日本語 dropdown-ico

Wells WM-TR IIの取扱説明書

18ページ 0.49 mb
ダウンロード

ページに移動 of 18

Summary
  • Wells WM-TR II - page 1

    IMPORTANT: DO NOT DI SCARD THIS MANUAL This manual is considered to be part of the appli ance and is to be given to the OWNER or MANAGER of the restaurant, or to the pers on responsible for TRAI NING OPERATORS of this appliance. Additional manuals a re available fro m your WELLS DEALER. THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING O ...

  • Wells WM-TR II - page 2

    Unless otherwise specified, all commercial cooking equip- ment manufactured by WELLS MFG. CO. is warranted against defects in materials and workmanship for a period of one year from the date of original installation or 18 months from the date of shipment from our factory, whichever comes first, and is for the benefit of the original purchaser only. ...

  • Wells WM-TR II - page 3

    W A R R A N T Y x i S P E C I F I C A T I O N S 1 FEATURES & OPERATING CONTROLS 2 PRECAUTIONS & GENERAL INFORMATION 4 AGENCY LISTING INFORMATION 4 I N S T A L L A T I O N 5 O P E R A T I O N 9 CLEANING INSTRUCTIONS 10 TROUBLESHOOTING SUGGESTIONS 12 PARTS & SERVICE 13 CUSTOMER SERVICE DATA 13 Thank you for purchasing this Wells Manufactu ...

  • Wells WM-TR II - page 4

    FEATURES & OPERATING CONTROLS 2 ITEM DESCRIPTION NOTES 1 HEATER SWITCH Controls power to water heater, satellite heater a nd sa tellite fill 2 POWER LIGHT Indicates main power available 3 REFILL LIGHT Indicates satellite is being refilled from the main tank 4 HEAT LIGHT Indicates heater eleme nt is energi zed and water is heating 5 FLOW NOZZLE ...

  • Wells WM-TR II - page 5

    FEATURES & OPERATING CONTROLS (continued) Fig. 2 Features & Operating Contro ls - Water Max II™ 5 Gallon Satellite 3 ITEM DESCRIPTION NOTES S1 COVER Forms fill funnel, allows access to tan k for se rvice S2 COVER HOLDING CLIPS Retains cover in place S3 WATER LEVEL SENSOR Maintains wat er level in tank S4 DISPENSE FAUCET Dispense hot water ...

  • Wells WM-TR II - page 6

    WARNING: Electric Shock hazard All servicing requiring access to non-insulated electrical components must be performed by a factory authorized technician. DO NOT open any access panel which requires the use of tools. Failure to follow this warning can result in severe electrical shock. CAUTION: Risk of Damage DO NOT connect or energize this applian ...

  • Wells WM-TR II - page 7

    UNPACKING & INSPECTION Carefully remove the appliance from the carton. Remove all prote c tive plastic film, packing materials and acce ssories from the appliance before connecting electrical powe r or otherwise performing any installation procedure. Carefully read all instructions in this manual an d the Installation Instruction Sheet packed w ...

  • Wells WM-TR II - page 8

    INST ALLA TION (continued) PLUMBING LINE CONNECTION If power has been run to the dispenser, verify that the circuit breaker is turned OFF , and that the POWER SWITCH is in the OFF [O] position. Water-Max II™ must be connected to a potable water supply. Connect to a cold water line only. Connecting to a hot water line will damag e the inlet water ...

  • Wells WM-TR II - page 9

    INST ALLA TION (continued) ELECTRICAL INSTALLATION NOTICE: A DEDICATED CIRCUIT OF AT LEAST 40 AMPS IS REQUIRED. WIRING AND CONNECTIONS MUST BE INSTALLED AND MAINTAINED IN COMPLIANCE WITH FEDERAL, STATE, AND LOCAL ORDINANCES. The dispenser is factory configured for ei ther 208 volts or 240 volts. The voltage configuration is NOT field convertible. D ...

  • Wells WM-TR II - page 10

    INSTALLATION START-UP AND CHECKOUT Before turning on power or wa ter to Water-Max II™, verify: a. Unit is level, with all legs touching the counter b. Water and electrical connection s prope rly made c. HEATER SWITCH is OFF ( O ) d. Removable SATELLITE is NOT installed on Wate r-Max II™ at this time Only after steps a. through d. are satisfacto ...

  • Wells WM-TR II - page 11

    OPERA TION Water-Max II™ is used to dispense hot water for food preparation. The SATELLITE TANK stores five gallons of hot water for immediate use. INSTALLING OR REMO VING SATELLITE TANK Drain all water from SATELLITE before attempting to remove from u nit. Press the HEATER SWITCH to OFF ( O ) Be sure the COVER is properly installed on the SATELL ...

  • Wells WM-TR II - page 12

    CLEANING INSTRUCTIONS DAILY CLEANING PRECAUTIONS: Press HEATER SWITCH to OFF ( O ). Drain all water from SATELLITE. Remove satellite from Water-Max II™. FREQUENCY: Minimum - Daily, or as required TOOLS: Soft Cloth, Soft Bristle Brush Wipe down the exterior of the Water-MaxII™ with a soft damp cloth. Use a soft bristle brush to remove any calciu ...

  • Wells WM-TR II - page 13

    PERIODIC CLEANING - Delime Internal Heating Tank PRECAUTIONS: Water in main tank is EXTREMELY HOT (around 200ºF) FREQUENCY: Wee kly TOOLS: Wells Delimi ng Solution Bottle (p/n 85377) Plastic Scouring Pad Clean Cloth or Sponge Kay Orange Neutralizer and Delimer (K ay p/n 55905 ) Begin with the HEATER SWITCH ON , MAIN TANK full and at temperature (i ...

  • Wells WM-TR II - page 14

    CONTINUED FROM PAGE 11 After 30 minutes, flush solution fr om main tank (HEATER SWITCH OFF ): Insert drain hose into a suitable container. Open d rain hose clamp and drain valve. Allow all solution to drain. Close drain valve. Reconnect main water supply and allow main ta nk to fill (approximately 4 minutes). After tank is filled, disconnect main w ...

  • Wells WM-TR II - page 15

    PERIODIC CLEANING - Satellite Tank PRECAUTIONS: Water in satellite is EXTREMELY HOT (around 200ºF) Satellite full of water is HEAVY (62 lbs.) Drain water from SATELLITE before moving. FREQUENCY: Wee kly TOOLS: Plastic Scouring Pad Clean Cloth or Sponge Kay Orange Neutralizer and Delimer (K ay p/n 55905 ) Press HEATER SWITCH to OFF [ O ]. Drain SAT ...

  • Wells WM-TR II - page 16

    TROUBLESHOOTING SUGGESTIONS There are no user serviceable com pon ents in t he appliance. In all cases of damage or compo nent malfunction, contact your Authorized Wells Servi ce Agency for repairs. 14 SYMPTOM POSSIBLE CAUSE SUGGESTED REMEDY Power light not lit Circuit breaker off or tripped Reset circuit breaker Satellite does not fill Satellite n ...

  • Wells WM-TR II - page 17

    D E S C R I P T I O N S E R V I C E P A R T N O . TANK, 5 GALLON, MODEL DT-5 22658 DEL IMIN G SOLU TION BOTT LE WITH QUICK DISCONNECT FITTING 22800 DEL IMIN G SOLU TION BOTT LE (ONLY) 22801 PITCHER, PLASTIC, 4 QT. 8450 1 ASSEMBLY (STRAINER / PRESSURE REGULATOR WITH GAUGE / WATER HAMMER ARRESTOR) 84868 PRESSURE REGULATOR (ONLY ) 8541-401 PRESSURE GA ...

  • Wells WM-TR II - page 18

    PRINTED IN UNITED STATES OF AMERIC A ...

メーカー Wells カテゴリー Water Dispenser

Wells WM-TR IIのメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- WM-TR IIの取扱説明書
- Wellsの製品カード
- パンフレット
- またはWells WM-TR IIの消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Wells WM-TR IIの取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Wells WM-TR IIの取り付け説明書、サービスマニュアル、簡易説明書、またはWells WM-TR IIのユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Wells WM-TR IIの製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Wells WM-TR IIデバイスの取扱説明書はどのようなものですか？
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがWells WM-TR IIを使用するのを助ける技術的文書のことです。説明書は通常、全てのWells WM-TR IIユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Wellsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Wells WM-TR IIの説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははWells WM-TR IIの目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Wells WM-TR IIに関してこのドキュメントで見つけることができる全てのヒントの目次
3. Wells WM-TR IIデバイスの基本機能を使うにあたってのヒント。 Wells WM-TR IIのユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Wells WM-TR IIに関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるWells WM-TR IIのメーカー/サービスへの連絡先に関する情報。

Wells WM-TR IIについてご質問がありますか？

次のフォームを使用してください

見つけた説明書を読んでもWells WM-TR IIの問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWells WM-TR IIで同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

Captcha
新しい画像

コメント (0)