Manuel d’utilisation CrimeStopper CS-2003DC

16 pages 0.5 mb
Télécharger

Aller à la page of 16

Summary
  • CrimeStopper CS-2003DC - page 1

    CS - 2003DC REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security Products Inc. This system features DYNAMIC CODE anti code - g rabbing technology. The remote control code changes with every use of the transmitter making it impo ...

  • CrimeStopper CS-2003DC - page 2

    INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, A BS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUSE PRIOR TO TESTING FOR DOOR TRIGGERS. DO NOT EXCE ...

  • CrimeStopper CS-2003DC - page 3

    COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender - well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren. LED: Mount the red LED in a visible location on the dashboard or console. Shock Sensor ...

  • CrimeStopper CS-2003DC - page 4

    WIRIN G PIN 8: BLACK WIRE: CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure a good connection. We recommend the kick panel area for your ground point. PIN 9: WHITE WIRE: +12V FLASHING P ARKING LIGHT OUTPUT (Optional) Connect to switched parking light wire at back of light switch ...

  • CrimeStopper CS-2003DC - page 5

    WIRING 4 - PIN SENSOR PLUG: WH ITE WIRE: NEG. WARN AWAY * The Sensor supplied with the system does not require BLUE WIRE: NEG. TRIGGER any additional wiring, simply mount the sensor in a BLACK WIRE SENSOR GROUND suitable location, plug in, and adjust sensitivity. RED WIRE SENSO R +12V POWER 3 - PIN PASSENGER DOOR UNLOCK PLUG: GREEN WIRE: (- ) PASSE ...

  • CrimeStopper CS-2003DC - page 6

    POWER DOOR LOCK WIRING UL REVERSE POLARITY DOOR LOCK WIRING + L NEG ATIVE TRIGGER DOORLOCK WIRING UL L +12V FUSED WHITE GREEN BLUE BROWN VIOLET WHITE GREEN BLUE BROWN VIOLET NOT USED + NOT USED UNLOCK CUT LOCK CUT FACTORY LOCKING REL AYS POWER UL L + AFTERMARKET MOTOR/DOOR LOCK WIRING UL L POSITIVE TRIGGER DOORLOCK WIRING +12V FUSED WHITE GREEN BLU ...

  • CrimeStopper CS-2003DC - page 7

    SEPARATE DRIVER’S DOOR UNLOCK WIRING NEG ATIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHITE GREEN BLUE BROWN VIOLET + 86 85 87 30 87A POSITIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHIT ...

  • CrimeStopper CS-2003DC - page 8

    TRANSMITTER PROGRAMMING 1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3 rd time. (ON/OFF, ON/OFF, ON) You should hear (3) chirps. 2. Push and release the Program/Override Button 5 times and the Status LED will come on solid. 3. Press #1 (LOCK) on new transmitter two times. LED goes o ut, siren chirps one time, and LED will flicker ...

  • CrimeStopper CS-2003DC - page 9

    OPTION PROG RAMMING CS - 2003 DC PROGRAMMABLE OPTIONS 1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear 6 confirmation chirps . 2. Within the next few seconds, press the Override/Program button [again] the number of times that co rresponds to the feature list below. The siren will chirp for each button press. DO ...

  • CrimeStopper CS-2003DC - page 10

    OPTION PROGRAMMING 2. SOFT CHIRP ARM / DISARM WITH BUTTON #3 (SHORT PRESS) With this feature, the system can be programmed to Arm and Disarm with a very soft siren chirp using a short press on button #3 on the remote. The Factory Default setting is ON. 3. PARKING LIGHTS ON WITH DISARM Keeps parking lights on instead of 2 flashes when system is disa ...

  • CrimeStopper CS-2003DC - page 11

    OPTION PROGRAMMING 12 . ACTIVE or PASSIVE CARJACK PROTECTION This feature controls the alarm system’s Carjack Mode for ACTIVE OR PASSIVE protection. Option number 9 Must be enabled to allow Carjack functions to operate. See Operation section for Carjack Features. Factory def ault is Active. 13. 10/60 Sec. DOOR/ZONE OPEN WARNING This setting chang ...

  • CrimeStopper CS-2003DC - page 12

    OPERATION DISARMING To disarm the alarm and unlock the doors, press the #2 (Unlock Symbol) button on the transmitter. You will hear 2 siren chirps and the lights will flash twice. The dome light turns on and the dash LED stops flashing. ARMED TRIP RESET If and when the alarm system is tripped, you can reset the unit’s tripped condition without ha ...

  • CrimeStopper CS-2003DC - page 13

    OPERATION SOFT CHIRP ARM/DISARM This system can be armed and disarmed wit h very faint/soft chirps as needed. Press and quickly release Button #3 (Trunk pop) to Arm and Disarm system with soft chirps. Note: If Button #3 is pressed too long, then the Aux. 1 output will activate. SILENT ARM/DISARM MODE The system can be silentl y armed and disarmed a ...

  • CrimeStopper CS-2003DC - page 14

    OPERATION 2 nd AUX . OUTPUT (REMOTE AUX. OUTPUT 2) To activate the Second auxiliary output press Button #1 (Lock) and hold for more than (1) second. This output can be used to control other optional add - on accessories such as Remote Engine Start Modules, Window Roll up/down modules, etc. 2 VEHICLE CONTROL This unit can be programmed to Arm/Disarm ...

  • CrimeStopper CS-2003DC - page 15

    CS2003DC REVA 2.10.00 Crimestopper Security Products 1770 S. Tapo Street Simi Val ley, CA 93063 ...

  • CrimeStopper CS-2003DC - page 16

    www.crimestopper.com ...

Fabricant CrimeStopper Catégorie Automobile Alarm

Les documents que nous recevons du fabricant de l'appareilCrimeStopper CS-2003DC peuvent être divisés en plusieurs groupes. Ceux-ci sont, entre autres:
- dessins techniques CrimeStopper
- manuels d’utilisations CS-2003DC
- fiches produit CrimeStopper
- dépliants
- ou étiquettes-énergie CrimeStopper CS-2003DC
Tous sont importants, mais les informations les plus importantes du point de vue de l'utilisation de l'appareil se trouvent dans le manuel d’utilisation CrimeStopper CS-2003DC.

Un groupe de documents appelé manuels d’utilisation est également divisé en types plus spécifiques, tels que: Manuels d’installation CrimeStopper CS-2003DC, manuels d’entretien, brefs manuels ou manuels de l’utilisateur CrimeStopper CS-2003DC. Selon vos besoins, vous devriez chercher le document dont vous avez besoin. Sur notre site, vous pouvez voir le manuel le plus populaire d’utilisation du produit CrimeStopper CS-2003DC.

Manuels d’utilsiation similaires

Manuel d’utilisation complet de l’appareil CrimeStopper CS-2003DC, quelle devrait-elle être?
Le manuel d’utilisation, également appelé le mode d’emploi, ou tout simplement le manuel, est un document technique destiné à aider à utiliser CrimeStopper CS-2003DC par les utilisateurs. Des manuels sont généralement écrits par un rédacteur technique, mais dans un langage accessible à tous les utilisateurs CrimeStopper CS-2003DC.

Le manuel d’utilisation complet CrimeStopper, devrait inclure plusieurs éléments de base. Certains d'entre eux sont moins importants, tels que: la couverture / page de titre ou pages d'auteur. Cependant, la partie restante, devrait nous fournir des informations importantes du point de vue de l'utilisateur.

1. Introduction et des conseils sur la façon d'utiliser le manuel CrimeStopper CS-2003DC - Au début de chaque manuel, nous devrions trouver des indices sur la façon d'utiliser le document. Il doit contenir des informations sur l'emplacement de la table des matières CrimeStopper CS-2003DC, FAQ ou des problèmes les plus fréquents - les points qui sont les plus souvent recherchés par les utilisateurs de chaque manuel
2. Table des matières - index de tous les conseils pour lCrimeStopper CS-2003DC qui peuvent être trouvés dans le document courant
3. Conseils sur la façon d'utiliser les fonctions de base de l’appareil CrimeStopper CS-2003DC - qui devraient nous aider dans les premières étapes lors de l'utilisation CrimeStopper CS-2003DC
4. Troubleshooting - séquence systématique des activités qui nous aideront à diagnostiquer et ensuite résoudre les principaux problèmes de CrimeStopper CS-2003DC
5. FAQ - questions fréquemment posées
6. Détails du contact Informations sur l'endroit où chercher le contact avec le fabricant / service CrimeStopper CS-2003DC dans un pays donné, si le problème ne peut être résolu par nous-mêmes.

Avez-vous une question à propos de CrimeStopper CS-2003DC?

Utiliser le formulaire ci-dessous

Si vous n’avez pas résolu votre problème avec CrimeStopper CS-2003DC, avec l'aide du manuel que vous avez trouvé, posez une question en utilisant le formulaire ci-dessous. Si un utilisateur a eu un problème similaire avec CrimeStopper CS-2003DC il est probable qu’il a envie de partager la façon de le résoudre.

Réécrire le texte de l'image

Commentaires (0)