Italiano dropdown-ico

Manuale per l’uso CFM SHR36

24 pagine 3.38 mb
Scarica

Vai alla pagina of 24

Summary
  • CFM SHR36 - page 1

    1384 SHR cov er 5/27/99 djt SHR Series W oodburning Fireplace For Models: SHR36 SHR42A SHR48 SHR52 Underwriter's Laboratories Report No. MH6018 DO NOT DISCARD THIS MANUAL: Retain for future use. 20001384 4/07 Rev . 19 Homeowner's Installation and Operating Manual ...

  • CFM SHR36 - page 2

    2 SHR Series W oodbur ning Fir eplace 20001384 Safety Information PLEASE READ THIS MANUAL BEFORE INST ALLING AND USING FIREPLACE. IMPORT ANT : Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty . Description The SHR Series ? ...

  • CFM SHR36 - page 3

    3 SH R Series W oodb ur ning Fir eplaces 20001384 Rough Opening Height 42" (1067mm) 52  " (1327mm) 48  " (1222mm)  "  " 28  " (724mm)  " (189mm) 13  " Dia. (340mm) Rough Opening Width 53  " Rough Opening Depth 65  &quo ...

  • CFM SHR36 - page 4

    4 SHR Series W oodbur ning Fireplace 20001384  " (724mm) 7  " (197mm ) 48" (1219mm) 58  " (1480mm) 48  " (1232mm)  "  "  " (189mm) 13  " Dia. (340mm) Rough Opening Width 59  " Rough Opening Height Rough Open ...

  • CFM SHR36 - page 5

    5 SH R Series W oodb ur ning Fir eplaces 20001384 FP554A SH Series  1/28/99 djt Chase Installation Insulation methods shown are optional for cold climate, not a requirement for unit operation. FP554A Fig. 5 Fireplace and chase parts identification. (SHR48 shown) T ermination Cap Storm Collar Pan Flashing Batt Insulation (cut out around fire ...

  • CFM SHR36 - page 6

    6 SHR Series W oodbur ning Fireplace 20001384 Chimney Requirements - Offset Installations 0 0 0 0 0 3" 1 1" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 1 1 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 ...

  • CFM SHR36 - page 7

    7 SH R Series W oodb ur ning Fir eplaces 20001384 Planning Information The T en Foot Rule Major U.S. building codes specify a minimum chimney height above the roof top. The “T en Foot Rule” is a fire safety rule and not a draft rule. T o ensure proper draft, it is recommended that you always meet or exceed the “T en Foot Rule,” especially ...

  • CFM SHR36 - page 8

    8 SHR Series W oodbur ning Fireplace 20001384 Installation Chimney Supports The chimney system is supported by the fireplace for vertical chimney heights less than 30 feet above the hearth. Chimney supports are required if the vertical height exceeds 30 feet with 1 1CF chimneys. Locate chimney supports at ceiling holes or other structural framing ...

  • CFM SHR36 - page 9

    9 SH R Series W oodb ur ning Fir eplaces 20001384 Framing Framing can be constructed before or after the fireplace is set in place, however , most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials. Refer to framing dimensions in Figures 1 - 4 for basic fireplace specifications. NOTE ...

  • CFM SHR36 - page 10

    10 SHR Series W oodbur ning Fireplace 20001384 FP556SHR Fig. 13 Locate centerline of chimney with plumb line. FP556SHR SHR LOCA TE CENTER LINE 5/11/99 djt Chimney Centerline Actual Centerpoint Plumb Line Plumb Bob Imaginary Centerpoint 1 1 ¹⁄₈ " (283 mm) FP 548b SHR 5/1 1/99 djt Angle of Chimney at Ceiling Size of Chimney V ertic ...

  • CFM SHR36 - page 11

    1 1 SH R Series W oodb ur ning Fir eplaces 20001384 The inside dimension of the frame must be the same as the hole size selected from Figure 1 1 in order to provide the required 2 inches of air space between the outside diameter of the chimney and the edges of the framed ceiling hole. Positioning, Safety Strips, Securing the Fireplace Slide firepl ...

  • CFM SHR36 - page 12

    12 SHR Series W oodbur ning Fireplace 20001384 Installing the Chimney System Start by attaching the first chimney section to the collar on top of the fireplace. Install the pipe as pictured in Figure 19. When you get a good lock, you will hear the pipe clearly snap together . Once sections are snap-locked in place, it is extremely difficult to g ...

  • CFM SHR36 - page 13

    13 SH R Series W oodb ur ning Fir eplaces 20001384 Attic Installation Ceiling Installation Fig. 21 Installing firestop spacer . FP285 IWF285 mbuf 5/25/96   Nails (4) Firestop Spacer Joist Joist Firestop Spacer Nails (4) Flange Down Into Hole Flange Up Into Hole NOTE: If the attic insulation shield is used, the firestop is not required ...

  • CFM SHR36 - page 14

    14 SHR Series W oodbur ning Fireplace 20001384 Cut and Frame Roof Hole Size of roof hole varies with the type of chimney termi- nation installed. Refer to installation instructions pro- vided with the chimney termination to find correct size roof hole. There must be a 2" (51 mm) air space between out- ermost portion of chimney sections and an ...

  • CFM SHR36 - page 15

    15 SH R Series W oodb ur ning Fir eplaces 20001384 FP1166 surround flush with finished wall 12/20/01 djt Stud 2 x 4 Header Ledge Bracket Surround Must be Sealed with Noncombustible Material Noncombus- tible Decorative Facing Finished W all FP1 166 Fig. 26 Fireplace surround flush with finished wall. FP1277 SHR52 drywall finish 1/30/03 djt Fini ...

  • CFM SHR36 - page 16

    16 SHR Series W oodbur ning Fireplace 20001384 FP1167 facing flush with finished wall 12/20/01 djt Finished W all Stud Noncombustible Decorative Fac- ing Must be Sealed with Noncombustible Material Surround 2 x 4 Finished Header Covered W all Ledge Bracket FP1 167 Fig. 27 Facing on fireplace surround flush with finished wall. FP1168 finishing fr ...

  • CFM SHR36 - page 17

    17 SH R Series W oodb ur ning Fir eplaces 20001384 Side W all Protection Adjacent combustible side walls that are within dimen- sions shown in Figure 30 of fireplace opening must be protected with W all Shield Model SP40 or a specifically built wall shield described in Figure 29. The special wall shield design described in Figure 27 is an alterna ...

  • CFM SHR36 - page 18

    18 SHR Series W oodbur ning Fireplace 20001384 FP532SHR Fig. 32 Combustible side wall protection and hearth extension dimensions. Minimum W all Clearances WITH Noncombustible Surround Facing WITHOUT Noncombustible Surround Facing Minimum Hearth Extension Dimensions (for On-Site Construction) G H G J Seal cracks between the fireplace and hearth exte ...

  • CFM SHR36 - page 19

    19 SH R Series W oodb ur ning Fir eplaces 20001384 removed from gas line tube to repack space around the pipe. Material should be inserted from outside of the fireplace and packed tightly to totally seal between the pipe and tube. NOTE: Gas pipe should not come in contact with any wood structures until it has reached a point at least one (1) inch ...

  • CFM SHR36 - page 20

    20 SHR Series W oodbur ning Fireplace 20001384 1384 pts replacement parts 5/27/99 djt 7/14/99 removed clips,added push nut 1 2 3 4 5 6 7 8 a b c 9 10 1 1 d 12 13 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. SHR36/42A/48/52 W oodburni ...

  • CFM SHR36 - page 21

    21 SH R Series W oodb ur ning Fir eplaces 20001384 Description Designed to enclose the fireplace opening with glass doors allowing the fire to remain visible. Available in Polished, Brushed Brass, Black and Pewter Provides outside air for fuel conbustion in the firebox. This accessory must be installed before fireplace is installed. Located on ...

  • CFM SHR36 - page 22

    22 SHR Series W oodbur ning Fireplace 20001384 Accessory Description Model No. Contemporary Flashing Contemporary Chase T op T ermina- tion Contemporary Round T op T ermina - tion Extended Round T op Chimney Sections Chimney Elbows T op Housing with Upper Baffle Attic Insulation Shield Required for contemporary top termination on the roof to preve ...

  • CFM SHR36 - page 23

    23 SH R Series W oodb ur ning Fir eplaces 20001384 LIMITED W ARRANTY & 30 YEAR PROTECTION PLAN For MAJESTIC FIREPLACES ® PRE-ENGINEERED Fireplace Systems CFM Corporation warrants its MAJESTIC FIREPLACES® Pre- Engineered Fireplace (“Fireplace”) and the CFM Corporation supplied firegrate, glass doors, outside air system, fan motor , and li ...

  • CFM SHR36 - page 24

    © CFM Corporation 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 800-668-5323 • www .cfmcorp.com CFM Corporation ...

Fabbricante CFM Categoria Outdoor Fireplace

I documenti che otteniamo dal fabbricante del dispositivoCFM SHR36 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici CFM
- manuali per l’uso SHR36
- schede prodotto CFM
- opuscoli
- o etichette energetiche CFM SHR36
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso CFM SHR36.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione CFM SHR36, manuali di manutenzione, brevi manuali o manuali utente CFM SHR36. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto CFM SHR36.

Manuali per l’uso simili

Manuale completo del dispositivo CFM SHR36, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare CFM SHR36 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti CFM SHR36.

Il manuale per l’uso completo CFM, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale CFM SHR36 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice CFM SHR36, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per CFM SHR36 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo CFM SHR36 - che ci dovrebbe aiutare nei primi passi durante l'uso CFM SHR36
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del CFM SHR36
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio CFM SHR36 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su CFM SHR36?

Utilizza il modulo sottostante

Se non hai risolto il problema con CFM SHR36 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con CFM SHR36 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)