Carrier Access Thermidistatの取扱説明書

12ページ 0.1 mb
ダウンロード

ページに移動 of 12

Summary
  • Carrier Access Thermidistat - page 1

    Thermidistat™ Control Installation, Start-Up, and Operating Instructions NOTE: Read the entire instruction manual before starting the installation. This symbol → indicates a change since the last issue. INDEX Page SAFETY CONSIDERATIONS .....................................................1 INTRODUCTION .......................................... ...

  • Carrier Access Thermidistat - page 2

    INSTALLATION Step 1—Thermidistat Control Location Thermidistat Control should be mounted: • Approximately 5 ft (1.5m) from floor. • Close to or in a frequently used room, preferably on an inside partitioning wall. • On a section of wall without pipes or duct work. Thermidistat Control should NOT be mounted: • Close to a window, on an outs ...

  • Carrier Access Thermidistat - page 3

    3. A2—for 2-speed air conditioner 4. H2—for 2-speed heat pump 5. dF—for 1-speed dual fuel 6. d2—for 2-speed dual fuel 7. HS—for 1-speed heat pump with Intelligent Heat Staging (3-stage auxiliary heat with 40FK, FK4C, or FV4A Series fan coils.) When this identifier disappears, normal operation begins. The MODE control should be set to OFF ...

  • Carrier Access Thermidistat - page 4

    3. Use up and down buttons to move between F and C on large display. 4. Press SET TIME/TEMP button again to flash upper small display for selection of another option, or press END to exit configuration mode. Option 4—Fan (G) On With W This selection determines whether fan (G) output is to be ON or OFF when any W (furnace or strip heat) output is ...

  • Carrier Access Thermidistat - page 5

    Option 10—Dual Fuel Equipment All dual fuel installations must be equipped with a high pressure switch to turn off compressor under a high indoor coil pressure condition. The high pressure switch protects compressor and indoor coil from overpressure which would occur if a failure or wiring error resulted in the heat pump and furnace operating at ...

  • Carrier Access Thermidistat - page 6

    will be supplied, resulting in additional outputs being turned on. If room overheats, specified outputs will not turn off, guaranteeing a sufficiently warm leaving air temperature during defrost. Tempera- ture overshoot during defrost can occur, but is almost never noticeable because of the short duration of the defrost cycle (4 minutes typical, 10 ...

  • Carrier Access Thermidistat - page 7

    3. Use up and down buttons to move between OF and ON on large display. Factory default is OF. 4. Press SET TIME/TEMP button again to flash upper small display for selection of another option, or press END to exit configuration mode. Option 17—Enable Non-Programmable Operation This option converts the programmable Thermidistat Control to a non-pro ...

  • Carrier Access Thermidistat - page 8

    TO TEST COOLING AND DEHUMIDIFICATION: Press MODE button until COOL icon turns on. Cooling begins within 10 sec and remains on for 4 minutes. If system is 2-speed, low speed comes on for first 2 minutes, followed by high speed for second 2 minutes. At the end of 4-minute run, cooling stops, and MODE reverts back to OFF. At any time during 4-minute r ...

  • Carrier Access Thermidistat - page 9

    4. Auto and Fan Humidify The 2 choices of AUTO and FAN can be selected together. This provides both functions simultaneously. 5. Humidify Off The humidify function can be turned off completely. This does not require changing existing set points. To Select Humidification (Between NORMAL, FAN, AUTO, FAN and AUTO, or OFF) (See Table 4.) Press HUMIDITY ...

  • Carrier Access Thermidistat - page 10

    humidity removal is desired, this should be done, if possible. Fan coils have the capability of removing this off delay, furnaces do not. On FK or FV Fan Coils, set delay tap to 0/0. On standard fan coils, a jumper can be cut to disable off delay. Refer to fan coil Installation Instructions for details. If FAN is set for continuous operation (fan O ...

  • Carrier Access Thermidistat - page 11

    Vacation Dehumidification Normal Dehumidify, Cool to Dehumidify, and Dehumidify OFF, are all available in vacation mode, and selection of 1 of these can be different from that of occupied. Vacation dehumidification selection and set points are remembered the next time vacation is used. Cool to dehumidify operates slightly differently, allowing the ...

  • Carrier Access Thermidistat - page 12

    THERMIDIST A T CONTROL CONFIGURA TION RECORD Date Owner/Operator A) Hardware Configuration Switch A ____ AC/HP Select. (OFF = AC) Switch B ____ 1 or 2-Speed Compressor . (OFF = 1-Speed) Switch C ____ Smar t Recov ery . (OFF = Enable) Switch D ____ Installer T est. (OFF = Disab le) Thermidistat Model No. B) Mode Settings ____ Hold (On or Off) ____ M ...

メーカー Carrier Access カテゴリー Thermostat

Carrier Access Thermidistatのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- Thermidistatの取扱説明書
- Carrier Accessの製品カード
- パンフレット
- またはCarrier Access Thermidistatの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Carrier Access Thermidistatの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Carrier Access Thermidistatの取り付け説明書、サービスマニュアル、簡易説明書、またはCarrier Access Thermidistatのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Carrier Access Thermidistatの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Carrier Access Thermidistatデバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがCarrier Access Thermidistatを使用するのを助ける技術的文書のことです。説明書は通常、全てのCarrier Access Thermidistatユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Carrier Accessの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Carrier Access Thermidistatの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははCarrier Access Thermidistatの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Carrier Access Thermidistatに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Carrier Access Thermidistatデバイスの基本機能を使うにあたってのヒント。 Carrier Access Thermidistatのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Carrier Access Thermidistatに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるCarrier Access Thermidistatのメーカー/サービスへの連絡先に関する情報。

Carrier Access Thermidistatについてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもCarrier Access Thermidistatの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがCarrier Access Thermidistatで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)