-
CrimeStopper CS-2003DC - page 1
CS - 2003DC REMOTE CONTROL ALARM SYSTEM INSTALLATION & OPERATING INSTRUCTIONS INTRODUCTION CONGRATULATIONS on your choice of a Gargoyle™ Remote Alarm System by Crimestopper Security Products Inc. This system features DYNAMIC CODE anti code - g rabbing technology. The remote control code changes with every use of the transmitter making it impo ...
-
CrimeStopper CS-2003DC - page 2
INSTALLATION CAUTIONS & WARNINGS BEFORE BEGINNING , check all vehicle manufacturer cautions and warnings regarding electrical service (AIR BAGS, A BS BRAKES, AND BATTERY). TO PREVENT A POSSIBLE DEAD BATTERY remove vehicle dome light fuse while working on the vehicle. MAKE CERTAIN TO REINSTALL FUSE PRIOR TO TESTING FOR DOOR TRIGGERS. DO NOT EXCE ...
-
CrimeStopper CS-2003DC - page 3
COMPONENT MOUNTING SIREN MOUNTING: Mount the siren under the hood to fender - well or other body surface with the open end facing downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body metal near the siren. LED: Mount the red LED in a visible location on the dashboard or console. Shock Sensor ...
-
CrimeStopper CS-2003DC - page 4
WIRIN G PIN 8: BLACK WIRE: CHASSIS GROUND THIS WIRE MUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure a good connection. We recommend the kick panel area for your ground point. PIN 9: WHITE WIRE: +12V FLASHING P ARKING LIGHT OUTPUT (Optional) Connect to switched parking light wire at back of light switch ...
-
CrimeStopper CS-2003DC - page 5
WIRING 4 - PIN SENSOR PLUG: WH ITE WIRE: NEG. WARN AWAY * The Sensor supplied with the system does not require BLUE WIRE: NEG. TRIGGER any additional wiring, simply mount the sensor in a BLACK WIRE SENSOR GROUND suitable location, plug in, and adjust sensitivity. RED WIRE SENSO R +12V POWER 3 - PIN PASSENGER DOOR UNLOCK PLUG: GREEN WIRE: (- ) PASSE ...
-
CrimeStopper CS-2003DC - page 6
POWER DOOR LOCK WIRING UL REVERSE POLARITY DOOR LOCK WIRING + L NEG ATIVE TRIGGER DOORLOCK WIRING UL L +12V FUSED WHITE GREEN BLUE BROWN VIOLET WHITE GREEN BLUE BROWN VIOLET NOT USED + NOT USED UNLOCK CUT LOCK CUT FACTORY LOCKING REL AYS POWER UL L + AFTERMARKET MOTOR/DOOR LOCK WIRING UL L POSITIVE TRIGGER DOORLOCK WIRING +12V FUSED WHITE GREEN BLU ...
-
CrimeStopper CS-2003DC - page 7
SEPARATE DRIVER’S DOOR UNLOCK WIRING NEG ATIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHITE GREEN BLUE BROWN VIOLET + 86 85 87 30 87A POSITIVE TRIGGER DOOR LOCKS GREEN DRIVER'S DOOR MOTOR L L UL UL FACTORY LOCK RELAYS +12V + FUSED UNLOCK WIRE CUT +12V FUSED WHIT ...
-
CrimeStopper CS-2003DC - page 8
TRANSMITTER PROGRAMMING 1. Turn Ignition ON and OFF 3 times quickly, leaving it ON the 3 rd time. (ON/OFF, ON/OFF, ON) You should hear (3) chirps. 2. Push and release the Program/Override Button 5 times and the Status LED will come on solid. 3. Press #1 (LOCK) on new transmitter two times. LED goes o ut, siren chirps one time, and LED will flicker ...
-
CrimeStopper CS-2003DC - page 9
OPTION PROG RAMMING CS - 2003 DC PROGRAMMABLE OPTIONS 1. Turn the Ignition ON and press the Override/Program button 5 times. You should hear 6 confirmation chirps . 2. Within the next few seconds, press the Override/Program button [again] the number of times that co rresponds to the feature list below. The siren will chirp for each button press. DO ...
-
CrimeStopper CS-2003DC - page 10
OPTION PROGRAMMING 2. SOFT CHIRP ARM / DISARM WITH BUTTON #3 (SHORT PRESS) With this feature, the system can be programmed to Arm and Disarm with a very soft siren chirp using a short press on button #3 on the remote. The Factory Default setting is ON. 3. PARKING LIGHTS ON WITH DISARM Keeps parking lights on instead of 2 flashes when system is disa ...
-
CrimeStopper CS-2003DC - page 11
OPTION PROGRAMMING 12 . ACTIVE or PASSIVE CARJACK PROTECTION This feature controls the alarm system’s Carjack Mode for ACTIVE OR PASSIVE protection. Option number 9 Must be enabled to allow Carjack functions to operate. See Operation section for Carjack Features. Factory def ault is Active. 13. 10/60 Sec. DOOR/ZONE OPEN WARNING This setting chang ...
-
CrimeStopper CS-2003DC - page 12
OPERATION DISARMING To disarm the alarm and unlock the doors, press the #2 (Unlock Symbol) button on the transmitter. You will hear 2 siren chirps and the lights will flash twice. The dome light turns on and the dash LED stops flashing. ARMED TRIP RESET If and when the alarm system is tripped, you can reset the unit’s tripped condition without ha ...
-
CrimeStopper CS-2003DC - page 13
OPERATION SOFT CHIRP ARM/DISARM This system can be armed and disarmed wit h very faint/soft chirps as needed. Press and quickly release Button #3 (Trunk pop) to Arm and Disarm system with soft chirps. Note: If Button #3 is pressed too long, then the Aux. 1 output will activate. SILENT ARM/DISARM MODE The system can be silentl y armed and disarmed a ...
-
CrimeStopper CS-2003DC - page 14
OPERATION 2 nd AUX . OUTPUT (REMOTE AUX. OUTPUT 2) To activate the Second auxiliary output press Button #1 (Lock) and hold for more than (1) second. This output can be used to control other optional add - on accessories such as Remote Engine Start Modules, Window Roll up/down modules, etc. 2 VEHICLE CONTROL This unit can be programmed to Arm/Disarm ...
-
CrimeStopper CS-2003DC - page 15
CS2003DC REVA 2.10.00 Crimestopper Security Products 1770 S. Tapo Street Simi Val ley, CA 93063 ...
-
CrimeStopper CS-2003DC - page 16
www.crimestopper.com ...
¿Tienes una pregunta acerca de CrimeStopper CS-2003DC?
Utiliza el formulario que se encuentra abajo
Si con la ayuda del manual de instrucciones encontrado no has podido solucionar tu problema con CrimeStopper CS-2003DC, haz una pregunta utilizando el formulario que se encuentra abajo. Si alguno de los usuarios ha tenido un problema parecido con CrimeStopper CS-2003DC probablemente compartirá una forma de solucionarlo.