Italiano dropdown-ico

Manuale per l’uso Hobart ML-136500

24 pagine 1.43 mb
Scarica

Vai alla pagina of 24

Summary
  • Hobart ML-136500 - page 1

    INSTALLATION & OPERATIONAL MANUAL 1HFD & HFC SERIES ELECTRIC FRYERS With KleenScreen PLUS ® Filtration Systems MODELS: 1HF50D ML-136500 1HF85CF ML-136819 1HF85CF Shown - Computer Control ENERGY STAR® Qualified For additional information on Hobart or to locate an authorized parts and service provider in your area, visit our website at www. ...

  • Hobart ML-136500 - page 2

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -2- IMPORTANT FOR YOUR SAFETY THIS MANUAL HAS BEEN PREPARED FOR PERSONNEL QUALIFIED TO INSTALL ELECTRIC EQUIPMENT, WHO SHOULD PER FORM THE INITIAL FIELD START-UP AND ADJUSTMENTS OF THE EQUIPMENT COVERED BY THIS MANUAL. FOR YOUR SAFETY DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABL ...

  • Hobart ML-136500 - page 3

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -3- TABLE OF CONTENTS IMPORTANT FOR YOUR SAFETY……………………………… ………. 2 INTRODUCTION…………………… …………………………………… … 4 GENERAL…………………………… ……………………………… 4 ORDERING PARTS…? ...

  • Hobart ML-136500 - page 4

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -4- INTRODUCTION GENERAL Hobart Fryers are produced wit h quality workmanship and mate rial. Proper installation, usage and maintenance will result in year s of satisfactory performance. Before installing the fryer, thoroughly read th is manual and carefully fo llow all instructio ...

  • Hobart ML-136500 - page 5

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -5- Do not use the door or its handle to lift the fryer. MODEL - GMO Kw per Fry Tank Width Inch (cm) Total System Shortening lbs. (kg) Each Fry Tank 1HF50D 17 15.5" (39) 50 (23) 1HF85CF 24 21.0" (53) 85 (39) Voltage ranges are: 208, 3 Phase - 50 – 60 Hz 240, 3 Phase - ...

  • Hobart ML-136500 - page 6

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -6- CODES AND STANDARDS The fryer must be instal led in accordance with: In the United States:  State and local codes, or in the absence of local codes, with:  National Electrical Code, ANSI/NFPA-70 (latest edition). Copies may be obtained from The National Fire Protection A ...

  • Hobart ML-136500 - page 7

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -7-  Australia, use only the caster suppl ied by the manufactu rer for the fryer device. The fryer must be installed usi ng a hose assembly restraining device to limit the movement of the appli ance in accordance with AS1869.  The fryer must be installed with a connector (no ...

  • Hobart ML-136500 - page 8

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -8- LEVELING THE FRYER Check the level of the fryer by placing a level on top of the fr yer after electrical connections have been made. Ensure that the fryer is level front-to-back and side-to-side in the final installed position. If using casters, lock the wheels after unit is l ...

  • Hobart ML-136500 - page 9

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -9-  Wipe tank completely dry with a soft, clean cloth. FILLING TANK WITH SHORTENING  Close the drain valve.  Fill the fryer tank with shortening. Hobart recommends using liquid shortening.  Shortening level should be between the MIN and MAX lines in the fryer tank. ? ...

  • Hobart ML-136500 - page 10

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -10-  Batter covered foods should be dropped carefully , one by one, into shortening or basket. If you use the basket, first dip the basket into the shortening to reduce batter-build up on basket surfaces.  When frying is completed, remove ba sket or product. Hang basket on ...

  • Hobart ML-136500 - page 11

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -11- Programming the Solid State Control ...

  • Hobart ML-136500 - page 12

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -12- Programming the Computer Control ...

  • Hobart ML-136500 - page 13

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -13- TURNING OFF THE FRYER  Open the door to the fryer. Press t he power switch to the OFF position. EXTENDED SHUTDOWN 1. Open the door to the fryer. Press the power switch to the OFF position. 2. Thoroughly drain the fryer. Refer to DRAINING THE FRYER. 3. Clean the fryer accor ...

  • Hobart ML-136500 - page 14

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -14- DRAINING THE TANK 1. Open the door to the fryer. The power must remain ON for the fryer to filter correctly. 2. Insert the drain extension into t he drain valve. Tighten only hand tight. 3. Direct the drain spout into the container that you want to drain the shortening into. ...

  • Hobart ML-136500 - page 15

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -15- 9. Drain the tank according to DRAINING TH E TANK. Rinse thoroughly with clear, hot water. All traces of cleaner must be removed. Dry the tank thoroughly. 10. Close the drain valve and add shorteni ng. Follow the FILLING TANK WITH SHORTENING procedure in this manual. The frye ...

  • Hobart ML-136500 - page 16

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -16- KleenScreen Plus ® Filtration System Installation and Operational Manual for “HFF” Models 1HF85CF Shown Electric KleenScreen PLUS® Models 8 1HF85CF ML-136819 ...

  • Hobart ML-136500 - page 17

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -17- Filtering Instructions for KleenScreen PLUS ® Fryers General The KleenScreen PLUS ® filtration system filters the oil as it is pumped back into its’ respective tank(s). Only one tank can be drained and filter ed at a time. Under no circumstances should both tanks be drain ...

  • Hobart ML-136500 - page 18

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -18- Fully assembled filter screen assembly: F i g . 2 Secure Tube with Suction Tube Clip Filter Screen Lays Flat On Bottom of Filter Pan Fig. 3 Micro-Filtration Fabric Envelope Assembly: Same Suction Tube F a b r i c E n v e l o p e I n s e r t (Different from Screen Assembly) Fa ...

  • Hobart ML-136500 - page 19

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -19- INSTRUCTIONS TO REMOVE & REPLACE KLEENSCREE N PLUS ® FILTER ENVELOPE FOR ABSOLUTE FILTRATION & MAXIMUM FLOW RATE WE RECOMME ND YOU CHANGE YOUR FI LTER ENVELOPES AT EVERY OIL CHANGE (10-14 DAYS DEPENDING ON OIL USAGE). Step 1 Discard all oil from the filter vessel, (s ...

  • Hobart ML-136500 - page 20

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -20- Operation Hot oil and parts can cause burns. Use care when operating, cleaning and servicing the fryer. Spilling hot frying compound can cause severe burns. Do not move fryer wi thout draining all frying compound from the tank. Never run water or boil out solution thr ough fi ...

  • Hobart ML-136500 - page 21

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -21- Filtering Instructions for KleenScreen PLUS ® Fryers with Computer Controls ...

  • Hobart ML-136500 - page 22

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -22- FILTERING TIP: Open the filtering drawer approximately 1” to allow any oil in the re turn line to run back into the filter pan. This will take about 30 seconds to complete. Then open the drawer completely to clean filter components. REMOVING EXCESS DEBRIS FROM THE SCREEN FI ...

  • Hobart ML-136500 - page 23

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -23- BOIL OUT PROCEDURE: Use the Boil Out By-Pass™ drai n extension allowing the boil out solution to exit the fry t ank without using the filtering system. Do not allow water to run through the motor / pump. Drain the boil out solution into a bucket or place a hose on the end o ...

  • Hobart ML-136500 - page 24

    HFD, HFCF SERIES ELECTRIC FRYER HOBARTCORP F-32964 Rev. C (May 2012) -24- MAINTENANCE Hot oil and hot parts can cause burns. Use care when operating, cleani ng, and servicing the fry er. Spilling hot fryer com pound can cause severe burns. Do not move fryer without draining all frying com pound from the tank. Service in the US and Canada Contact yo ...

Fabbricante Hobart Categoria Clothes Dryer

I documenti che otteniamo dal fabbricante del dispositivoHobart ML-136500 possono essere suddivisi in diversi gruppi. Questi sono tra gli altri:
- disegni tecnici Hobart
- manuali per l’uso ML-136500
- schede prodotto Hobart
- opuscoli
- o etichette energetiche Hobart ML-136500
Tutti sono importanti, ma le informazioni più importanti dal punto di vista di utilizzo del dispositivo possono essere trovate nel manuale per l’uso Hobart ML-136500.

Un gruppo di documenti denominato manuali per l’uso, è anche suddiviso in tipi più specifici, come: Manuali di installazione Hobart ML-136500, manuali di manutenzione, brevi manuali o manuali utente Hobart ML-136500. A seconda delle esigenze, si dovrebbe cercare il documento necessario. Nel nostro sito web, puoi visualizzare il manuale più popolare per l'uso del prodotto Hobart ML-136500.

Manuali per l’uso simili

Manuale completo del dispositivo Hobart ML-136500, come deve essere?
Il manuale per l’uso, denominato anche istruzioni per l’uso, o semplicemente il manuale è un documento tecnico progettato per aiutare ad utilizzare Hobart ML-136500 dagli utenti. I manuali sono di solito scritti da uno scrittore tecnico, ma in un linguaggio accessibile a tutti gli utenti Hobart ML-136500.

Il manuale per l’uso completo Hobart, dovrebbe includere vari elementi di base. Alcuni di loro sono meno importanti, come ad esempio: copertina / pagina del titolo o pagina di autore. Tuttavia, la parte rimanente, dovrebbe fornire informazioni importanti dal punto di vista dell'utente.

1. Introduzione e la guida su come utilizzare il manuale Hobart ML-136500 - All'inizio di ogni manuale, dovremmo trovare indizi su come utilizzare il documento. Dovrebbe contenere informazioni sulla posizione dell’indice Hobart ML-136500, FAQ o i problemi più comuni : i punti che sono più spesso cercati dagli utenti di ogni manuale
2. Indice - elenco di tutti i suggerimenti per Hobart ML-136500 che possono essere trovati nel documento corrente
3. Suggerimenti su come utilizzare le funzioni di base del dispositivo Hobart ML-136500 - che ci dovrebbe aiutare nei primi passi durante l'uso Hobart ML-136500
4. Troubleshooting - sequenza sistematica delle attività che vi aiuterà a diagnosticare e, successivamente, risolvere i problemi più importanti del Hobart ML-136500
5. FAQ - domande più frequenti
6. Dettagli di contatto Informazioni su dove cercare il contatto con il fabbricante / servizio Hobart ML-136500 in un dato paese, se il problema non può essere risolto da noi stessi.

Hai una domanda su Hobart ML-136500?

Utilizza il modulo sottostante

Se non hai risolto il problema con Hobart ML-136500 con l'aiuto del manuale che hai trovato, fai una domanda utilizzando il modulo sottostante. Se un utente ha avuto un problema simile con Hobart ML-136500 è probabile che voglia condividere il modo di risolverlo.

Riscrivi il testo dall’immagine

Captcha
Nuova immagine

Commenti (0)