Directed Electronics 6000の取扱説明書

20ページ 0.08 mb
ダウンロード

ページに移動 of 20

Summary
  • Directed Electronics 6000 - page 1

    This de vice complies with par t 15 of FCC rules. Operation is subject to the f ollowing two conditions: (1) This de vice ma y not cause harmful interference , and (2) This de vice m ust accept any interf erence receiv ed, including inter- f erence that ma y cause undesired operation. CA UTION: Changes or modifications not e xpressly approv ed b y ...

  • Directed Electronics 6000 - page 2

    2 © 1996 Directed Electronics, Inc. T able of C ontents System Maintenance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Y our W arranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 What Is Included . . . . . . . . . . . . . . ...

  • Directed Electronics 6000 - page 3

    3 © 1996 Directed Electronics, Inc. What is included ■ The control module ■ A pair of two-b utton transmitters ■ A Stinger ® DoubleGuard ® dual-output shock sensor ■ The Re venger ® Soft Chir p ® six-tone programmab le siren ■ The red Status LED indicator light ■ A push-button V alet ® s witch ■ Y our warranty card ■ F ailSafe ...

  • Directed Electronics 6000 - page 4

    4 © 1996 Directed Electronics, Inc. T ransmitter Channels Channel I The arm/disar m and panic functions, are usually controlled b y Button I. Channel II The Silent Mode ™ /trunk release function, is usually controlled by Button II. Silent Mode ™ and Remote V alet ® work by pressing b utton II for less than one second. T r unk release requires ...

  • Directed Electronics 6000 - page 5

    5 © 1996 Directed Electronics, Inc. Using Y our S ystem Arming Y ou can tur n on, or arm , the system b y pressing button I of y our transmitter f or one second. When the system arms, y ou will hear a short siren sound, or chirp , and see the parking lights flash once. If the v ehicle’ s power door loc ks are controlled by the system, the doors ...

  • Directed Electronics 6000 - page 6

    6 © 1996 Directed Electronics, Inc. to disar m the system with y our transmitter if you inadv er tently open the door while the system is ar med, while still pro viding instant response (e v en if the door is immediately closed). • T ur ning on the ignition ke y will tr ip the same two-stage response as opening a door . • The optional starter ...

  • Directed Electronics 6000 - page 7

    7 © 1996 Directed Electronics, Inc. to check the v ehicle visually . The tr igger will stop , but the v ehicle will remain protected. T o disar m with the transmitter during a trigger , press Button I on your tr ansmitter . The siren will stop sounding. Ne xt press Button I once more and the system will chir p four or fiv e times (repor ting the t ...

  • Directed Electronics 6000 - page 8

    8 © 1996 Directed Electronics, Inc. V alet ® Mode Y ou can prev ent your system from automatically arming and tr iggering by using V alet ® Mode. This is ver y useful when w ashing the vehicle or having it ser viced. In V alet ® Mode, the system will not arm, ev en with the transmitter , but all con venience functions (door loc ks, trunk releas ...

  • Directed Electronics 6000 - page 9

    9 © 1996 Directed Electronics, Inc. trigger the system while it is being bypassed, the 60-minute b ypass period will star t ov er . This ensures that a sensor that continuously triggers will remain bypassed. Doors are cov ered by NPC ™ diff erently: If the alarm is tr iggered b y an open door f or three full cycles (one and one half minutes), th ...

  • Directed Electronics 6000 - page 10

    10 © 1996 Directed Electronics, Inc. Diagnostics The microprocessor at the hear t of your system is constantly monitoring all of the s witches and sensors connected to it. It detects any f aulty switches and sensors and pre vents them from disab ling the entire system. The micro- processor will also record and repor t any triggers that occurred du ...

  • Directed Electronics 6000 - page 11

    11 © 1996 Directed Electronics, Inc. Table of Zones The zone number is the number of LED flashes used by the system to iden- tify that input. The standard input assignments are listed below , along with spaces to write in any optional sensors or s witches you ha ve had installed. NOTE: If the Warn A way ® response is triggered, the LED will not r ...

  • Directed Electronics 6000 - page 12

    12 © 1996 Directed Electronics, Inc. C ode Hopping ™ Explained The receiver and tr ansmitters each use a mathematical formula called an algorithm to change their code each time the transmitter is used. This tech- nology has been de v eloped to increase the security of the unit. The control unit knows what the ne xt codes should be. This helps to ...

  • Directed Electronics 6000 - page 13

    13 © 1996 Directed Electronics, Inc. NOTE: If the door is open when the ignition is turned on, the doors will not lock. • P anic mode enabled /disab led with the ignition on. (Some states hav e laws against siren capability in a moving v ehicle). • A utomatic Engine Disable (AED) on or off . The pur pose of the feature is to pro- tect the vehi ...

  • Directed Electronics 6000 - page 14

    14 © 1996 Directed Electronics, Inc. V ehicle R ecovery S ystem (V RS ® )* The optional V ehicle Recovery System feature is designed to ensure that an y unauthorized user of your v ehicle (ev en if using your ke ys and remote con- trol) will not be able to permanently separate you from y our vehicle . The VRS ® f eature cannot pre vent a carjac ...

  • Directed Electronics 6000 - page 15

    15 © 1996 Directed Electronics, Arming the VR S ® T o ar m the VRS ® , push the b utton once. This can be done before driving or while driving the vehicle. Once the system is ar med, it will go into its triggered sequence (see below) if an y door is opened and closed. If you are f orced from the v ehicle the system will trigger as the door will ...

  • Directed Electronics 6000 - page 16

    F rom this point on, when the ignition k e y is turned off, the VRS ® will immediately turn on the F ailSafe ® starter kill. This will pre- vent the v ehicle from being restar ted, thus immobilizing it at that spot. Three minutes after the constant siren output begins, the flashing parking lights and the siren will stop. The star ter kill will re ...

  • Directed Electronics 6000 - page 17

    17 © 1996 Directed Electronics, Inc. Gloss ary of T erms Control Unit The “brain” of y our system. Usually hidden under neath the dash area of the vehicle . It houses the microprocessor which monitors y our vehi- cle and controls all of the alarm's functions. FailSaf e ® Starter Kill An automatic switch controlled b y the secur ity syste ...

  • Directed Electronics 6000 - page 18

    18 © 1996 Directed Electronics, Inc. Security & C onvenience Expansions Here we ha v e listed only some of the many e xpansion options av ailable . Please consult your dealer f or a complete explanation of all the options a vail- able to y ou. Field Disturbance Sensor : An invisible dome of co verage is estab lished by the 508T “radar” sen ...

  • Directed Electronics 6000 - page 19

    19 QU ICK RE FE RE NCE OPE RA TING C ARD : Arming ▼ Y ou can turn on, or ar m, the system b y pressing Button I of your transmitter f or one second. When the system arms, you will hear a shor t chir p, and see the parking lights flash once . Arming While Driving ▼ Press Button I on y our transmitter while the v ehicle is r unning. The system wi ...

  • Directed Electronics 6000 - page 20

    S ystem Ref er ence Car d Directed Electronics, Inc. 2560 Progress Street Vista, CA 92083-8491 © Copyright 1990, 1996 Directed Electronics, Inc. - All rights reserved G437 12/96 The company behind DEI ® is Directed Electr onics, Inc. Since its inception, the company known as Directed Electronics, Inc. (DEI ® ) has had one pur pose - to br ing th ...

メーカー Directed Electronics カテゴリー Stud Sensor

Directed Electronics 6000のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 6000の取扱説明書
- Directed Electronicsの製品カード
- パンフレット
- またはDirected Electronics 6000の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Directed Electronics 6000の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Directed Electronics 6000の取り付け説明書、サービスマニュアル、簡易説明書、またはDirected Electronics 6000のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Directed Electronics 6000の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Directed Electronics 6000デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがDirected Electronics 6000を使用するのを助ける技術的文書のことです。説明書は通常、全てのDirected Electronics 6000ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Directed Electronicsの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Directed Electronics 6000の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははDirected Electronics 6000の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Directed Electronics 6000に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Directed Electronics 6000デバイスの基本機能を使うにあたってのヒント。 Directed Electronics 6000のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Directed Electronics 6000に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるDirected Electronics 6000のメーカー/サービスへの連絡先に関する情報。

Directed Electronics 6000についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもDirected Electronics 6000の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがDirected Electronics 6000で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)