English dropdown-ico

Manual CFM Corporation SHR42A

24 pages 1.66 mb
Download

Go to site of 24

Summary
  • CFM Corporation SHR42A - page 1

    1384 SHR cov er 5/27/99 djt SHR Series W oodburning Fireplace For Models: SHR36 SHR42A SHR48 SHR52 Underwriter's Laboratories Report No. MH6018 DO NOT DISCARD THIS MANUAL: Retain for future use. 20001384 4/07 Rev . 19 Homeowner's Installation and Operating Manual ...

  • CFM Corporation SHR42A - page 2

    2 SHR Series W oodbur ning Fireplace 20001384 Safety Information PLEASE READ THIS MANUAL BEFORE INST ALLING AND USING FIREPLACE. IMPORT ANT : Read all instructions and warnings carefully before starting installation. Failure to follow these instructions may result in a possible fire hazard and will void the warranty . Description The SHR Series ? ...

  • CFM Corporation SHR42A - page 3

    3 SH R Series W oodb urning Fireplaces 20001384 Rough Opening Height 42" (1067mm) 52  " (1327mm) 48  " (1222mm)  "  " 28  " (724mm)  " (189mm) 13  " Dia. (340mm) Rough Opening Width 53  " Rough Opening Depth 65  " ...

  • CFM Corporation SHR42A - page 4

    4 SHR Series W oodbur ning Fireplace 20001384  " (724mm) 7  " (197mm ) 48" (1219mm) 58  " (1480mm) 48  " (1232mm)  "  "  " (189mm) 13  " Dia. (340mm) Rough Opening Width 59  " Rough Opening Height Rough Open ...

  • CFM Corporation SHR42A - page 5

    5 SH R Series W oodb urning Fireplaces 20001384 FP554A SH Series  1/28/99 djt Chase Installation Insulation methods shown are optional for cold climate, not a requirement for unit operation. FP554A Fig. 5 Fireplace and chase parts identification. (SHR48 shown) T ermination Cap Storm Collar Pan Flashing Batt Insulation (cut out around firest ...

  • CFM Corporation SHR42A - page 6

    6 SHR Series W oodbur ning Fireplace 20001384 Chimney Requirements - Offset Installations 0 0 0 0 0 3" 1 1" 1 0 0 0 0 8 ¹⁄₄ " 20" 0 1 0 0 0 1 1 ¹⁄₄ " 25 ¹⁄₄ " 2 0 0 0 0 13 ¹⁄₂ " 29 ¹⁄₄ " 1 1 0 0 0 16 ¹⁄₂ " 34 ¹⁄₄ " 0 0 1 0 0 20 ¹⁄₄ " 40 ³⁄₄ " 2 ...

  • CFM Corporation SHR42A - page 7

    7 SH R Series W oodb urning Fireplaces 20001384 Planning Information The T en Foot Rule Major U.S. building codes specify a minimum chimney height above the roof top. The “T en Foot Rule” is a fire safety rule and not a draft rule. T o ensure proper draft, it is recommended that you always meet or exceed the “T en Foot Rule,” especially wh ...

  • CFM Corporation SHR42A - page 8

    8 SHR Series W oodbur ning Fireplace 20001384 Installation Chimney Supports The chimney system is supported by the fireplace for vertical chimney heights less than 30 feet above the hearth. Chimney supports are required if the vertical height exceeds 30 feet with 1 1CF chimneys. Locate chimney supports at ceiling holes or other structural framing ...

  • CFM Corporation SHR42A - page 9

    9 SH R Series W oodb urning Fireplaces 20001384 Framing Framing can be constructed before or after the fireplace is set in place, however , most installers build the frame before setting the fireplace. Frame fireplace with 2 x 4 lumber or heavier materials. Refer to framing dimensions in Figures 1 - 4 for basic fireplace specifications. NOTE: ...

  • CFM Corporation SHR42A - page 10

    10 SHR Series W oodbur ning Fireplace 20001384 FP556SHR Fig. 13 Locate centerline of chimney with plumb line. FP556SHR SHR LOCA TE CENTER LINE 5/11/99 djt Chimney Centerline Actual Centerpoint Plumb Line Plumb Bob Imaginary Centerpoint 1 1 ¹⁄₈ " (283 mm) FP 548b SHR 5/1 1/99 djt Angle of Chimney at Ceiling Size of Chimney V ertic ...

  • CFM Corporation SHR42A - page 11

    1 1 SH R Series W oodb urning Fireplaces 20001384 The inside dimension of the frame must be the same as the hole size selected from Figure 1 1 in order to provide the required 2 inches of air space between the outside diameter of the chimney and the edges of the framed ceiling hole. Positioning, Safety Strips, Securing the Fireplace Slide fireplac ...

  • CFM Corporation SHR42A - page 12

    12 SHR Series W oodbur ning Fireplace 20001384 Installing the Chimney System Start by attaching the first chimney section to the collar on top of the fireplace. Install the pipe as pictured in Figure 19. When you get a good lock, you will hear the pipe clearly snap together . Once sections are snap-locked in place, it is extremely difficult to g ...

  • CFM Corporation SHR42A - page 13

    13 SH R Series W oodb urning Fireplaces 20001384 Attic Installation Ceiling Installation Fig. 21 Installing firestop spacer . FP285 IWF285 mbuf 5/25/96   Nails (4) Firestop Spacer Joist Joist Firestop Spacer Nails (4) Flange Down Into Hole Flange Up Into Hole NOTE: If the attic insulation shield is used, the firestop is not required i ...

  • CFM Corporation SHR42A - page 14

    14 SHR Series W oodbur ning Fireplace 20001384 Cut and Frame Roof Hole Size of roof hole varies with the type of chimney termi- nation installed. Refer to installation instructions pro- vided with the chimney termination to find correct size roof hole. There must be a 2" (51 mm) air space between out- ermost portion of chimney sections and an ...

  • CFM Corporation SHR42A - page 15

    15 SH R Series W oodb urning Fireplaces 20001384 FP1166 surround flush with finished wall 12/20/01 djt Stud 2 x 4 Header Ledge Bracket Surround Must be Sealed with Noncombustible Material Noncombus- tible Decorative Facing Finished W all FP1 166 Fig. 26 Fireplace surround flush with finished wall. FP1277 SHR52 drywall finish 1/30/03 djt Finish ...

  • CFM Corporation SHR42A - page 16

    16 SHR Series W oodbur ning Fireplace 20001384 FP1167 facing flush with finished wall 12/20/01 djt Finished W all Stud Noncombustible Decorative Fac- ing Must be Sealed with Noncombustible Material Surround 2 x 4 Finished Header Covered W all Ledge Bracket FP1 167 Fig. 27 Facing on fireplace surround flush with finished wall. FP1168 finishing fr ...

  • CFM Corporation SHR42A - page 17

    17 SH R Series W oodb urning Fireplaces 20001384 Side W all Protection Adjacent combustible side walls that are within dimen- sions shown in Figure 30 of fireplace opening must be protected with W all Shield Model SP40 or a specifically built wall shield described in Figure 29. The special wall shield design described in Figure 27 is an alternate ...

  • CFM Corporation SHR42A - page 18

    18 SHR Series W oodbur ning Fireplace 20001384 FP532SHR Fig. 32 Combustible side wall protection and hearth extension dimensions. Minimum W all Clearances WITH Noncombustible Surround Facing WITHOUT Noncombustible Surround Facing Minimum Hearth Extension Dimensions (for On-Site Construction) G H G J Seal cracks between the fireplace and hearth exte ...

  • CFM Corporation SHR42A - page 19

    19 SH R Series W oodb urning Fireplaces 20001384 removed from gas line tube to repack space around the pipe. Material should be inserted from outside of the fireplace and packed tightly to totally seal between the pipe and tube. NOTE: Gas pipe should not come in contact with any wood structures until it has reached a point at least one (1) inch aw ...

  • CFM Corporation SHR42A - page 20

    20 SHR Series W oodbur ning Fireplace 20001384 1384 pts replacement parts 5/27/99 djt 7/14/99 removed clips,added push nut 1 2 3 4 5 6 7 8 a b c 9 10 1 1 d 12 13 CFM Corporation reserves the right to make changes in design, materials, specifications, prices and discontinue colors and products at any time, without notice. SHR36/42A/48/52 W oodburni ...

  • CFM Corporation SHR42A - page 21

    21 SH R Series W oodb urning Fireplaces 20001384 Description Designed to enclose the fireplace opening with glass doors allowing the fire to remain visible. Available in Polished, Brushed Brass, Black and Pewter Provides outside air for fuel conbustion in the firebox. This accessory must be installed before fireplace is installed. Located on th ...

  • CFM Corporation SHR42A - page 22

    22 SHR Series W oodbur ning Fireplace 20001384 Accessory Description Model No. Contemporary Flashing Contemporary Chase T op T ermina- tion Contemporary Round T op T ermina - tion Extended Round T op Chimney Sections Chimney Elbows T op Housing with Upper Baffle Attic Insulation Shield Required for contemporary top termination on the roof to preve ...

  • CFM Corporation SHR42A - page 23

    23 SH R Series W oodb urning Fireplaces 20001384 LIMITED W ARRANTY & 30 YEAR PROTECTION PLAN For MAJESTIC FIREPLACES ® PRE-ENGINEERED Fireplace Systems CFM Corporation warrants its MAJESTIC FIREPLACES® Pre- Engineered Fireplace (“Fireplace”) and the CFM Corporation supplied firegrate, glass doors, outside air system, fan motor , and line ...

  • CFM Corporation SHR42A - page 24

    © CFM Corporation 410 Admiral Blvd. • Mississauga, Ontario, Canada L5T 2N6 800-668-5323 • www .cfmcorp.com CFM Corporation ...

Manufacturer CFM Corporation Category Outdoor Fireplace

Documents that we receive from a manufacturer of a CFM Corporation SHR42A can be divided into several groups. They are, among others:
- CFM Corporation technical drawings
- SHR42A manuals
- CFM Corporation product data sheets
- information booklets
- or energy labels CFM Corporation SHR42A
All of them are important, but the most important information from the point of view of use of the device are in the user manual CFM Corporation SHR42A.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals CFM Corporation SHR42A, service manual, brief instructions and user manuals CFM Corporation SHR42A. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product CFM Corporation SHR42A.

Similar manuals

A complete manual for the device CFM Corporation SHR42A, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use CFM Corporation SHR42A by users. Manuals are usually written by a technical writer, but in a language understandable to all users of CFM Corporation SHR42A.

A complete CFM Corporation manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual CFM Corporation SHR42A - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the CFM Corporation SHR42A, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the CFM Corporation SHR42A, that we can find in the current document
3. Tips how to use the basic functions of the device CFM Corporation SHR42A - which should help us in our first steps of using CFM Corporation SHR42A
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with CFM Corporation SHR42A
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of CFM Corporation SHR42A in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning CFM Corporation SHR42A?

Use the form below

If you did not solve your problem by using a manual CFM Corporation SHR42A, ask a question using the form below. If a user had a similar problem with CFM Corporation SHR42A it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)