-
Hotpoint EG53 - page 1
U se and Installation Instructions The cooker must be installed in accordance with the r egulations in forc e and only used in a well ventila ted space. Read these instructions prior to using the cooker and retain them f or future refer ence . Instructions for Installation and Use EG72 EG53 ...
-
Hotpoint EG53 - page 2
PA G E Introduction 3 For Y our Safety 4 Timer Operation (EG72) 6 Timer Operation (EG53) 12 Hotplate 14 Grill 16 Ovens 17 Oven Cooking Char t 18 The Slow Cooking “S” Setting 20 Care and Cleaning 21 Something Wr ong with your cooker? 24 Installation Instructions 26 K e y C on ta cts Back Cov er 2 C ONTENTS ...
-
Hotpoint EG53 - page 3
T o help you make the best use of your c ooker , PLEASE READ THIS BOOKLET CAREFULL Y . Y our new cooker is guaran teed and will give lasting service. The guarantee is only applicable if the cooker has been installed in accordance with the Installation Instructions. The cooker is designed specifically for domestic use and responsibility will not be ...
-
Hotpoint EG53 - page 4
Please read the precautions below befor e using your cook er . AL W A Y S . . . AL W A YS make sure you understand the controls bef ore using the co oker . AL W A YS check that all controls on the c ooker are turned off after use. AL W A YS stand back when opening an oven door t o allow heat to dis perse . AL W A Y S use dry , good qualit y ov en g ...
-
Hotpoint EG53 - page 5
NEVER . . . NEVER leave childr en unsuper vised where the cooker is installed as all sur faces will get hot during and after use. NEVER allow any one to sit or stand on any par t of the cooker . NEVER store items that childr en may attempt t o reach abov e the c ooker . NEVER heat up unopened food con tainers as pressure can build up causing the co ...
-
Hotpoint EG53 - page 6
6 The timer offers y ou the following f eatures: 1. Time of Day 2. Automatic C ook ing 3. Minute Minder A UTOMA TIC C OOKING The main ov en can be controlled automa tically . GUIDANCE ON A UTOMA TIC C OOKING 1. Select foods which will take the same time to cook. 2. Set the oven timer so that the f ood has just finished or is j ust about to finish c ...
-
Hotpoint EG53 - page 7
7 CL OCKF A CE The timer incorporates a 24 hour clock. Ensure the correct time of day is alw ay s set, before using your cooker. SYMBOLS A ‘bell’ symbol will light up when you select a Minute Minder Period and will remain lit for the period set. At the end of the Minute Minder Period , the timer will emit an audible tone and the ‘bell’ symb ...
-
Hotpoint EG53 - page 8
8 SETTING THE TIME OF DA Y Step 1 Make sure all oven controls ar e turned Off. Step 2 Check the electricity supply to the cooker is turned on. Step 3 When switched on the display will show 0.00 and the A uto symbol , flashing intermittently . Step 4 Press & hold in both the C ook Period & End Time buttons togethe r. Step 5 With the Cook P e ...
-
Hotpoint EG53 - page 9
9 Step 3 Press and hold in the C ook Period button. The display will read 0.00 with the ‘ cook pot’ symbol lit. Step 4 With the Cook P er iod button still held in, set the required Cook Per io d using the “+” and “–” buttons. Release the buttons and the timer display will rev ert to the time of day with the ‘ Auto ’ symbol and ‘ ...
-
Hotpoint EG53 - page 10
10 Step 4 Press & hold in the C ook Period button, the display will read 0.00 and the ‘ cookpot ’ symbol will light up. With the Cook P er iod button still held in set the requir ed Cook P eriod using the “+” and “–” buttons. Example: 1hr 30 minutes (as shown). Note: Cook P erio d is the length of time the food requir es to cook. ...
-
Hotpoint EG53 - page 11
11 O THER NO TES ON TIMER OPER A TION 1. When cooking Automatically the Cook P eriod can be checked at an y time simply by pressing the Cook Period button. 2. When cooking Automatically the End Time can be checked at any t ime by simply pressing the End Time button. 3. Having set a Cook P eriod and End Time an electronic device stor es the inf or m ...
-
Hotpoint EG53 - page 12
CL OCKF A CE The timer incorporates a 24 hour clock. SYMBOLS A ‘Bell’ symbol will light up when you select a Minute Minder Pe riod and will remain lit for the period set. At the end of the Minute Minder Period , the timer will emit an audible tone and the ‘B ell’ symbol will disappear . SET TING THE TIME OF DA Y Step 1 Make sure all oven co ...
-
Hotpoint EG53 - page 13
Here you can set a time period of up to 10 hours , that will coun t down. When it reaches zero , the timer will emit an audible tone. For Example: If you set 20 minutes, the audible tone will occur 20 minutes later . SET TING THE MINUTE MINDER Step 1 Ensure the time of day is set correctly . Step 2 Press and r elease the ‘+’ button. Note: Step ...
-
Hotpoint EG53 - page 14
The hotplate lid is fitted with a saf et y device which cuts off the gas supply t o the hotplate burners unless the lid is fully open. Do not use the sa fety device as a means of controlling the hotplat e burners. The hotplate has two high speed burners and two simmering burners which will accommodate pans between 100mm (4”) and 230mm (9”) diam ...
-
Hotpoint EG53 - page 15
15 SAFET Y REQUIREMENTS FOR DEEP F A T FR YING 1. Never fill chip pans more than one third full with oil or fa t . 2. Never leav e oil or fat unattended during the heating or cooli ng period. 3. Never heat fat or fry with a lid on the pan. 4. Always dry food thoroughly bef ore frying, and lower it slowly into the hot oil or fat. Froz en foods in pa ...
-
Hotpoint EG53 - page 16
16 T O USE THE GRILL 1. Open the grill/top oven door and plac e the shelf in the requi red position. 2. T urn the grill control knob clock wise to 4 for full width grilling or anticlockwise for the half grill. 3. Slide the grill pan toward the back of the grill compartment until it stops. 4. Lea ve the contr ol at 4 for toast and f or sealing and f ...
-
Hotpoint EG53 - page 17
17 O VENS Both ovens ha ve a thermostat light that will illuminat e until the oven has reached the set temperature . I t will then switch off and on during cooking as the thermostat maintains the temperature . Each shelf has a safety stop to prev ent it from being pulled ou t too far when attending to food . Shelves are removed b y pulling them out ...
-
Hotpoint EG53 - page 18
O VEN C OOKING CHART Beef/ Lamb (slow roasting) Meat 170/180 35 mins per 450g (1lb) + 35 mins over . Runner 1 from bottom of oven. 35-40 mins per 450g (1lb) 40 mins per 450g (1lb) + 40 mins over 40 mins per 450g (1lb) 40-45 mins per 450g (1lb) + 40 mins over 40-45 mins per 450g (1lb) 25-30 mins per 450g (1lb) + 25 mins over 25-30 mins per 450g (1lb ...
-
Hotpoint EG53 - page 19
Note: If soft margarine is used for cake mak ing , temperatures recommended b y the manufacturers should be followed . T emperatures recommended in th is chart refer to cakes made with block margarine only . O VEN C OOKING CHART 19 Scones Food Pre- heat Ye s 210/220 10-15 Runner 1 from bottom of oven. Runner 1 from bottom of oven. Runner 1 Runner 1 ...
-
Hotpoint EG53 - page 20
The ‘S’ setting on the main oven thermostat can be used f or slow cookin g. PREP ARING FOOD FOR SLO W COOKING 1. All dishes cooked by the ‘S’ setting should be cooked for a minimum 6 hours. They will ‘hold ’ at this setting for a further hour but mar ked deterioration in appearanc e will be noticed in some cases. 2. Joints of meat and p ...
-
Hotpoint EG53 - page 21
Switch off the electricity supply and allow to c ool before cleaning the cook er . Clean the cooker r egularly and wipe up spills so on after they occur to pr ev ent them from becoming burnt on. Never use biological washing po wde r , caustic cleaners, harsh abrasives , scouring pads, steam cleaners, aerosol c leaners or ov en chemical cleaners of ...
-
Hotpoint EG53 - page 22
22 CARE AND CLEANING C OOKER FINISH CLEANING METHOD Vitreous Enamel Hotplate , pan supports, hotplate front trim, burner caps, roasting dish, grill pan, main oven base , inside of grill compartment, inside of doors. Cloth wrung out in warm soapy water . Stubborn stains can be remov ed with a cream paste , liquid cleaner or by rubbing with fine stee ...
-
Hotpoint EG53 - page 23
23 CARE AND CLEANING Take particular care not to damage the inner sur face of the door inner glass tha t is coated with a hea t reflec tiv e lay er . Do not use scouring pads , or abrasive powder , which will scratch the glass. Ensure that the glass panel is not subjected to any sharp mechanical blo ws. Stubborn stains can be remov ed by using a fi ...
-
Hotpoint EG53 - page 24
PROBLEM CHECK Ignition does not work. 24 SOMETHING WRONG WITH Y OUR C OOKER Before contacting your Service C entre or Installer , check the problem guide below , there may be nothing wrong with your c ooker . Burner por ts Ignitor Hotplate burner . I f all burners fail to ignit e: Check that sparks appear at the burners; a clicking noise should be ...
-
Hotpoint EG53 - page 25
DISPOSAL OF Y OUR PRODUCT : T o minimise the risk to injur y to children please dispose of your product carefully and saf ely . Remove all doors and lids (where fitt ed). Remove the mains cable (where fitted) by cutting off flush with the appliance and always ensur e that no plug is left in a condition where it could be connected to the electricity ...
-
Hotpoint EG53 - page 26
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas pressure) and the adjustment conditions ar e compatible. The adjustment conditions for this appliance ar e stated on the rating label which is fitted on the back panel. This appliance is not designed to be connected to a c ombustion products evacuation d ...
-
Hotpoint EG53 - page 27
TECHNICAL DA T A DIMENSIONS Height 900 - 915mm Width 600mm Depth 595mm (excluding door handles) GENERAL Gas connection Rp 1 / 2 ( 1 / 2 ” BSP female) Pressur e test point Hotplate burner injector . Gas rate adjustment None Aeration adjustmen t None Electrical connection 4mm 2 t win and earth. 230-240V a.c. 50Hz. 27 INST ALLA TION INSTR UCTIONS HO ...
-
Hotpoint EG53 - page 28
SP ACE FOR FIXING The cooker can be close fitted below hotplat e level. This requires a minimum distance of 600mm between cupboard units of hotplat e height. When installing next to a tall cupboard , par tition or wall, for a minimum distance of 400mm abov e hotplate level, allow a side clearance of at least 65mm. The diagram below illustr ates the ...
-
Hotpoint EG53 - page 29
LEVELLING T wo rear wheels and two front feet are fitt ed which can be adju sted up or do wn to set the height (915mm) and level the cooker . 1. The rear wheels can be raised or low ered from the BACK of the cooker by adjusting the levelling screws ‘ A ’ in the plinth. 2. The front f eet can be simply screwed in or out to low er or raise the fr ...
-
Hotpoint EG53 - page 30
OPERA TIONAL CHECKS 30 W ARNING - THIS APPLIANCE MUST BE EARTHED The cooker must be connected by a qualified electrician to a suitable double - pole control unit with a minimum rating of 32A and a minimum contact clearance of 3mm, which should be fitted adjacent to (but not abo ve) the cooker , in accordance with IEE regulations . The power supply ...
-
Hotpoint EG53 - page 31
...
-
Hotpoint EG53 - page 32
PRINTED BY SIMLEX . FOUR ASHES, WOL VERHAMPTON. November 2003 P ar t No. 19504160600 K ey Contacts Ser vice Hotpoint has the largest appliance manufacturer’ s ser vice t eam i n Europe , trained specialists directly employed by us t o ensure your comp lete confidence. Repair Ser vic e UK: 08709 066 066 Republic of Ireland: 1850 302 200 Y ou will ...
У вас вопрос, касающийся Hotpoint EG53?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Hotpoint EG53, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Hotpoint EG53 со всей вероятностью он захочет поделиться методом ее решения.