Bedienungsanleitung CrimeStopper CS-2003DC

16 Seiten 0.5 mb
Download

Zur Seite of 16

Summary
  • CrimeStopper CS-2003DC - page 1

    CS - 2003DC REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security Products Inc. This system features DYNAMIC CODE anti code - g rabbing technology. The remote control code changes with every use of the transmitter making it impo ...

  • CrimeStopper CS-2003DC - page 2

    INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, A BS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUSE PRIOR TO TESTING FOR DOOR TRIGGERS. DO NOT EXCE ...

  • CrimeStopper CS-2003DC - page 3

    COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender - well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren. LED: Mount the red LED in a visible location on the dashboard or console. Shock Sensor ...

  • CrimeStopper CS-2003DC - page 4

    WIRIN G PIN 8: BLACK WIRE: CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure a good connection. We recommend the kick panel area for your ground point. PIN 9: WHITE WIRE: +12V FLASHING P ARKING LIGHT OUTPUT (Optional) Connect to switched parking light wire at back of light switch ...

  • CrimeStopper CS-2003DC - page 5

    WIRING 4 - PIN SENSOR PLUG: WH ITE WIRE: NEG. WARN AWAY * The Sensor supplied with the system does not require BLUE WIRE: NEG. TRIGGER any additional wiring, simply mount the sensor in a BLACK WIRE SENSOR GROUND suitable location, plug in, and adjust sensitivity. RED WIRE SENSO R +12V POWER 3 - PIN PASSENGER DOOR UNLOCK PLUG: GREEN WIRE: (- ) PASSE ...

  • CrimeStopper CS-2003DC - page 6

    POWER DOOR LOCK WIRING UL REVERSE POLARITY DOOR LOCK WIRING + L NEG ATIVE TRIGGER DOORLOCK WIRING UL L +12V FUSED WHITE GREEN BLUE BROWN VIOLET WHITE GREEN BLUE BROWN VIOLET NOT USED + NOT USED UNLOCK CUT LOCK CUT FACTORY LOCKING REL AYS POWER UL L + AFTERMARKET MOTOR/DOOR LOCK WIRING UL L POSITIVE TRIGGER DOORLOCK WIRING +12V FUSED WHITE GREEN BLU ...

  • CrimeStopper CS-2003DC - page 7

    SEPARATE DRIVER’S DOOR UNLOCK WIRING NEG ATIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHITE GREEN BLUE BROWN VIOLET + 86 85 87 30 87A POSITIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHIT ...

  • CrimeStopper CS-2003DC - page 8

    TRANSMITTER PROGRAMMING 1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3 rd time. (ON/OFF, ON/OFF, ON) You should hear (3) chirps. 2. Push and release the Program/Override Button 5 times and the Status LED will come on solid. 3. Press #1 (LOCK) on new transmitter two times. LED goes o ut, siren chirps one time, and LED will flicker ...

  • CrimeStopper CS-2003DC - page 9

    OPTION PROG RAMMING CS - 2003 DC PROGRAMMABLE OPTIONS 1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear 6 confirmation chirps . 2. Within the next few seconds, press the Override/Program button [again] the number of times that co rresponds to the feature list below. The siren will chirp for each button press. DO ...

  • CrimeStopper CS-2003DC - page 10

    OPTION PROGRAMMING 2. SOFT CHIRP ARM / DISARM WITH BUTTON #3 (SHORT PRESS) With this feature, the system can be programmed to Arm and Disarm with a very soft siren chirp using a short press on button #3 on the remote. The Factory Default setting is ON. 3. PARKING LIGHTS ON WITH DISARM Keeps parking lights on instead of 2 flashes when system is disa ...

  • CrimeStopper CS-2003DC - page 11

    OPTION PROGRAMMING 12 . ACTIVE or PASSIVE CARJACK PROTECTION This feature controls the alarm system’s Carjack Mode for ACTIVE OR PASSIVE protection. Option number 9 Must be enabled to allow Carjack functions to operate. See Operation section for Carjack Features. Factory def ault is Active. 13. 10/60 Sec. DOOR/ZONE OPEN WARNING This setting chang ...

  • CrimeStopper CS-2003DC - page 12

    OPERATION DISARMING To disarm the alarm and unlock the doors, press the #2 (Unlock Symbol) button on the transmitter. You will hear 2 siren chirps and the lights will flash twice. The dome light turns on and the dash LED stops flashing. ARMED TRIP RESET If and when the alarm system is tripped, you can reset the unit’s tripped condition without ha ...

  • CrimeStopper CS-2003DC - page 13

    OPERATION SOFT CHIRP ARM/DISARM This system can be armed and disarmed wit h very faint/soft chirps as needed. Press and quickly release Button #3 (Trunk pop) to Arm and Disarm system with soft chirps. Note: If Button #3 is pressed too long, then the Aux. 1 output will activate. SILENT ARM/DISARM MODE The system can be silentl y armed and disarmed a ...

  • CrimeStopper CS-2003DC - page 14

    OPERATION 2 nd AUX . OUTPUT (REMOTE AUX. OUTPUT 2) To activate the Second auxiliary output press Button #1 (Lock) and hold for more than (1) second. This output can be used to control other optional add - on accessories such as Remote Engine Start Modules, Window Roll up/down modules, etc. 2 VEHICLE CONTROL This unit can be programmed to Arm/Disarm ...

  • CrimeStopper CS-2003DC - page 15

    CS2003DC REVA 2.10.00 Crimestopper Security Products 1770 S. Tapo Street Simi Val ley, CA 93063 ...

  • CrimeStopper CS-2003DC - page 16

    www.crimestopper.com ...

Produzent CrimeStopper Kategorie Automobile Alarm

Dokumente, die wir vom Produzenten des Geräts CrimeStopper CS-2003DC erhalten, können wir in mehrere Gruppen teilen. Unteranderem in:
- technische Zeichnungen CrimeStopper
- Bedienungsanleitungen CS-2003DC
- Produktkarten CrimeStopper
- Informationsbroschüren
- oder Energieetiketten CrimeStopper CS-2003DC
Jede von ihnen ist wichtig, jedoch finden wir die wichtigsten Informationen für den Nutzer des Geräts in der Bedienungsanleitung CrimeStopper CS-2003DC.

Die Dokumentengruppe, die als Bedienungsanleitungen bezeichnet wird, wird ebenfalls in detaillierte Arten geteilt, solche wie: Montageanleitungen CrimeStopper CS-2003DC, Wartungsanleitungen, Kurzanleitungen oder Benutzeranleitungen CrimeStopper CS-2003DC. Abhängig vom Bedarf, sollten Sie das Dokument finden, das Sie brauchen. In unserem Service können Sie sich die populärste Bedienungsanleitung des Produkts CrimeStopper CS-2003DC ansehen.

Ähnliche Bedienungsanleitungen

Die komplette Bedienungsanleitung des Geräts CrimeStopper CS-2003DC, wie sollte sie aussehen?
Die Bedienungsanleitung, auch bezeichnet als Benutzerhandbuch, oder einfach nur „Anleitung”, ist ein technisches Dokument, das dem Benutzer bei der Nutzung von CrimeStopper CS-2003DC hilfreich sein soll. Die Bedienungsanleitungen werden in der Regel von technischen Schriftstellern geschrieben, aber in einer Sprache, die für alle Nutzer von CrimeStopper CS-2003DC verständlich ist.

Eine gänzliche Bedienungsanleitung von CrimeStopper sollte einige Grundelemente enthalten. Ein Teil von ihnen ist nicht so wichtig, wie z.B.: die Titelseite oder Autorenseiten. Die restlichen von ihnen jedoch, sollten Informationen liefern, die für den Nutzer von enormer Wichtigkeit sind.

1. Einführung und Hinweise, wie man sich in einer Bedienungsanleitung von CrimeStopper CS-2003DC bewegt - Am Anfang jeder Bedienungsanleitung sollten wir Hinweise bezüglich der Nutzungsart eines bestimmten Ratgebers finden. In ihr sollten sich Informationen über die Lokalisierung des Inhaltsverzeichnisses von CrimeStopper CS-2003DC befinden, FAQ oder über oft auftretende Probleme – also Stellen, die von den Benutzern in jeder Bedienungsanleitung am meisten gesucht werden
2. Inhaltsverzeichnis - Index aller Ratschläge bezüglich CrimeStopper CS-2003DC, die wir im aktuellen Dokument finden
3. Ratschläge zur Nutzung der Grundfunktionen des Geräts CrimeStopper CS-2003DC - die uns die ersten Schritte während der Nutzung von CrimeStopper CS-2003DC erleichtern sollten
4. Troubleshooting - geordneter Tätigkeitslauf, der uns bei der Diagnose und als nächstes bei der Lösung wichtiger Probleme mit CrimeStopper CS-2003DC hilft
5. FAQ - häufig gestellte Fragen
6. Kontaktdaten Informationen darüber, wo man Kontakt zum Produzenten / Service von CrimeStopper CS-2003DC im bestimmten Land suchen kann, wenn es nicht gelingt, das Problem selbst zu lösen.

Haben Sie eine Frage bezüglich CrimeStopper CS-2003DC?

Nutzen Sie das untere Formular

Wenn Sie mit Hilfe der gefundenen Bedienungsanleitung Ihr Problem mit CrimeStopper CS-2003DC nicht gelöst haben, stellen Sie eine Frage, indem Sie das untere Formular nutzen. Wenn einer der Nutzer ein ähnliches Problem mit CrimeStopper CS-2003DC hatte, ist es möglich, dass er mit Ihnen die Lösung teilen möchte.

Text vom Bild übertragen

Kommentare (0)