English dropdown-ico

Manual O'Neil 2TE

22 pages 0.18 mb
Download

Go to site of 22

Summary
  • O'Neil 2TE - page 1

    User's Guide MICROFLASH 2T e ...

  • O'Neil 2TE - page 2

    T ABLE OF C ONTENTS microFlash 2t e Printer: Top View .......... ...... 1 Using the Batter y: General Guidelines ........ 2 Charging the Battery ................ .......... ......... 2 Determining Battery Conditio n ........ ........... .. 2 Installing Paper ......... .......... ........ ........ ......... 3 Printing a Self-Test .......... ........ ...

  • O'Neil 2TE - page 3

    MICROFLASH 2T e PRINTER USER'S GUIDE 1 microFlash 2t e Printer: Top View Charge LED Pap e r / Pa pe r Cavity Data P ort Rol l er Self - T est Button Print Head Rel ea s e L e ve r RF P ower LED Power P ort Figure 1 Figure 2 ON/OFF Status LED Latch LEDs NOTE: When the cable plug is inserted into the P ower Po rt, the cable plug must lay hori zo ...

  • O'Neil 2TE - page 4

    MICROFLASH 2T e PRINTER USER'S GUIDE 2 Using the Battery: General Guidelines If the printer has not been used for a long period of time, it may be necessary to recharge the batte ry . For more information, see Chargi ng the Batt ery on page 2 . Charging the Battery If the battery is low when the printer “wakes up, ” the printer sounds thre ...

  • O'Neil 2TE - page 5

    MICROFLASH 2T e PRINTER USER'S GUIDE 3 Installing Paper 1. Insert a roll of paper with the end of the roll exiting from the bot tom of the pape r cavity (Figur e 3). 2. Open the print head by raising the green, print head release lever until it stops (Figure 4). 3. W ake up the printer by briefly pressing the gr een, self -test butto n (Figu r ...

  • O'Neil 2TE - page 6

    MICROFLASH 2T e PRINTER USER'S GUIDE 4 4. Feed the end of the paper under the rol ler . The paper automatically feeds under the roller and exits from the t op of the print he ad. V erify the paper exits straight. 5. Lower the green, print head release lever (Figure 6). 6. Fe ed the paper through the printer's cov er (Figure 7). 7 . Close ...

  • O'Neil 2TE - page 7

    MICROFLASH 2T e PRINTER USER'S GUIDE 5 Clearing Linerless Paper Jams A paper jam may occur if an O’Neil printer with linerless paper installed is left in a cold environment without being used for an extended period of time (such as overnig ht). Removing a Paper Jam 1. Open the print head by raising the print head release lever until it is fu ...

  • O'Neil 2TE - page 8

    MICROFLASH 2T e PRINTER USER'S GUIDE 6 Remo ve the Linerless Paper fr om the Print Head If the printer is going to be in a cold environment for a long period of time, remove the linerless paper from the print head. The paper can remain in the printer . Advance the P aper When the printer is turne d on, hold the paper and then advance the paper ...

  • O'Neil 2TE - page 9

    MICROFLASH 2T e PRINTER USER'S GUIDE 7 Using Prin ter Data Cables 1. Select the appropriate cable f or use with the host/ device you are using . 2. Insert the plug into the printer data port (Figur e 12). 3. Lead the cable thr ough the notch on the ou tside of the printer cover . 4. With the cable exiting t he fr ont of the print er , close an ...

  • O'Neil 2TE - page 10

    MICROFLASH 2T e PRINTER USER'S GUIDE 8 Note: When closing the prin ter , be ca utious of the cable that is exiting to prev ent pinching of the cable. Remove the cable when the pr inter is not in use. Figure 13 ...

  • O'Neil 2TE - page 11

    MICROFLASH 2T e PRINTER USER'S GUIDE 9 Using Blueto oth Radio printers are configured with def ault factory settings. T o determine your printer's radio configuration, print a self -test. (F or more information, see Printing a Self - T est on page 4 . ) If you have multiple printers, configure th em specifically for use in your envir onme ...

  • O'Neil 2TE - page 12

    MICROFLASH 2T e PRINTER USER'S GUIDE 10 Using Buttons, LEDs, and Audio Indicators Button Functions LED Indicators Bluetooth LED Indicators Green Self-Test Button Short press If printer is asleep; printer wakes up. If printer is awak e; paper fee ds. Long press (press and hold for five seconds) Prints a self -test. Bluetooth Power Button Short ...

  • O'Neil 2TE - page 13

    MICROFLASH 2T e PRINTER USER'S GUIDE 11 Charge LED Indicators Power LED Indicato rs LED State of Charge Action Flashing Orange Flashing Red Charge in progress . W ait for the cha rge LED to turn green. Green Charge complete. None. Red f la s h - slow Battery is too cold. Change environment. Red f la s h - fast High temperature. Change environm ...

  • O'Neil 2TE - page 14

    MICROFLASH 2T e PRINTER USER'S GUIDE 12 Audio Indicators CardReader Audio Indicators Beep(s) Description Action 1P r i n t e r w a k e s u p . N o n e . 2 Out of paper . Install paper . 3 Low battery . Charge battery . 1 short RF power is on (when blue, RF power but ton is pressed and power w as turned off ). None. 2 short RF power is off (whe ...

  • O'Neil 2TE - page 15

    MICROFLASH 2T e PRINTER USER'S GUIDE 13 Using a CardReader General Guidelines T o use the CardReader , swipe a card with the stripe facing toward the printe r , then slowly move the card left or right in the CardR eader slot. Fo r information on Ca rdRe ader LED indicators and audio indicators, see Using Buttons, LEDs, and Audio Indicators on ...

  • O'Neil 2TE - page 16

    MICROFLASH 2T e PRINTER USER'S GUIDE 14 Agency Approvals FCC Notice This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmf ul interference in a residentia l installation. This equipment genera ...

  • O'Neil 2TE - page 17

    MICROFLASH 2T e PRINTER USER'S GUIDE 15 Applicable Di rective • 89/336/EEC, 73/23/EEC Applicable Standards • EN55022 (1998) • EN55024 (1998) • EN60950 (1992) ...

  • O'Neil 2TE - page 18

    MICROFLASH 2T e PRINTER USER'S GUIDE 16 ...

  • O'Neil 2TE - page 19

    MICROFLASH 2T e PRINTER USER'S GUIDE 17 Copyright This manual and an y examples co ntain ed her e in ar e pr o vi ded “as is” and are subject to change withou t notice. O’Neil P roduct Development, I nc. makes no w arrant y of any ki nd with regard to this manual, incl ud in g, but not limited to , th e impli ed warr an ties of merchanta ...

  • O'Neil 2TE - page 20

    MICROFLASH 2T e PRINTER USER'S GUIDE 18 Media Supplies O'Neil Product Dev elopment, In c. off ers seven certified grades of paper fo r use in the printers. Our certified supplies are guaranteed compatible — this important qualification means that rigorous performa nce and image life testing have been perf ormed. Quality supplies are key ...

  • O'Neil 2TE - page 21

    ...

  • O'Neil 2TE - page 22

    W orld Headquarters O'Neil Product Development 8 Mason Irvine, CA 92618-2705 Ph: 949.458.0500 Fx: 949.458.0708 Europe 6 Joplin Court, Crownhill Milton Keynes MK8 0JP United Kingdom Ph: +44 (0) 1908 635360 Fx: +44 (0) 1908 635361 WWW .ONEILPRINTERS.COM COPYRIGHT © 2008, O’NEIL PRODUCT DEVELOPMENT , INC. Part Number 110228-001, April 2008, Ma ...

Manufacturer O'Neil Category Printer

Documents that we receive from a manufacturer of a O'Neil 2TE can be divided into several groups. They are, among others:
- O'Neil technical drawings
- 2TE manuals
- O'Neil product data sheets
- information booklets
- or energy labels O'Neil 2TE
All of them are important, but the most important information from the point of view of use of the device are in the user manual O'Neil 2TE.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals O'Neil 2TE, service manual, brief instructions and user manuals O'Neil 2TE. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product O'Neil 2TE.

Similar manuals

A complete manual for the device O'Neil 2TE, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use O'Neil 2TE by users. Manuals are usually written by a technical writer, but in a language understandable to all users of O'Neil 2TE.

A complete O'Neil manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual O'Neil 2TE - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the O'Neil 2TE, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the O'Neil 2TE, that we can find in the current document
3. Tips how to use the basic functions of the device O'Neil 2TE - which should help us in our first steps of using O'Neil 2TE
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with O'Neil 2TE
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of O'Neil 2TE in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning O'Neil 2TE?

Use the form below

If you did not solve your problem by using a manual O'Neil 2TE, ask a question using the form below. If a user had a similar problem with O'Neil 2TE it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)