C) - 2008 Cannon CANTERBUR Y ...
У вас вопрос, касающийся Cannon CANTFS-03-NG?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Cannon CANTFS-03-NG, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Cannon CANTFS-03-NG со всей вероятностью он захочет поделиться методом ее решения.