Manuel d’utilisation Ei Electronics Ei141RC

16 pages Non applicable
Télécharger

Aller à la page of 16

Summary
  • Ei Electronics Ei141RC - page 1

    IDEALLY I NSTALL IN T HE C ENTRE OF CEILIN G AT L EAST 3 00mm FROM L IGHT FITTINGS LOCATE IONISATION A LARMS AWAY FROM KITCHENS TO PREVENT NUISANCE ALARM S ENSURE L IVE MAINS IS CORRECTLY CONNECTED TO L TERMINALS ON A LL INTERCONNECTED A LARMS - OTHERWIS E UNITS WILL BE DAMAGED DO N OT FIT ACTUAL A LARM UNTIL A LL BUILDING WORK IS C OMPLETED TO AVO ...

  • Ei Electronics Ei141RC - page 2

    1.1 Installation Guide 2 ...

  • Ei Electronics Ei141RC - page 3

    2. Alarm Removal SLIDE AL AR M OFF BA SE WI TH T HE S CREW DRIVER STILL IN SER TE D, PUSH TH E LO WE R HALF OF TH E ALARM AW AY F ROM THE SCRE WD RIVER, I N TH E DIRECTION OF THE ARROW ON THE COVER HOLD T HE L OW ER H ALF OF THE ALA RM AND REMOVE FRO M THE BASE PLATE B Y MO VI NG I T VERTICALL Y DO WNWA RDS, T O WA RD S T HE F L OO R REMOVE A L ARM ...

  • Ei Electronics Ei141RC - page 4

    2. HOW MANY ALARMS TO INSTALL - CATEGORIES & GRADES - The advice here follows the guidance in British Standard BS 5839-Part 6: 2004 in general (for further information see the BS standard itself). The main reason for fitting Smoke & Heat Alarms in dwellings is to ensure that when there is a fire, sufficient early warning is given so that ev ...

  • Ei Electronics Ei141RC - page 5

    for dwellings where occupants may be at high risk (e.g. elderly) OPTIMUM PROTECTION LD1 Optimum Protection LD1: As LD2, but in addition Smoke or Heat Alarms should be located in all rooms and other areas of the dwelling. (apart from toilets or bathroom) Multi Storey Dwelling LD1 Heat Alarms located in: (Heat Alarms must be within 5.3m of potential ...

  • Ei Electronics Ei141RC - page 6

    for dwellings where occupants may be at high risk (e.g. elderly) OPTIMUM PROTECTION LD1 Optimum Protection LD1: As LD2, but in addition Smoke or Heat Alarms should be located in all rooms and other areas of the dwelling. (apart from toilets or bathroom) Multi Storey Dwelling LD1 Heat Alarms located in: (Heat Alarms must be within 5.3m of potential ...

  • Ei Electronics Ei141RC - page 7

    for dwellings where occupants may be at high risk (e.g. elderly) OPTIMUM PROTECTION LD1 Optimum Protection LD1: As LD2, but in addition Smoke or Heat Alarms should be located in all rooms and other areas of the dwelling. (apart from toilets or bathroom) Multi Storey Dwelling LD1 Heat Alarms located in: (Heat Alarms must be within 5.3m of potential ...

  • Ei Electronics Ei141RC - page 8

    2.2 Selecting Alarm Type 1 Optical Smoke Alarms are recommended due to their excellent response to smouldering fires. If there is likely to be problems with steam, contamination or dust build-up, or if there is significant risk of a fast burning clean fire an Ionisation Smoke Alarm should be fitted. 2 Ionisation and Optical Smoke Alarms should be f ...

  • Ei Electronics Ei141RC - page 9

    Improved Audibility The effectiveness of Category LD2 and LD3 systems can be significantly enhanced if an additional Smoke Alarm (interconnected) is installed in the master bedroom. This will help ensure that a responsible person will quickly be alerted to a fire and can arrange for an orderly evacuation of children and other vulnerable occupants. ...

  • Ei Electronics Ei141RC - page 10

    Wall mounting of smoke alarms (only): If ceiling mounting is impractical, smoke alarms may be mounted on a wall, provided that: a) the top of the detection element is between 150mm and 300mm below the ceiling; b) the bottom of the detection element is above the level of any door openings; Wall mounting should only be considered where close spaced b ...

  • Ei Electronics Ei141RC - page 11

    • Do not locate in insect infested areas . Small insects getting into the smoke detector chamber can cause intermittent alarms. Insects and contamination on the Heat Alarm sensor can increase its response time. 4. INSTALLATION The Alarm is designed to be permanently mounted, using it’s own built-in terminal block to connect it to the mains. The ...

  • Ei Electronics Ei141RC - page 12

    Note: BS 5839-6 2004 gives the folowing recommendations regarding the mains supply to be used in a Grade D system (The Ei141RC/146RC/161RC/166RC Smoke Alarms and Ei144RC/164RC Heat Alarms can be used in a Grade D system). The power supply for the Alarms should be derived from the public electricity supply to the dwelling. The mains supply to the Al ...

  • Ei Electronics Ei141RC - page 13

    We strongly recommend that you check for the following before connecting the alarm : • check for Live and Neutral using a two probe tester. • check for Live using a neon tester. • check that the Interconnect wire is NOT connected to Live, Neutral or Earth. Do not use an Earth wire for the Interconnect line. N.B. The alarm does not need to be ...

  • Ei Electronics Ei141RC - page 14

    prevent air draughts affecting the smoke/heat entering the alarm. If the hole is too large or the alarm does not seal it, it should be sealed with silicone rubber or equivalent. 6. Replace the wiring cover. Check the alarm battery is connected (Ei141RC/144RC/146RC only). 7. Carefully line up the unit on the base and slide on. 8. Press and hold the ...

  • Ei Electronics Ei141RC - page 15

    In the UK it is recommended that the following coloured cores are used (for example with triple flat 6243Y cable). 230V supply Brown Neutral Grey - sleeved blue at terminations Interconnect Black The interconnect wire (minimum 0.75mm 2 cable) must be treated as if it was Live. It should be insulated and sheathed. A maximum of 250 metres of wire can ...

  • Ei Electronics Ei141RC - page 16

    5. ACCESSORIES Alarm System Control Switch Ei1529RC: The Syst em Contr ol Switc h is recommended for systems with three or more Smoke / Heat Alarms. It a llo ws the user to perform the following functions from a remote location: LOCATE - If alarms sound press Locate to allow source of alarm to be identified. SILENCE - Press Hush to silence nuisance ...

Fabricant Ei Electronics Catégorie Smoke detector

Les documents que nous recevons du fabricant de l'appareilEi Electronics Ei141RC peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques Ei Electronics
- manuels d’utilisations Ei141RC
- fiches produit Ei Electronics
- dépliants
- ou étiquettes-énergie Ei Electronics Ei141RC
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation Ei Electronics Ei141RC.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation Ei Electronics Ei141RC, manuels d’entretien, brefs manuels ou manuels de l’utilisateur Ei Electronics Ei141RC. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit Ei Electronics Ei141RC.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil Ei Electronics Ei141RC, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser Ei Electronics Ei141RC par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs Ei Electronics Ei141RC.

Le manuel d’utilisation complet Ei Electronics, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel Ei Electronics Ei141RC - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières Ei Electronics Ei141RC, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lEi Electronics Ei141RC qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil Ei Electronics Ei141RC - qui devraient nous aider dans les premières étapes lors de l'utilisation Ei Electronics Ei141RC
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de Ei Electronics Ei141RC
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service Ei Electronics Ei141RC dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de Ei Electronics Ei141RC?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec Ei Electronics Ei141RC, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec Ei Electronics Ei141RC il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)