Français dropdown-ico

Manuel d’utilisation CFM SHR36

24 pages 3.38 mb
Télécharger

Aller à la page of 24

Summary
  • CFM SHR36 - page 1

    1384 SHR cov er 5/27/99 djt SHR Series W oodburning Fireplace For Models: SHR36 SHR42A SHR48 SHR52 Underwriter's Laboratories Report No. MH6018 DO NOT DISCARD THIS MANUAL: Retain for future use. 20001384 4/07 Rev . 19 Homeowner's Installation and Operating Manual ...

  • CFM SHR36 - page 2

    2 SHR Series W oodbur ning Fir eplace 20001384 Safety Information PLEASE READ THIS MANUAL BEFORE INST ALLING AND USING FIREPLACE. IMPORT ANT : Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty . Description The SHR Series ? ...

  • CFM SHR36 - page 3

    3 SH R Series W oodb ur ning Fir eplaces 20001384 Rough Opening Height 42" (1067mm) 52  " (1327mm) 48  " (1222mm)  "  " 28  " (724mm)  " (189mm) 13  " Dia. (340mm) Rough Opening Width 53  " Rough Opening Depth 65  &quo ...

  • CFM SHR36 - page 4

    4 SHR Series W oodbur ning Fireplace 20001384  " (724mm) 7  " (197mm ) 48" (1219mm) 58  " (1480mm) 48  " (1232mm)  "  "  " (189mm) 13  " Dia. (340mm) Rough Opening Width 59  " Rough Opening Height Rough Open ...

  • CFM SHR36 - page 5

    5 SH R Series W oodb ur ning Fir eplaces 20001384 FP554A SH Series  1/28/99 djt Chase Installation Insulation methods shown are optional for cold climate, not a requirement for unit operation. FP554A Fig. 5 Fireplace and chase parts identification. (SHR48 shown) T ermination Cap Storm Collar Pan Flashing Batt Insulation (cut out around fire ...

  • CFM SHR36 - page 6

    6 SHR Series W oodbur ning Fireplace 20001384 Chimney Requirements - Offset Installations 0 0 0 0 0 3" 1 1" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 1 1 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 ...

  • CFM SHR36 - page 7

    7 SH R Series W oodb ur ning Fir eplaces 20001384 Planning Information The T en Foot Rule Major U.S. building codes specify a minimum chimney height above the roof top. The “T en Foot Rule” is a fire safety rule and not a draft rule. T o ensure proper draft, it is recommended that you always meet or exceed the “T en Foot Rule,” especially ...

  • CFM SHR36 - page 8

    8 SHR Series W oodbur ning Fireplace 20001384 Installation Chimney Supports The chimney system is supported by the fireplace for vertical chimney heights less than 30 feet above the hearth. Chimney supports are required if the vertical height exceeds 30 feet with 1 1CF chimneys. Locate chimney supports at ceiling holes or other structural framing ...

  • CFM SHR36 - page 9

    9 SH R Series W oodb ur ning Fir eplaces 20001384 Framing Framing can be constructed before or after the fireplace is set in place, however , most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials. Refer to framing dimensions in Figures 1 - 4 for basic fireplace specifications. NOTE ...

  • CFM SHR36 - page 10

    10 SHR Series W oodbur ning Fireplace 20001384 FP556SHR Fig. 13 Locate centerline of chimney with plumb line. FP556SHR SHR LOCA TE CENTER LINE 5/11/99 djt Chimney Centerline Actual Centerpoint Plumb Line Plumb Bob Imaginary Centerpoint 1 1 ¹⁄₈ " (283 mm) FP 548b SHR 5/1 1/99 djt Angle of Chimney at Ceiling Size of Chimney V ertic ...

  • CFM SHR36 - page 11

    1 1 SH R Series W oodb ur ning Fir eplaces 20001384 The inside dimension of the frame must be the same as the hole size selected from Figure 1 1 in order to provide the required 2 inches of air space between the outside diameter of the chimney and the edges of the framed ceiling hole. Positioning, Safety Strips, Securing the Fireplace Slide firepl ...

  • CFM SHR36 - page 12

    12 SHR Series W oodbur ning Fireplace 20001384 Installing the Chimney System Start by attaching the first chimney section to the collar on top of the fireplace. Install the pipe as pictured in Figure 19. When you get a good lock, you will hear the pipe clearly snap together . Once sections are snap-locked in place, it is extremely difficult to g ...

  • CFM SHR36 - page 13

    13 SH R Series W oodb ur ning Fir eplaces 20001384 Attic Installation Ceiling Installation Fig. 21 Installing firestop spacer . FP285 IWF285 mbuf 5/25/96   Nails (4) Firestop Spacer Joist Joist Firestop Spacer Nails (4) Flange Down Into Hole Flange Up Into Hole NOTE: If the attic insulation shield is used, the firestop is not required ...

  • CFM SHR36 - page 14

    14 SHR Series W oodbur ning Fireplace 20001384 Cut and Frame Roof Hole Size of roof hole varies with the type of chimney termi- nation installed. Refer to installation instructions pro- vided with the chimney termination to find correct size roof hole. There must be a 2" (51 mm) air space between out- ermost portion of chimney sections and an ...

  • CFM SHR36 - page 15

    15 SH R Series W oodb ur ning Fir eplaces 20001384 FP1166 surround flush with finished wall 12/20/01 djt Stud 2 x 4 Header Ledge Bracket Surround Must be Sealed with Noncombustible Material Noncombus- tible Decorative Facing Finished W all FP1 166 Fig. 26 Fireplace surround flush with finished wall. FP1277 SHR52 drywall finish 1/30/03 djt Fini ...

  • CFM SHR36 - page 16

    16 SHR Series W oodbur ning Fireplace 20001384 FP1167 facing flush with finished wall 12/20/01 djt Finished W all Stud Noncombustible Decorative Fac- ing Must be Sealed with Noncombustible Material Surround 2 x 4 Finished Header Covered W all Ledge Bracket FP1 167 Fig. 27 Facing on fireplace surround flush with finished wall. FP1168 finishing fr ...

  • CFM SHR36 - page 17

    17 SH R Series W oodb ur ning Fir eplaces 20001384 Side W all Protection Adjacent combustible side walls that are within dimen- sions shown in Figure 30 of fireplace opening must be protected with W all Shield Model SP40 or a specifically built wall shield described in Figure 29. The special wall shield design described in Figure 27 is an alterna ...

  • CFM SHR36 - page 18

    18 SHR Series W oodbur ning Fireplace 20001384 FP532SHR Fig. 32 Combustible side wall protection and hearth extension dimensions. Minimum W all Clearances WITH Noncombustible Surround Facing WITHOUT Noncombustible Surround Facing Minimum Hearth Extension Dimensions (for On-Site Construction) G H G J Seal cracks between the fireplace and hearth exte ...

  • CFM SHR36 - page 19

    19 SH R Series W oodb ur ning Fir eplaces 20001384 removed from gas line tube to repack space around the pipe. Material should be inserted from outside of the fireplace and packed tightly to totally seal between the pipe and tube. NOTE: Gas pipe should not come in contact with any wood structures until it has reached a point at least one (1) inch ...

  • CFM SHR36 - page 20

    20 SHR Series W oodbur ning Fireplace 20001384 1384 pts replacement parts 5/27/99 djt 7/14/99 removed clips,added push nut 1 2 3 4 5 6 7 8 a b c 9 10 1 1 d 12 13 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. SHR36/42A/48/52 W oodburni ...

  • CFM SHR36 - page 21

    21 SH R Series W oodb ur ning Fir eplaces 20001384 Description Designed to enclose the fireplace opening with glass doors allowing the fire to remain visible. Available in Polished, Brushed Brass, Black and Pewter Provides outside air for fuel conbustion in the firebox. This accessory must be installed before fireplace is installed. Located on ...

  • CFM SHR36 - page 22

    22 SHR Series W oodbur ning Fireplace 20001384 Accessory Description Model No. Contemporary Flashing Contemporary Chase T op T ermina- tion Contemporary Round T op T ermina - tion Extended Round T op Chimney Sections Chimney Elbows T op Housing with Upper Baffle Attic Insulation Shield Required for contemporary top termination on the roof to preve ...

  • CFM SHR36 - page 23

    23 SH R Series W oodb ur ning Fir eplaces 20001384 LIMITED W ARRANTY & 30 YEAR PROTECTION PLAN For MAJESTIC FIREPLACES ® PRE-ENGINEERED Fireplace Systems CFM Corporation warrants its MAJESTIC FIREPLACES® Pre- Engineered Fireplace (“Fireplace”) and the CFM Corporation supplied firegrate, glass doors, outside air system, fan motor , and li ...

  • CFM SHR36 - page 24

    © CFM Corporation 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 800-668-5323 • www .cfmcorp.com CFM Corporation ...

Fabricant CFM Catégorie Outdoor Fireplace

Les documents que nous recevons du fabricant de l'appareilCFM SHR36 peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques CFM
- manuels d’utilisations SHR36
- fiches produit CFM
- dépliants
- ou étiquettes-énergie CFM SHR36
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation CFM SHR36.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation CFM SHR36, manuels d’entretien, brefs manuels ou manuels de l’utilisateur CFM SHR36. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit CFM SHR36.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil CFM SHR36, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser CFM SHR36 par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs CFM SHR36.

Le manuel d’utilisation complet CFM, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel CFM SHR36 - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières CFM SHR36, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lCFM SHR36 qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil CFM SHR36 - qui devraient nous aider dans les premières étapes lors de l'utilisation CFM SHR36
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de CFM SHR36
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service CFM SHR36 dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de CFM SHR36?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec CFM SHR36, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec CFM SHR36 il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Captcha
Nouvelle image

Commentaires (0)