-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 1
Owner’s Manual Please read before using this equipment. 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID 43-5520.fm Page 1 Friday, July 2 1, 2000 8:01 AM ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 2
2 ˆ Contents Features ........... .............. .............. .............. .............. ................. .............. .............. ...... ........ .... 6 Installation ....... .............. .............. .............. .............. .............. .............. ................. ...... .. .......... 7 Mounting the Phone ............. ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 3
3 This phone has bee n tested and found to comply with all applicable UL and FCC stan- dards. IMPORTANT CALLER ID INFORMATION To use the phone's Caller ID and Call Wait- ing with Caller ID features, you must be in an area where those services are available and you must subscribe to those services through your local phon e company. Where Caller ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 4
4 notice is not practical, the phone compa ny notifies you as soon as possible an d advises you of your right to fil e a complaint with the FCC. Also, the phone company can make changes to its lines, equi pment, operations, or p roce- dures that could affect the operation of th is telephone. The telephon e company notifies you of these changes in a ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 5
5 1 1 . Slots and openings in the cabine t and the back or bottom are provided fo r ve n- tilation. T o protect it from overheating, these openings must not be blocked or covered. The openings should never b e blocked by pla cing the product on a bed, sofa, rug, or other similar surface. This product should never be placed ne ar or over a radiator ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 6
6 Features 3. Do not open or mutilate the battery pack. Released electrolyte is corrosive and may cause damage to the eyes or skin. It may be toxic if swallowed. 4. Exercise care in handling the battery pack in order not to short it with conduct- ing materials such as rings, bracelets, and keys. The battery or cond uctor may overheat and cause bu r ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 7
7 Installation Headset Jack — lets you connect an optio n- al headset (available from yo ur local Ra- dioShack store) for hands-free convenience. Facedown or Faceup Handset Charging — you can place the handset on the ba se face down or face up (to show the Caller ID display, for example). Volume Control — lets you adjust the vol- ume you hear ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 8
8 Installation • Always connect the AC adapter to the phone before you connect it to AC power . When you finish, disco nnect the adapter from AC power before you dis- connect it from the phone. Note: Your telephone connects dire ctly to a modular telephone li ne jack. If your phone line jack is not a modul ar jack, you ca n up- date the wiring yo ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 9
9 Installation Note: To mount the phone directly on a wa ll, you need two screws (not sup plied) with heads that fit into the keyhole slots on the bottom of the base. Follow the steps u nder “On a Wall Plate or Wall” on Page 8, then apply th ese additional instructions. 1. Drill two holes 3 15 / 16 in ches (100 mm) apart. Then thread a screw in ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 10
10 Installation return the handset to the base for about 5 seconds. • Using a pencil eraser , clean the charg- ing contacts on the handset an d base about once a month. • If the battery pack becomes weak during a call, the handset beeps eve ry 3 sec- onds and Low Battery flashes. When this happens, you cannot make anoth er call on the phone unt ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 11
11 Installation A QUICK LOOK AT THE HANDSET Note: The handset window ha s a plastic film on it to protect it during sh ipment. Carefully peel off the film before using your phone for the first time . SETTING THE DIALING MODE Set DIAL MODE on the b ack of the base for the type of service you have. If you are not sure which type you have, once the ba ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 12
12 Installation not press the access code numb er either . If the dial tone stops , you have touch- tone service. Leave DIAL MODE set to T . If the dial tone continues , you have pulse service. Set DIAL MODE to P (pulse). SETTING THE RINGER TO N E / VO L U M E You can select one of four different ringer tone/volume settings on the handset. Re- peat ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 13
13 Operation STORING Y OUR AREA CODE You can store your local area code in the phone’s Caller ID record so it does not sho w the area code if the received call is from yo ur local area. If for some reason you ne ed to dial the area code (or store it in the memory), you can add it afterwards. See “Adding/De- leting the Area Code” on Page 20. N ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 14
14 Operation Once you set the volume level, the setting is maintained even after you han g up the phone. Note: When you press VOL/CID 8 8 8 8 while the volume is maximum or VOL/CID 9 9 9 9 while the volume is low, the setting d oes not chang e and the phone beeps three times. USING THE SPEAKERPHONE To make or answer a ca ll using the speaker- phone ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 15
15 Operation plays. Th en press TA L K and the phone dia ls the number. To dial the last number dialed using the base, press SPEAKER then REDIAL . Notes: • The redial memory fo r each keyp ad is separate. Y ou cannot redi al a number you dialed on the handset’s keypad using REDIAL on the base’s keypad, and vice versa. • On the handset, you ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 16
16 Operation T ransferring a Call Between the Handset and Base You can use the phone’s intercom feature to transfer a call between the handset and the base. To transfer a call from the handset to the base, press INTCM . The ca ll is placed on hold, and Paging Base and Hold appear. When the person at the base answers, press TA L K . The call is re ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 17
17 Operation 6. Press SELECT/CHANNEL . Store Num- ber appears. 7. Enter the phone number and any tone or pause entries (see “Usin g T one Services on a Pulse Line” o n Page 15 and “Enter- ing a Pause” on Pag e 18). 8. Press SELECT/CHANNEL . The phone beeps and <Memory nn Stored> appears (nn is the memory location number you selected). ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 18
18 Operation Entering a Pause In some telephone systems, you must di al an access code (9, for example) and wait for a second dial tone before you can dial an out- side number. You can store the access cod e with the phone number. However, you should also store a pause after the access code to allow the outside line time to con- nect. To enter a 2- ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 19
19 Operation Notes: • Connecting a headset disconnects th e handset’s earpiece and microphone. • VOL/CID 8 8 8 8 or 9 9 9 9 on the handset also controls the connected headset’s vol- ume. • If you place the handset on the base to recharge it while the headset is co n- nected, be sure the handset seats p rop- erly . With a headset connected ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 20
20 Operation Adding/Deleting the Area Code When the area code of the received call is the same as the one you stored (see “Storing Your Area Code” on Page 13), the call er ID record does not show the area code. If it is different, the record shows the area code. However, you can add or delete the area code. When the record is on the display, pr ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 21
21 Operation Follow these steps to delete all Calle r ID records. 1. Press CAL L ID so the record tota ls appear . 2. Press DEL . Delete All? and Yes / No appear with the cursor pointing to No . 3. Press VOL/CID 8 8 8 8 to move the cursor to Yes , then press SELECT/CHANNEL or DEL . The phone beeps once and Total:00 appears. USING THE PHONE COMPANY? ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 22
22 Troubleshooting Note: You can disp lay the programmed ser- vice number of each calling feature. At step 2 above, press 7 7 7 7 to see the number and 6 6 6 6 to return the list of servi ces. Editing Service Name and Numbers You might need to ch ange the numb er stored in any of the three service locations, for example, if your phone compan y uses ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 23
23 Troubleshooting If you still have problems, discon nect the phone. If other phones on the sa me line work proper- ly, the fault is in th is phone or its in stallation. If you cannot fi nd the problem, take the p hone to your local RadioShack store for assistance. CARE Keep the phone dry; if it gets we t, wipe it dry immediately. Use and store th ...
-
Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID - page 24
43-5520 UZZ01699ZZ 07A00 Printed in China RadioShack Corporation Fort Worth, Texas 76102 Limited One-Y ear Warranty This product is warr anted by RadioShack against manufacturing defects in material and workman- ship under normal use for one (1) year f rom t he date o f purch ase f rom RadioShack compan y- owned stores and authorized RadioShack fra ...
У вас вопрос, касающийся Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Radio Shack 900 MHz Digital Spread Spectrum Dual Keypad Cordless Telephone with Caller ID/Call Waiting ID со всей вероятностью он захочет поделиться методом ее решения.