-
Kenmore 625.38575 - page 1
OWNER'S MANUAL MODEL NO. UltraFilter 550 625.385750 Caution: Read and Follow All Safety Rules and Operating Instructions Before First Use of This Product. If you have questions when installing, operating or maintaining your reverse osmosis system, call this toll-free number... 1-800-426-9345 (M-F, 7am-8pm, CST) For repair or replacement parts, ...
-
Kenmore 625.38575 - page 2
- WARRANTY- F iiiiiiiii iiiiiiiiiiii iiiiiiii _ FULL WARRANTY ON REVERSE OSMOSIS DRINKING WATER SYSTEM I I i (except filter cartridges and R. O. membrane) i i For one year from the date of purchase, when the Reverse Osmosis Drinking Water System is installed I and maintained in accordance with our instructions, Sears will repair, free of charge, de ...
-
Kenmore 625.38575 - page 3
- TABLE OF CONTENTS - Where To Install the RO System ............ 4 Tools and Materials Needed ............... 4 6 Steps to Install ......................... 4 Install Cold Water Supply Fitting ......... 5 Install Drain Adapter ................... 6 Install Faucet ........................... 6 Install RO Assembly .................... 7 Install Stor ...
-
Kenmore 625.38575 - page 4
- WHERE TO INSTALL THE RO SYSTEM - The RO assembly and storage tank is designed for installation under the sink, usually in the kitchen or bathroom. The RO assembly mounts on a wall sur- face, or can lay on the cabinet floor next to the storage tank. Hanger washers and wood screws are included for cabinet wall mounting. The RO product water faucet ...
-
Kenmore 625.38575 - page 5
- STEP 1: INSTALL COLD WATER SUPPLY FITTING - Check and comply with local plumbing codes as you plan, then install a cold feed (supply) water fitting. The fitting must provide a leak- tight connection to the RO 1/4" tubing (see Figure 8, page 8). A typical connection using the included water supply fitting is shown in Figure 3A below. An optio ...
-
Kenmore 625.38575 - page 6
- STEP 2: INSTALL DRAIN ADAPTER - • Note: Running the drain tubing directly to a floor drain, sump, standpipe, laundry tub, etc., as shown on page 17, is preferred. However, if that is not pos- sible or practical, the included drain adapter installs in the sink drain pipe, always above or ahead of the p-trap, Figure 4. Be sure to comply with your ...
-
Kenmore 625.38575 - page 7
STEP 3: INSTALL FAUCET (cont.)- B. ASSEMBLE FAUCET NOTE: If the faucet and spout are unassembled, slide the spout into the faucet body. 1. Snap LED assembly into electronics ring (may al- ready be assembled) and o-ring in the groove on the bottom of the ring and slide the chrome monitor ring onto the faucet stud. The monitor ring LED wire must be r ...
-
Kenmore 625.38575 - page 8
- STEP 5: INSTALL STORAGE TANK, MAKE REMAINING TUBING CONNECTIONS - 1. CONNECT DRAIN TUBING, FAUCET TO DRAIN ADAPTER: Referring to Figure 8, run the loose section of black 3/8" tubing from the faucet to the drain adapter, with a black collet, installed on page 6. Cut this tubing as needed to route in as straight of a run as possible, without l ...
-
Kenmore 625.38575 - page 9
- STEP 6: SANITIZING, PRESSURE TESTING & PURGING - SANITIZING Sanitizing is recommended upon installation of the RO system, and after servicing inner parts. It is im- portant for the service person to have clean hands while handling inner parts of the system. CA UTION: Be sure to remove the RO membrane and both filter cartridges as follows, bef ...
-
Kenmore 625.38575 - page 10
- HOW YOUR REVERSE OSMOSIS SYSTEM WORKS - PREFILTER Water from the cold supply pipe enters the RO as- sembly prefilter first (Figure 8, page 8, and sche- matic, page 11). The prefilter has a replaceable sediment cartridge with activated carbon in its composition. The car- tridge (10 micron) removes sand, silt, dirt, other sedi- ments, and up to the ...
-
Kenmore 625.38575 - page 11
- HOW YOUR REVERSE OSMOSIS SYSTEM WORKS - REVERSE OSMOSIS WATER FLOW SCHEMATIC PRODUCT WATER FAUCET air gap __f _1= gravity 4. drain BLUE _ PRODUCT WATER RED -o drain flow control check SHUTOFF valve WATER GREEN ! IN "" t_q RO PREFILTER MEMBRANE POSTFILTER Figure 9 - CARE OF YOUR REVERSE OSMOSIS SYSTEM - To keep your reverse osmosis syste ...
-
Kenmore 625.38575 - page 12
- CARE OF YOUR REVERSE OSMOSIS SYSTEM - PREFILTER AND POST FILTER CARTRIDGES You must replace the pref!lter cartridge often to pro- tect the RO membrane from being destroyed by chlorine, and/or from plugging with sediments in your water supply. If the water supply contains both chlorine and sediments, replace the prefilter cartridge at least every ...
-
Kenmore 625.38575 - page 13
- CARE OF YOUR REVERSE OSMOSIS SYSTEM - RO MEMBRANE CARTRIDGE The life of the RO membrane cartridge depends mostly on the pH of the supply water to the RO sys- tem (see specifications). Cartridge life is shorter with higher pH. For example, if supply water pH is flom 6.8 to 7.7, the cartridge may last for well over one yea1: How- eve_, cartridge li ...
-
Kenmore 625.38575 - page 14
- CARE OF YOUR REVERSE OSMOSIS SYSTEM - TUBING CONNECTION (all push- in fitting locations) This RO system includes push-in fittings for quick tubing connection at most locations. If working with the fittings, do the following. Connection (Figure 12): 1. Use a sharp cutter or knife to cut the end of tubing square. 2. Inspect the end (about 1") ...
-
Kenmore 625.38575 - page 15
- CARE OF YOUR REVERSE OSMOSIS SYSTEM - REVERSE OSMOSIS SYSTEM CARE GUIDE MODEL NO. 625.385750 1. AT LEAST every 6 months, replace the prefilter and postfilter cartridges or when yellow LED flashes. 2. Replace the RO membrane cartridge when the percent rejection of total dissolved solids (TDS) is less than shown in the specifications (see B, below) ...
-
Kenmore 625.38575 - page 16
- DIMENSIONS and SPECIFICATIONS - 11" 13" Supply water pressure limits ........................ 40 - 100 psi Supply water temperature limits ..................... 40 - 100 °F Maximum total dissolved solids (TDS) ............... 2000 ppm Maximum water hardness @ 6.9 pH ................. 10 gpg Maximum iron, manganese, hydrogen sulfide ... ...
-
Kenmore 625.38575 - page 17
- REMOTE INSTALLATION LOCATIONS - Possible remote locations for the RO nearby the kitchen or bathroom sink include; (1) a basement area underneath the sink, and (2) an adjacent room or closet. Longer lengths of tubing (see parts list on page 18) and telephone cable extension (purchase lo- cally*) may be needed. You can run the drain tubing directly ...
-
Kenmore 625.38575 - page 18
- REPAIR PARTS - 22 21 Z O Kenmore Reverse Osmosis Drinking Water System, Model No. 625.385750 24 lO_"f 11 9 12 13 / Manifold Housing PUSH - IN FITTINGS 1/4" _" 3/8" o- ring seal toilet 8 25 23 [ @ ® 26 I 19 16 17 15 18 Problems, Questions? Call 1-800-426-9345 Kenmore Water Line 3 1/4" Tubing ...
-
Kenmore 625.38575 - page 19
- REPAIR PARTS - Kenmore Reverse Osmosis Drinking Water System, Model No. 625.385750 Key Part Description of Part No. Number 1 7221128 Sump (3 req.) 2 7223633 O-Ring, 2-1/4" x 2-1/2" (3 req.) 3 7199486 Flow (Control) Insert 4 9006062 Screw (2 req.) 5 9041700 Hanger Washer (2 req.) 6 7234210 Paddlewheel & O-Ring Kit 7 7234228 Paddlewhe ...
-
Kenmore 625.38575 - page 20
OWNER'S MANUAL MODEL NO. UltraFilter 550 625.385750 The model number of your reverse osmosis system is found on the rating decal. This decal is on the back of the R. O. sump. When requesting service or ordering parts, always provide the following in- formation: 4, Product Type 4, Model Number 4, Part Number 4, Part Description www.Ken moreWate ...
У вас вопрос, касающийся Kenmore 625.38575?
Воспользуйтесь формуляром, находящимся ниже
Если с помощью найденной инструкции Вы не решили свою проблему с Kenmore 625.38575, задайте вопрос, заполнив следующий формуляр. Если у какого то из пользователей была похожая проблема с Kenmore 625.38575 со всей вероятностью он захочет поделиться методом ее решения.