-
Snapper ELBX10151BV - page 1
ASSEMBLY INSTRUCTIONS OPERATOR’S MANUAL PARTS LIST European Extreme Serie s Walk-Behind Leaf Blower Series 1 Models covered: ELBX10151BV (Part # 7085912) Actual product may differ slightl y from product pictured above Manual No. 7078092 (I.R. - 09/14/ 04) ...
-
Snapper ELBX10151BV - page 2
1 preliminaries Congratulations! You have just purchased one of the finest pieces of out door power equipment on the market today. If properly cared for, your new blower will provide years of dependable service. Please read and follow this instruction manual carefully in order to get the most out of your new equipment. As you carefully unpack your ...
-
Snapper ELBX10151BV - page 3
2 safety rules regarding outdoor power equipment IMPORTANT! READ CAREFULLY THE FO LLOWING SAFETY RULES BEFORE ASSEMBLING OR OPERATING UNIT. TRAINING • Read, understand, and follow all instructions in the manual and on the unit before starting. If the operator(s) or mechanic(s) can not read English it is the owner’s responsibility to explain thi ...
-
Snapper ELBX10151BV - page 4
2 safety rules regarding outdoor power equipment (cont.) • Watch for holes, ruts, or bumps. Uneven terrain could overturn the unit. Tall grass can hide obstacles. • Keep all movement on the slopes slow and gradual. Do not make sudden changes in speed or direction. Do Not • Do not start or stop on a slope. If tires lose traction, proceed slowl ...
-
Snapper ELBX10151BV - page 5
3 unit assembly Note: Please refer to Parts List for corr ect part identification and placement. FRONT WHEEL ASSEMBLY • Place Mounting Bracket against lower right corner of Blower Housing, aligning holes in bracket with threaded studs in housing. Secure with three 3/8-16 hex nuts, split lock washers and flat washers. Tighten securely. • Install ...
-
Snapper ELBX10151BV - page 6
4 unit operation STARTING THE ENGINE IMPORTANT NOTE: The procedures outlined within this section are general guidelines, and are in no way meant to replace or supercede engine manufacturer’ s oper ating instructions. In order to obtain optimum performance from your engine, refer to your engine manual. WARNING! IMPELLER IS MOUNTED DIRECTLY TO ENGI ...
-
Snapper ELBX10151BV - page 7
4 unit operation (cont.) STARTING THE ENGINE (cont.) • Bracing unit with one hand on the upper handle and a foot on the right rear tire, firmly grasp recoil handle and pull briskly. You may have to pull several times before engine starts. (If engine fails to start within a reasonable amount of time, discontinue and check engine manual for further ...
-
Snapper ELBX10151BV - page 8
4 unit operation (cont.) GENERAL RULES TO OBSERVE BEFORE AND DURING OPERATION: • Inspect your unit before each and every use. Check for wo rn, bent or broken components, loose fasteners, low or flat tires, etc., and repair or replace prior to operation. DO NOT OPERATE A MACHINE THAT IS WORN OR DAMAGED – SERIOUS INJURY OR DEATH CAN RESULT. • C ...
-
Snapper ELBX10151BV - page 9
4 unit operation (cont.) HINTS FOR EFFECTIVE OPERATION: • For operator ease and maneuverability, push down on t he upper handle while walking so that the machine balances on the rear wheels. • When blowing dry debris, set blower discharge to lo wer rate; when blowing wet or frozen debris, increase discharge rate. 5 maintenance BEFORE MAKING ANY ...
-
Snapper ELBX10151BV - page 10
5 maintenance (cont.) BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. TROUBLESHOOTING: • UNIT WILL NOT START: • Check fuel and oil levels. • Check to make sure choke is se t when engine is cold, off when hot. • Check throttle for proper operation. • Check intake baffle for ...
-
Snapper ELBX10151BV - page 11
5 maintenance (cont.) ADJUSTMENTS: BEFORE MAKING ANY ADJUSTMENTS, STOP ENGINE AND DISCONNECT SPARK PLUG WIRE TO PREVENT INADVERTENT STARTING OF UNIT. • THROTTLE CABLE ADJUSTMENT: Correct cable adjustment allows for full range of movement of throttle body on engine in conjunction with throttle control on handle. To adjust, loosen cable clip screw ...
-
Snapper ELBX10151BV - page 12
6 illustrated parts list ELBX10151BV ...
-
Snapper ELBX10151BV - page 13
6 illustrated parts list (cont’d) Item Part No. Qty Description 1 3010267 1 WELDMENT, Housing- Extreme Blower, LBX10151BV 2 ----- --- DECAL – See DE CAL IDENTIFICATION 3 3039111 1 ENGINE, B&S 10HP Intek OHV Briggs Model 205412 Type 0121-E1 4 91540 4 SCREW, 5/16-18 x 1-1/2 Hex Head Cap, GR5 5 91601 4 NUT, 5/16-18 Hex Flange Lock, GR5 6 ----- ...
-
Snapper ELBX10151BV - page 14
6 illustrated parts list (cont’d) Item Part No. Qty Description 43 90391 4 WASHER, 5/16" Internal Tooth Lock 44 3071800 1 THROTTLE CONTROL, Briggs 45 3031220 1 BUSHING, Flanged .375 x .500 x .25 (.625 x .063 Flange) 46 90505 1 SCREW, 1/4-20 x 2" Hex Head Cap, GR5 47 90188 12 WASHER, .34 x .69 x .08 Flat 48 76978 1 NUT,1/4-20 Hex Nyloc 4 ...
-
Snapper ELBX10151BV - page 15
7 decal identification 75893 – EAR/NOSE/BREATHING PROTECTION REQUIRED – LOCATED ON SIDE OF BLOWER HOUSING 29776 – EUROPEAN CERTIFICATION – LOCATED ON REAR OF BLOWER HOUSING 75892 – DANGER – FLYING MATERIAL – LOCATED ON SIDE OF BLOWER HOUSING 22841 – DANGER – KEEP HANDS AND FEET AWAY – LOCATED ABOVE BLOWER DISCHARGE 29490 – MOD ...
-
Snapper ELBX10151BV - page 16
7 decal identification (cont’d) 75760 – SNAPPER LOGO – LOCATED ON INTAKE BAFFLE (ON APPLICABLE MODELS) 73462 – WARNING COMBO – LOCATED ON TOP OF BLOWER HOUSING 75861 / 29445 – GIANT-VAC LOGO – LOCATED ON MID-HANDLE PANEL (ON APPLICABLE MODELS) 3079269 – ‘EASY-OFF IMPELLER’ – LOCATED ON INTAKE BAFFLE 1722551 – SIMPLICITY LOGO ...
-
Snapper ELBX10151BV - page 17
NOTES ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ____________________________________________________________ ...
-
Snapper ELBX10151BV - page 18
NOTES ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ____________________________________________________________ ...
-
Snapper ELBX10151BV - page 19
NOTES ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ______________________________________________________________________ ____________________________________________________________ ...
-
Snapper ELBX10151BV - page 20
European Extreme Series Walk-Behind Leaf Blower Series 1 McDonough, GA 30253 USA Manual No. 7078092 (I.R. - 09/14/ 04) ...
У вас вопрос, касающийся Snapper ELBX10151BV?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Snapper ELBX10151BV, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Snapper ELBX10151BV со всей вероятностью он захочет поделиться методом ее решения.