-
Hitachi CS 33EB - page 1
Chain Saw Model CS 33EB Handling instructions Note: Before using this machine, carefully read through these HANDLING INSTRUCTIONS to ensure e ffi cient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this machine. 000Book_CS33EB_Eng.indb A 000Book_CS33EB_Eng.indb A 2009/08/07 ...
-
Hitachi CS 33EB - page 2
1 MEANINGS OF SYM BO L S NOTE: Some units do not carry them. Symbols W ARNING The followin g show symbols used for the ma chine. Be sure tha t you understand their meaning bef ore use. It is important that you read, fully understand and observe the follow ing safety precautions and warnin gs. Careless or improper use of the unit ma y cause serious ...
-
Hitachi CS 33EB - page 3
2 WHA T IS WHA T? 1. Throt tle trigger: Device activated by the operator ʼ s fi nger , for controlling the engine speed. 2. Throttle trigger lockout ( Safety trigger) : Device that prevents the accidental operation of the thro t tle trigger until manually released. 3. Ignition switch: Device for allo wing the engine to be started or stopped. 4. O ...
-
Hitachi CS 33EB - page 4
3 W ARNINGS AND SAFET Y INSTRUCTIONS Operator safe ty ○ Always we ar a safety face shield or goggles. ○ Gloves should be used when sharpening chain. ○ Always we ar safety prot ective equipment such as jacket, trousers, glov es, helmet, boots with steel toe-c aps and non- slip soles whenever yo u use a chain saw . For work ing in trees the saf ...
-
Hitachi CS 33EB - page 5
4 W ARNING Improper maintenance could result in serious engine damage or in serious personal injury . Tr a n s p o r t and storage ○ Carr y the unit/machine by hand with the engine stopped and the mu ffl er away from yo ur body . ○ Allow the engine to cool, empty the fuel tank, and secure the unit/machine before storing or transporting in a veh ...
-
Hitachi CS 33EB - page 6
5 SPECIF ICA TIONS Model CS33EB (30) CS 3 3 EB (35 ) CS 3 3 EB (4 0) Engine Size (ml ) 3 2. 2 Spark Plug NGK BP M- 6A or BPMR- 6A or equiv alent Fue l Ta n k Capacit y (m l) 3 5 0 Chain Oil Ta n k Capac ity (m l) 2 5 0 Dry Weight (kg) (Witho ut guide bar and chain) 3.8 Guide bar length (mm) 3 0 0 3 5 0 4 0 0 Chain pitch (mm) 9. 5 2 Chain gauge (mm) ...
-
Hitachi CS 33EB - page 7
6 ASSE MBL Y PRO CED URE S W ARNING Never try to start engine without side case securely fastened. 1. Remove chain bar clamp nuts (1). 2. Remov e the side case (2) as pinching the rear part of the side case (2). ( Fig. 1 ) 2 1 Fig. 1 * In case of installing the spiked bumper (3), install the spik ed bumper (3) (if so equipped ) to the unit with tw ...
-
Hitachi CS 33EB - page 8
7 ○ Fue l contains highly fl ammable and it is possible to ge t the serious personal injury when inhaling or spilling on your body . Always pay attent ion when handling fuel. Always have good venti lat ion when handling fuel inside building. Fig. 7 Fue l ○ Always use branded 89 octane unleaded gasoline. ○ Use genuine two-c ycle oil or use a ...
-
Hitachi CS 33EB - page 9
8 How to con fi rm: 1) Tu r n o ff the engine. 2) Holding the chain saw horizontally , release yo ur hand from the front handle, hit the tip of the guide bar to a stump or a piece of wood, and con fi rm brake operation . Opera ting le vel varies by bar size . Fig. 13 In case the brak e is not e ff ective, ask our dealer for inspection and repai ...
-
Hitachi CS 33EB - page 10
9 Fig. 17 ○ There is a risk of kickba ck if the saw is pushed far enough so that you begin to cut with the nose of the bar . The saf est cutting method is to cut with the bottom part of the chain. Sawing with the upper part makes it much more di ffi cult to control the saw and increases the risk of kickback. ○ In case the chain locked, immediat ...
-
Hitachi CS 33EB - page 11
10 LIMBING THICK BR ANCHES When limbing thick branches, the guide bar ma y get pinched easily. Branches under tension often snap up , so cut troublesome branches in small steps. Apply the same principles as for cross cutting. Think ahead and be aware of the possible consequences of all yo ur actions. CROSS CUTTING/BUCKING Before st arting to cut th ...
-
Hitachi CS 33EB - page 12
11 IF THE SAW GETS STUCK Stop the engine. Raise the log or change its position, using a thick branch or pole as a lever . Do not try to pull the saw free. If you do, you can deform the handle or be injured by the saw chain if the saw is suddenly relea sed. MAINTENANCE MAINTENANCE, REPLACEMENT , OR REP AIR OF THE EMISSION CONTROL DE VICES AND SYSTEM ...
-
Hitachi CS 33EB - page 13
12 37 Fig. 32 Side case (F ig . 33) Always ke ep the side case and drive area clean of sa w dust and debris. Period ica ll y apply oil or grease to this area to protect from corrosion as some trees contain high lev els of acid. Fig. 33 Fue l fi lter (Fig. 34) Remove the fuel fi lter from the fuel tank and thoroughly was h it in solvent. Afte r th ...
-
Hitachi CS 33EB - page 14
13 51 50 49 48 Fig. 39 39. To p plate 40. Wor k i ng corner 41. Side plate 42. Gullet 43. Heel 44. Chas sis 45. Rivet hole 46. To e 47 . Depth gauge 48. Corr ect angle on top plate (de g r e e of angle depends on chain typ e ) 49. Slightly protruding “ho ok” or point (c u r v e on non-chisel chain) 50. To p of depth gauge at correct height belo ...
-
Hitachi CS 33EB - page 15
14 Monthly maintenance ○ Rinse the fuel tank with gasoline , and clean fuel fi lter . ○ Clean chain oil fi lter . ○ Clean the ext eri or of the carburet or and the space around it. ○ Clean the fan and the space around it. ○ Clean the mu ffl er of carbon . NOTE When ordering the par ts to your nearest dealer , please use the item numbers ...
-
Hitachi CS 33EB - page 16
15 000Book_CS33EB_Eng.indb 15 000Book_CS33EB_Eng.indb 15 2009/08/07 19:15:35 2009/08/07 19:15:35 ...
-
Hitachi CS 33EB - page 17
16 000Book_CS33EB_Eng.indb 16 000Book_CS33EB_Eng.indb 16 2009/08/07 19:15:36 2009/08/07 19:15:36 ...
-
Hitachi CS 33EB - page 18
17 Item No. Part Name Q’TY 1 CHAIN BAR CLAMP NUT 2 2 NAME PLATE 1 3 SIDE COVER SUB 1 4 BRAKE SUPPORT 1 5 BRAKE LINK 1 6 BRAKE LINK COVER 1 7 TAPPING SCREW (W/FLANGE) D4×16 7 8 BRAKE SPRING 1 9 CLUTCH 1 10 CLUTCH HOUSING 1 11 NEEDLE BEARING (D) 1 12 CLUTCH WASHER 1 13 CRANK SHAFT COLLAR 1 14 BRAKE BAND 1 15 TAPPING SCREW D3×8 2 16 CHAIN PULLER 1 ...
-
Hitachi CS 33EB - page 19
18 000Book_CS33EB_Eng.indb 18 000Book_CS33EB_Eng.indb 18 2009/08/07 19:15:37 2009/08/07 19:15:37 ...
-
Hitachi CS 33EB - page 20
Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan 904 Code No. E99003011 G Printed in China 000Book_CS33EB_Eng.indb 19 000Book_CS33EB_Eng.indb 19 2009/08/07 19:15:37 2009/08/07 19:15:37 ...
У вас вопрос, касающийся Hitachi CS 33EB?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Hitachi CS 33EB, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Hitachi CS 33EB со всей вероятностью он захочет поделиться методом ее решения.