-
Tanaka TBC-2501 - page 1
Owner’s Manual Model Numbers: TBC-250,TBC-250PF/PFD, TBC-2501,TBC-2510, TBC-270PF/PN,TBC-270PFD/PND TBC-300/SDH/3010,TBC-340/D, TBC-340PF/PFD BRUSHCUTTERS P/N 29363 Date 04-06-05 Supplier To The Outdoor Power Equipment Industry ISM, Inc. • 1028 4 th Street SW • Auburn, WA 98001 • Phone: (253) 333-1200 • Fax: (253) 333-1212 www.tanaka-usa. ...
-
Tanaka TBC-2501 - page 2
www.tanaka-usa.com 1 custsvc @tanaka-ism.co m Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Before using this unit: • Read the operator’s manual carefully. • Check that the cutt ing equipment is correctly assembled and adjusted. • Start the unit and check ...
-
Tanaka TBC-2501 - page 3
www.tanaka-usa.com 2 custsvc@tan aka- ism.co m Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Blade thrust may occur when the spinning blade contacts a solid object in the critical area. A dangerous reacti on may occur causing the entire unit and operator to be thr ...
-
Tanaka TBC-2501 - page 4
www.tanaka-usa.com 3 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D 1. What is What? Since this manual coves several models, there ma y b e some difference between pictures and your unit. Use the instructions that apply to your unit. 1. Fuel ...
-
Tanaka TBC-2501 - page 5
www.tanaka-usa.com 4 custsvc@tan aka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-2501, TBC-2510,TBC-270PF/PN T B C -27 0 PN / PND , TB C - 300/S DH /30 1 0, TB C - 3 4 0/ D.TB C - 3 4 0 PF / D 2. Warnings and safety instructions. Operator Safety • Always wear a safet y face shield or goggles . • Always wear heavy, long pant s, boo ts and glo ...
-
Tanaka TBC-2501 - page 6
www.tanaka-usa.com 5 custsvc@tan aka-ism.c om Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N/P N D ,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D 3. Assembly procedures Drive shaft to engine (Fig. 1 -1) Loosen tube locking bolt (1) about ten turns so that the bolt p oint will not obstruct drive shaft tube to be ins ...
-
Tanaka TBC-2501 - page 7
www.tanaka-usa.com 6 custsvc@tan aka-ism.c om Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N/P N D ,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Throttle wire/stop cord Remove the air cleaner cover. (Fig. 1 -4) Connect stop cords. (Fig. 1 -5) Cover throttle wire and stop cords together with protectiv e tube provid ...
-
Tanaka TBC-2501 - page 8
www.tanaka-usa.com 7 custsvc@tan aka- ism.co m Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N / PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D When using a trimmer head (Fig.1-9B) wi th two-piece type bl ade guard, attach the guard extension to the blade guard. (Fig. 1-9) Then locate the guard above the angle tr ...
-
Tanaka TBC-2501 - page 9
www.tanaka-usa.com 8 custsvc@tan aka- ism.co m Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N/P N D/PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Installation of cutting blade (Fi g . 1-10, 10B) (If so equipped) When installing a cutting blade, m ake sure the blade is not crack ed or damage and the cutting edge ...
-
Tanaka TBC-2501 - page 10
www.tanaka-usa.com 9 custsvc@tan aka-ism.c om Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N/P N D ,TBC - 300/SDH/3010,TB C - 340/D ,TBC - 340PF/D 4. Operating procedures Fuel (Fig. 2-1) WARNING! The trimmer is equipped with a two-stroke engine. Al ways run the engine on fuel, which is mixed with oil. Provide good ...
-
Tanaka TBC-2501 - page 11
www.tanaka-usa.com 10 custsvc@tan aka-ism.c om Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D CAUTION! Before starting, make sure the cutting attach ment does not touch anything. Starting (Fig. 2-2, 2B) 1. Set ignition switch (1) to the ON position. (Fig. 2-2 ) *Pu ...
-
Tanaka TBC-2501 - page 12
www.tanaka-usa.com 11 custsvc@tanak a-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270P N/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Cutting (Fig. 2-4, 4B, 4C, 4D) • When cutting, operate engine at ov er 6500 rpm. Extended use at a low rpm will wear the clu tch prematurely. • Cut grass from right to ...
-
Tanaka TBC-2501 - page 13
www.tanaka-usa.com 12 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D 5. Maintenance MAINTENANCE, REPLA CEMENT, OR REPAIR OF THE EMISSION CONTROL DEVICES AND SYSTEMS MAY BE PERFORMED BY ANY NONROAD ENGINE RE PAIR ESTABLISHMENT OR INDIVIDUAL. ...
-
Tanaka TBC-2501 - page 14
www.tanaka-usa.com 13 custsvc@tana ka-ism.c om Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Drain all fuel from fuel tank and pull fuel filter line from tank. Pull filter element out of holder assembly. Replace filter if it appears to be discolored or hardened fr ...
-
Tanaka TBC-2501 - page 15
www.tanaka-usa.com 14 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Angle transmi ssion (Fig. 3-5B) Check the gear case grease level about every 50 hours of oper ation by removing the grease filler plug on the side of the case. If no grease ...
-
Tanaka TBC-2501 - page 16
www.tanaka-usa.com 15 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN/ PND,TBC - 300/SDH/3010,TBC - 340/D TBC - 340PF/D Maintenance schedule Below you will find some genera l maintenance instructions . For further information please contact your service dealer. Daily maintenance • Clean the ...
-
Tanaka TBC-2501 - page 17
www.tanaka-usa.com 16 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN /PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D 6. Optional Installation of free disk set (optional) (Fig. 4-1, 1 B) 1) Disassemble free disk (7) from the free disk set by loosening three bolts (8). 2) Install blade (3) ...
-
Tanaka TBC-2501 - page 18
www.tanaka-usa.com 17 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD, TBC-2501,TBC-2510 TBC - 270PF/PN/PFD/PND,TBC - 300/SDH/3010,TBC - 340/D 7. Specifications NOTE: Sound levels are calculated as the time-weighte d energy total under v arious working conditions with the followin g time distribution: ½ idlin g, ½ racin g . All data su ...
-
Tanaka TBC-2501 - page 19
www.tanaka-usa.com 18 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN /PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D Declaration of conformity D6claration de conformit6 Dichiarazione di conformita Konformitiitserkliirung Declaraci6n de conformidad Konformitetsdeklaration Tanaka Kogyo Co., ...
-
Tanaka TBC-2501 - page 20
www.tanaka-usa.com 19 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 P N /PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/ D IMPORTANT NOTICE THIS INFORMATION IS FOR TH E US AND CANADIAN MARKETS ONLY. • To reduce the risk of injury from loss of control, never use a metal blade on a curved sha ...
-
Tanaka TBC-2501 - page 21
www.tanaka-usa.com 20 custsvc@tana ka-ism.com Owner’s Manual TBC-250/250PF/PFD,TBC-250 1,TBC-2510,TBC-270PF/PFD TBC - 270 PN /PND,TBC - 300/SDH/3010,TBC - 340/D ,TBC - 340PF/D (1) Fixed line commercial cutting heads offer exc ellen t durability and light weight. Great for commercial use. (2) Tanaka Brain fully automatic heads. The Brain senses wh ...
У вас вопрос, касающийся Tanaka TBC-2501?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Tanaka TBC-2501, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Tanaka TBC-2501 со всей вероятностью он захочет поделиться методом ее решения.