Bedienungsanleitung CrimeStopper RS900

13 Seiten 0.18 mb
Download

Zur Seite of 13

Summary
  • CrimeStopper RS900 - page 1

    RS900 / RS901 SERIES V OPERATING INSTRUCTIONS CONGRATULATIONS on your choice of a CoolStart™ Remote Engine Starter by Crimestopper Security Products Inc. This booklet contains the information necessary for using & maintaining your remote s tart system. If any questions arise, contact your installation dealer or Crimestopper Security Products ...

  • CrimeStopper RS900 - page 2

    TABLE OF CONTENTS Operation Cautions & Warnings…….……………..….…………………………………….……………………………2 Using the Rem ote Transmitter…………………………………………………………………………………..….…….3 Remote Engine Control…………….…..…………? ...

  • CrimeStopper RS900 - page 3

    USING THE REMOTE TRANSMITTER (RS900) The transmitter supplied with this system has Four (4) buttons / channels. The button configuration is Factory - set and unchangeable. (RS901 model does not include remote transmitters: For add - on / OEM use only) #3 #1 TRANSMITTER BUTTONS #2 #4 START LOCK TRUNK REMOTE START UNLOCK #5 CAR 1-2 REMOTE ENGINE CONT ...

  • CrimeStopper RS900 - page 4

    AFTER IGN 3 STARTER THEN FLASH 1X SOLID SOLID SEC. START REMOTE ENGINE CONTROL REMOTE ENGINE STARTING - UNSUCCESSFUL START In the event that the engine does not start on the fir st attempt, the system shuts down for a few seconds, then attempts to restart the engine a 2 nd and 3 rd time. For hard starting engines, the unit will allow a starter cran ...

  • CrimeStopper RS900 - page 5

    START IDLE DOWN MODE: This mode allows the unit to take over operation of the parked vehicle while the ignition key is removed and you exit the vehicle. The vehicle is put int o a remote running condition before you exit and it will remain running for the programmed run time or until you come back. Examples: • You pull up to a convenience store f ...

  • CrimeStopper RS900 - page 6

    IGN SOLID OFF UNLOCK START ENTERING A VEHICLE DURING “IDLE - DOWN” or “INFINITY RUN” MODES: 1) With engine running in "IDLE DOWN" (parking lights ON), unlock door via remote or key. 2) Enter vehicle and be carefu l not to step on brake pedal! (Remote Start Reset) 3) Turn Ignition to ON/RUN position, then depress brake pedal to res ...

  • CrimeStopper RS900 - page 7

    2) Parking Lights will start flashing, and doors will unlock. 3) Turn Ignition switch OFF, remove key and exit the vehicle. Engine should remain running. 4) The vehicle’s parking lights will flash for the programmed run tim e of 12, 24, or 36, or 48 minutes and then switch to solid while motor runs indefinitely or until fuel supply runs out. IGN ...

  • CrimeStopper RS900 - page 8

    6) The vehicle will Start by itself every 4 hours until driven with key or started via the remote control. IGN SOLID OFF UNLOCK PRESS 1X WITHIN 10 SEC. LIGHTS OFF 5 SEC. FLASH 4X LOCK START START CONVENIENCE AND SAFETY FEATURES KEYLESS ENTRY (POWER DOOR LOCK CONTROL, Optional) This system enables you to remotely lock and unlock the vehicle’s door ...

  • CrimeStopper RS900 - page 9

    the remote control must still be utilized to operate the Starter disable feature. REMOTE PANIC (When used with Optional HORN HON K) For personal safety this unit now includes a panic feature. To sound the vehicle car horn, press the Lock Button on the remote for more than 2 seconds. The vehicle horn will honk along with flashing parking lamps for 1 ...

  • CrimeStopper RS900 - page 10

    of an external relay. This system must be programmed to allow the relay to work as a starter disable. PASSIVE STARTER DISABLE (Optional) This RS900 includes a programmable feature to allow the Optional Starter Disable to activate automatically 1 minute after the ignition is turned off. This programmable feature may provide insurance disc ounts or m ...

  • CrimeStopper RS900 - page 11

    and 4 flashes for the 4 th code. If all 4 codes are learned, the unit will automatically exit code learning mode, otherwise turn key off and close ho od. See diagram below. TRANSMITTER PROGRAMMING: IGN OFF WAIT FOR 4 FLASHES PRESS 4X's FLASH 2, 3, or 4 X's (GRAY WIRE GROUNDED) RS900 V IGN OFF START 2 - VEHICLE OPERATION The RS - 900 V sys ...

  • CrimeStopper RS900 - page 12

    START CAR I CAR II Slide RS 900 V CAR I / CAR II OPERATION TROUBLESHOOTING: “ BEFORE YOU CALL” SECTION UNIT WILL NOT ATTEMPT A START (KEYLESS ENTRY STILL FUNCTIONS NORMALLY): The unit is in Valet mode. Turn Ignition ON, press and hold valet/programming button for 6 seconds then turn key off. Unit is now out of valet mode and shou ld perform a r ...

  • CrimeStopper RS900 - page 13

    NO RESPONSE FROM REMOTE TRANSMITTERS: (4 Parts) 1. Check for proper power/ground wiring connections at module. 2. Check Antenna Module connection. The antenna module included with this system must be plugged in. 3. Transmitters may need to be programmed to the unit. See transmitter programming steps on Page 10. 4. Check transmitter Batteries and re ...

Produzent CrimeStopper Kategorie Automobile Alarm

Dokumente, die wir vom Produzenten des Geräts CrimeStopper RS900 erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen CrimeStopper
- Bedienungsanleitungen RS900
- Produktkarten CrimeStopper
- Informationsbroschüren
- oder Energieetiketten CrimeStopper RS900
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung CrimeStopper RS900.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen CrimeStopper RS900, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen CrimeStopper RS900. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts CrimeStopper RS900 ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts CrimeStopper RS900, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von CrimeStopper RS900 hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von CrimeStopper RS900 verständlich ist.

Eine gänzliche Bedienungsanleitung von CrimeStopper sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von CrimeStopper RS900 bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von CrimeStopper RS900 befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich CrimeStopper RS900, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts CrimeStopper RS900 - die uns die ersten Schritte während der Nutzung von CrimeStopper RS900 erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit CrimeStopper RS900 hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von CrimeStopper RS900 im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich CrimeStopper RS900?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit CrimeStopper RS900 nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit CrimeStopper RS900 hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)