Manual CrimeStopper RS900

13 pages 0.18 mb
Download

Go to site of 13

Summary
  • CrimeStopper RS900 - page 1

    RS900 / RS901 SERIES V OPERATING INSTRUCTIONS CONGRATULATIONS on your choice of a CoolStart™ Remote Engine Starter by Crimestopper Security Products Inc. This booklet contains the information necessary for using & maintaining your remote s tart system. If any questions arise, contact your installation dealer or Crimestopper Security Products ...

  • CrimeStopper RS900 - page 2

    TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….……………………………2 Using the Rem ote Transmitter…………………………………………………………………………………..….…….3 Remote Engine Control…………….…..…………? ...

  • CrimeStopper RS900 - page 3

    USING THE REMOTE TRANSMITTER (RS900) The transmitter supplied with this system has Four (4) buttons / channels. The button configuration is Factory - set and unchangeable. (RS901 model does not include remote transmitters: For add - on / OEM use only) #3 #1 TRANSMITTER BUTTONS #2 #4 START LOCK TRUNK REMOTE START UNLOCK #5 CAR 1-2 REMOTE ENGINE CONT ...

  • CrimeStopper RS900 - page 4

    AFTER IGN 3 STARTER THEN FLASH 1X SOLID SOLID SEC. START REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the fir st attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For hard starting engines, the unit will allow a starter cran ...

  • CrimeStopper RS900 - page 5

    START IDLE DOWN MODE: This mode allows the unit to take over operation of the parked vehicle while the ignition key is removed and you exit the vehicle. The vehicle is put int o a remote running condition before you exit and it will remain running for the programmed run time or until you come back. Examples: • You pull up to a convenience store f ...

  • CrimeStopper RS900 - page 6

    IGN SOLID OFF UNLOCK START ENTERING A VEHICLE DURING “IDLE - DOWN” or “INFINITY RUN” MODES: 1) With engine running in "IDLE DOWN" (parking lights ON), unlock door via remote or key. 2) Enter vehicle and be carefu l not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then depress brake pedal to res ...

  • CrimeStopper RS900 - page 7

    2) Parking Lights will start flashing, and doors will unlock. 3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running. 4) The vehicle’s parking lights will flash for the programmed run tim e of 12, 24, or 36, or 48 minutes and then switch to solid while motor runs indefinitely or until fuel supply runs out. IGN ...

  • CrimeStopper RS900 - page 8

    6) The vehicle will Start by itself every 4 hours until driven with key or started via the remote control. IGN SOLID OFF UNLOCK PRESS 1X WITHIN 10 SEC. LIGHTS OFF 5 SEC. FLASH 4X LOCK START START CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s door ...

  • CrimeStopper RS900 - page 9

    the remote control must still be utilized to operate the Starter disable feature. REMOTE PANIC (When used with Optional HORN HON K) For personal safety this unit now includes a panic feature. To sound the vehicle car horn, press the Lock Button on the remote for more than 2 seconds. The vehicle horn will honk along with flashing parking lamps for 1 ...

  • CrimeStopper RS900 - page 10

    of an external relay. This system must be programmed to allow the relay to work as a starter disable. PASSIVE STARTER DISABLE (Optional) This RS900 includes a programmable feature to allow the Optional Starter Disable to activate automatically 1 minute after the ignition is turned off. This programmable feature may provide insurance disc ounts or m ...

  • CrimeStopper RS900 - page 11

    and 4 flashes for the 4 th code. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key off and close ho od. See diagram below. TRANSMITTER PROGRAMMING: IGN OFF WAIT FOR 4 FLASHES PRESS 4X's FLASH 2, 3, or 4 X's (GRAY WIRE GROUNDED) RS900 V IGN OFF START 2 - VEHICLE OPERATION The RS - 900 V sys ...

  • CrimeStopper RS900 - page 12

    START CAR I CAR II Slide RS 900 V CAR I / CAR II OPERATION TROUBLESHOOTING: “ BEFORE YOU CALL” SECTION UNIT WILL NOT ATTEMPT A START (KEYLESS ENTRY STILL FUNCTIONS NORMALLY): The unit is in Valet mode. Turn Ignition ON, press and hold valet/programming button for 6 seconds then turn key off. Unit is now out of valet mode and shou ld perform a r ...

  • CrimeStopper RS900 - page 13

    NO RESPONSE FROM REMOTE TRANSMITTERS: (4 Parts) 1. Check for proper power/ground wiring connections at module. 2. Check Antenna Module connection. The antenna module included with this system must be plugged in. 3. Transmitters may need to be programmed to the unit. See transmitter programming steps on Page 10. 4. Check transmitter Batteries and re ...

Manufacturer CrimeStopper Category Automobile Alarm

Documents that we receive from a manufacturer of a CrimeStopper RS900 can be divided into several groups. They are, among others:
- CrimeStopper technical drawings
- RS900 manuals
- CrimeStopper product data sheets
- information booklets
- or energy labels CrimeStopper RS900
All of them are important, but the most important information from the point of view of use of the device are in the user manual CrimeStopper RS900.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals CrimeStopper RS900, service manual, brief instructions and user manuals CrimeStopper RS900. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product CrimeStopper RS900.

A complete manual for the device CrimeStopper RS900, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use CrimeStopper RS900 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of CrimeStopper RS900.

A complete CrimeStopper manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual CrimeStopper RS900 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the CrimeStopper RS900, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the CrimeStopper RS900, that we can find in the current document
3. Tips how to use the basic functions of the device CrimeStopper RS900 - which should help us in our first steps of using CrimeStopper RS900
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with CrimeStopper RS900
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of CrimeStopper RS900 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning CrimeStopper RS900?

Use the form below

If you did not solve your problem by using a manual CrimeStopper RS900, ask a question using the form below. If a user had a similar problem with CrimeStopper RS900 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)