English dropdown-ico

Manual CFM Corporation ODSHR42

24 pages 1.43 mb
Download

Go to site of 24

Summary
  • CFM Corporation ODSHR42 - page 1

    1384 SHR cover 5/27/99 djt Homeowner's Installation and Operating Manual DO NOT DISCARD THIS MANUAL: Retain for future use. 20002264 1/08 Rev . 18 Model: ODSHR42 Underwriter's Laboratories Report No. MH20546 ODSHR Series Outdoor W oodburning Fireplace ...

  • CFM Corporation ODSHR42 - page 2

    2 ODSHR Outdoor W oodbur ning Fireplace 20002264 PLEASE READ THIS MANUAL BEFORE INST ALLING AND USING FIREPLACE. IMPORT ANT : Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty . Safety Information . . . . . . . . . . . . . ...

  • CFM Corporation ODSHR42 - page 3

    3 ODSH R Outdoor W oodbur ning Fireplace 20002264 Safety Information Description The ODSHR Series (Super Hearth) fireplace is a clean- faced, solid fuel, woodburning fireplace. Precautions CFM Corporation fireplaces and component parts have been highly tested and will operate safely when installed in accordance with instructions provided in this ...

  • CFM Corporation ODSHR42 - page 4

    4 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Minimum Rough Opening Height 42" (1067 mm) 52  " (1327 mm) 44" (1 1 18 mm)  "  "  " (610 mm)  " (189 mm) 13  " Dia. Minimum Rough Opening Width 53  " (1365 mm) Minimum Rough Opening Depth 6 ...

  • CFM Corporation ODSHR42 - page 5

    5 ODSH R Outdoor W oodbur ning Fireplace 20002264 FP554A SH Series 1/28/99 djt Chase Installation Insulation methods shown are optional for cold climate, not a requirement for unit operation or exterior installation . FP554A Fig. 4 Fireplace and chase parts identification. T ermination Cap Storm Collar Pan Flashing Batt Insulation (cut out around ...

  • CFM Corporation ODSHR42 - page 6

    6 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Chimney Requirements - Offset Installations 0 0 0 0 0 3" 1 1" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 1 1 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " ...

  • CFM Corporation ODSHR42 - page 7

    7 ODSH R Outdoor W oodbur ning Fireplace 20002264 Planning Information The T en Foot Rule Major U.S. building codes specify a minimum chimney height above the roof top. The “T en Foot Rule” is a fire safety rule and not a draft rule. T o ensure proper draft, it is recommended that you always meet or exceed the “T en Foot Rule,” especially ...

  • CFM Corporation ODSHR42 - page 8

    8 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Chimney Supports The chimney system is supported by the fireplace for vertical chimney heights less than 30' (9 m) above the hearth. Chimney supports are required if the vertical height exceeds 30' (9 m) with 1 1CF chimneys. Locate chimney supports at ceiling holes or other structural fra ...

  • CFM Corporation ODSHR42 - page 9

    9 ODSH R Outdoor W oodbur ning Fireplace 20002264 Locate center point of the chimney on ceiling as though a straight up chimney arrangement is to be used. Mea- sure your offset dimension from straight up chimney center point on ceiling. Ceiling Chimney Hole/ Possible Obstructions The size of the hole in ceiling will vary with the angle at which the ...

  • CFM Corporation ODSHR42 - page 10

    10 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Cutting the Hole Cover fireplace collar opening and cut proper sized chimney hole in chimney . Framing the Ceiling Hole Frame the ceiling chimney hole as shown in Figure 13. It is good practice to use framing lumber that is the same size as the ceiling joists; this is a requirement at attic level. ...

  • CFM Corporation ODSHR42 - page 11

    1 1 ODSH R Outdoor W oodbur ning Fireplace 20002264 Positioning, Safety Strips, Securing the Fireplace Slide fireplace into position. Lift the fireplace front slightly and slide the metal safety strips under front bottom edge about 1 ¹⁄₂ " (38 mm), allowing the remainder to extend in front of firebox. Overlap strips at least 1/2" ...

  • CFM Corporation ODSHR42 - page 12

    12 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Installing the Chimney System Start by attaching the first chimney section to the collar on top of the fireplace. Install the pipe as pictured in Figure 17. When you get a good lock, you will hear the pipe clearly snap together . Once sections are snap-locked in place, it is extremely difficult ...

  • CFM Corporation ODSHR42 - page 13

    13 ODSH R Outdoor W oodbur ning Fireplace 20002264 Firestop spacers are not available for , nor are they required on, vertical walls. The CFM Corporation chimney components have been tested and approved with the area where the outer pipe slides through the firestop spacer sealed with a noncombustible caulk if desired, or left completely open with ...

  • CFM Corporation ODSHR42 - page 14

    14 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Finish W all Finish the wall with material of your choice. Do not install a combustible mantel shelf less than 12" (305 mm) from the top of the fireplace opening. Do not install a mantel face plate less than 6" (154 mm) from top of fireplace opening. (Fig. 24) If a combus- tible materia ...

  • CFM Corporation ODSHR42 - page 15

    15 ODSH R Outdoor W oodbur ning Fireplace 20002264 FP531 surround flush with finish wall 12/20/01 djt 12" (305mm) Max. 12" (305mm) min. * 1 ¹⁄₂ " 12" (305mm) Max. 12" (305mm) min. 1 ¹⁄₂ " 6" (159mm) Min. 1" Mantel Clearance - No Noncombustible Facing Material Combustible Mantel and T rim Finished W ...

  • CFM Corporation ODSHR42 - page 16

    16 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Side W all Protection Adjacent combustible side walls that are within dimen- sions shown in Figure 25 of fireplace opening must be protected with CFM Corporation W all Shield Model SP40 or a specifically built wall shield described in Figure 26. The special wall shield design described in Figure ...

  • CFM Corporation ODSHR42 - page 17

    17 ODSH R Outdoor W oodbur ning Fireplace 20002264 COMMON MA TERIALS AND F ACTORS MA TERIAL K* R MINIMUM THICKNESS EH2416 Common Brick 0.458 5.0 1.09 0.50 in.** 0.10 5.46 in.** (CFM Corporation) R V alue is for  inch. * Units of K = BTU/SQ FT/HR/˚F/IN ** Thickness of Listed Material FP533ADD Addendum 6/1/99 djt 8/4/99 changed .2 to .1 one ...

  • CFM Corporation ODSHR42 - page 18

    18 ODSHR Outdoor W oodb ur ning Fireplace 20002264 Installing Line for Gas Logs CFM Corporation fireplaces are designed to accept a 1/2 inch gas line for installation of an approved gas ap- pliance. (CFM Corporation manufactures a wide variety of gas logs for use in Majestic Fireplaces units.) Be sure to have the appliance installed in accordance ...

  • CFM Corporation ODSHR42 - page 19

    19 ODSH R Outdoor W oodbur ning Fireplace 20002264 * T wo (2) required ** Four (4) required CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. 2264pts odshr replacement parts 1/5/00 djt 1 2 5 7 6 4 3 12 1 1 8 10 9a,b 13 Ref. Description Pa ...

  • CFM Corporation ODSHR42 - page 20

    20 ODSHR Outdoor W oodb ur ning Fireplace 20002264 The following accessories for this appliance are available from your local CFM Corporation products distributor . Should you need additional information beyond what your distributor can furnish, contact: CFM Corporation, 2695 Meadowvale Blvd., Mississauga, Ontario, Canada L5N 8A3, Attn: T echnical ...

  • CFM Corporation ODSHR42 - page 21

    21 ODSH R Outdoor W oodbur ning Fireplace 20002264 Accessory Description Model No. Extended Round T op Chimney Sections Chimney Elbows T op Housing with Upper Baffle Chimney Reducer Kit Attic Insulation Shield For use with T ype "1 1CF" Chimney Sys- tems. Used to terminate chimney at top of chase. Adapter kit included. Flashing not inclu ...

  • CFM Corporation ODSHR42 - page 22

    22 ODSHR Outdoor W oodb ur ning Fireplace 20002264 ...

  • CFM Corporation ODSHR42 - page 23

    23 ODSH R Outdoor W oodbur ning Fireplace 20002264 LIMITED W ARRANTY & 30 YEAR PROTECTION PLAN For Majestic Fireplaces PRE-ENGINEERED Fireplace Systems CFM Corporation warrants its Pre-Engineered Fireplace (“Fireplace”) and the CFM Corporation-supplied firegrate, glass doors, outside air system, fan motor , and liners to be free from defec ...

  • CFM Corporation ODSHR42 - page 24

    2695 Meadowvale Blvd. • Mississauga, Ontario, Canada L5N 8A3 800-668-5323 • www .cfmcorp.com CFM Corporation ...

Manufacturer CFM Corporation Category Outdoor Fireplace

Documents that we receive from a manufacturer of a CFM Corporation ODSHR42 can be divided into several groups. They are, among others:
- CFM Corporation technical drawings
- ODSHR42 manuals
- CFM Corporation product data sheets
- information booklets
- or energy labels CFM Corporation ODSHR42
All of them are important, but the most important information from the point of view of use of the device are in the user manual CFM Corporation ODSHR42.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals CFM Corporation ODSHR42, service manual, brief instructions and user manuals CFM Corporation ODSHR42. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product CFM Corporation ODSHR42.

Similar manuals

A complete manual for the device CFM Corporation ODSHR42, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use CFM Corporation ODSHR42 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of CFM Corporation ODSHR42.

A complete CFM Corporation manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual CFM Corporation ODSHR42 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the CFM Corporation ODSHR42, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the CFM Corporation ODSHR42, that we can find in the current document
3. Tips how to use the basic functions of the device CFM Corporation ODSHR42 - which should help us in our first steps of using CFM Corporation ODSHR42
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with CFM Corporation ODSHR42
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of CFM Corporation ODSHR42 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning CFM Corporation ODSHR42?

Use the form below

If you did not solve your problem by using a manual CFM Corporation ODSHR42, ask a question using the form below. If a user had a similar problem with CFM Corporation ODSHR42 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)