English dropdown-ico

Manual Trane WSHP-DS-6

18 pages 4.84 mb
Download

Go to site of 18

Summary
  • Trane WSHP-DS-6 - page 1

    WSHP-DS-6 March 2000 Water Source Heat Pump Water-to-Water Model WPWD WSHP-DS-6 ...

  • Trane WSHP-DS-6 - page 2

    2 Introduction The WPWD product is a heating and cooling hydronic fluid water-to- water heat pump capable of pro- ducing water temperature up to 130 F or temperatures down to 25 F. This extended operating range offers great opportunities in commercial, residential and indus- trial applications. There are many load side applica- tions for which the ...

  • Trane WSHP-DS-6 - page 3

    3 Introduction 2 Features and Benefits 4 Model Number Description 7 General Data 8 Application Considerations 9 Electrical Data 18 Performance Data 19 Dimensional Data 25 Wiring Diagram 28 Accessory Options 30 Mechanical Specifications 31 Table of Contents ...

  • Trane WSHP-DS-6 - page 4

    4 General The water source heat pump model WPWD (water-to-water) offers a range of capacities from 2 tons to 6 tons. All units are housed in one standard compact cabinet. Cabinet The cabinet, which allows easy ac- cess for installation and service, is constructed of heavy gauge metal. The cabinet finish is produced by a corrosion resistant electros ...

  • Trane WSHP-DS-6 - page 5

    5 Controls Features and Benefits Lockout Relay 50 VA Transformer 24 VAC Contactor Compressor Run Capacitor 2 Amp Fuse (for use with desuperheater option) Ground 10 Pole Terminal Strip Low Voltage Thermostat Low Voltage High Voltage Figure 3: Controls 24 V olt Controls All electrical controls and safety de- vices are factory wired, tested, and mount ...

  • Trane WSHP-DS-6 - page 6

    6 Cold water (Supply) Hot water (Supply) Water heater hook-up kit with drain valve from Desuperheater to Desuperheater Desuper-out Isolation Valves (by others) Desuper-in Desuperheater Option The desuperheater option is a heat recovery system packaged within the water-to-water unit. This option captures heat energy from the heat pump for considerab ...

  • Trane WSHP-DS-6 - page 7

    7 Model Number Description Digits 1 & 2: Product Type WP = Trane Commercial Water Source Heat Pump Digit 3: Product Configuration W = Water-to-Water Digit 4: Development Sequence D Digits 5-7: Unit Nominal Capacity 024 = 24.0 MBh 036 = 36.0 MBh 042 = 42.0 MBh 048 = 48.0 MBh 060 = 60.0 MBh 072 = 72.0 MBh Digit 8: Voltage / Hertz / Phase 1 = 208- ...

  • Trane WSHP-DS-6 - page 8

    8 General Data Table G-1: Physical Data (English) Model: WPWD 024 036 042 048 060 072 Unit Size Width of cabinet (in) 23 23 23 23 23 23 Width of cabinet and connections (in) 24.8 24.8 24.8 24.8 24.8 24.8 Height (in) 24.3 24.3 24.3 24.3 24.3 24.3 Depth (in) 23.3 23.3 23.3 23.3 23.3 23.3 Compressor Type Scroll Scroll Scroll Scroll Scroll Scroll R-22 ...

  • Trane WSHP-DS-6 - page 9

    9 Application Considerations Closed Loop System Closed loop systems (both ground source and surface water) provide heat rejection and heat addition to maintain proper water source temperatures. Operating and maintenace cost are low because an auxillary fossil fuel boiler and cooling tower are not required to maintain the loop temperature. The techn ...

  • Trane WSHP-DS-6 - page 10

    10 Application Considerations Open Loop System Where an existing or proposed well can provide an ample supply of suitable quality water, ground water systems may be very efficient. (See Figure 7) Operation and benefits are similar to those for closed loop systems. There are however several considerations that should be addressed prior to installati ...

  • Trane WSHP-DS-6 - page 11

    11 Source Side vs. Load Side Application Considerations Source vs. Load The model WPWD water-to-water system contains two water to refrig- erant heat exchangers. The two heat exchangers enable the system to be divided into a source and load separation. The “ source side ” heat exchanger performs as in a standard water to air heat pump system. T ...

  • Trane WSHP-DS-6 - page 12

    12 Closed Loop Geothermal Application Considerations (Closed) Ground Loop Heat Exchanger Geothermal Space Heating / Cooling T emperature Refrigeration Equipment Hydronic Ice Melting Via Unit a W ater-to-W ater Geothermal Integrated System The Trane ground source heat pump is highly efficient in service station applications. This integrated system d ...

  • Trane WSHP-DS-6 - page 13

    13 Fresh Air Ventilation Application Considerations Water-Out (source) Water-In (source) Water-Out (load) Water-In (load) Exhaust Air Fresh Air (Closed) Ground Loop Heat Exchanger Geothermal Space Heating and Cooling Fresh Air Ventilation with Water-to-Water Units W ater-to-W ater and Fresh Air V entilation Geothermal energy systems take advantage ...

  • Trane WSHP-DS-6 - page 14

    14 Fresh Air Ventilation Mechanical Application Considerations HOT W A TER COIL EXHAUST AIR OUTSIDE AIR AIR HANDLER AIR HANDLER EXHAUST AIR TO HE A T PU MPS EXHAUST AIR FROM TOILET RMS WPWD AUTOMA TIC AIR VENT EXP T ANK DRAIN V A HAND PUMP PRESSURE RELIEF V A WPWD WPWD WPWD BALL V A SUPPL Y RETURN ...

  • Trane WSHP-DS-6 - page 15

     1 2 3 5 4 6 7 Central Pump Application  Ball valves should be installed in the supply and return lines for unit isolation and unit water flow rate balancing (if an auto- matic flow device is not selected). This connection, along with hoses, are also rec- ommended for backflushing and chemical cleaning of the water to refrigerant heat e ...

  • Trane WSHP-DS-6 - page 16

    16 Well Water Systems Application Considerations 7 6 2 3 4 5 Figure 11: Well water installation 1 9 8 S u p p l y O v e r f l o w R e t u r n General A well water application involves an open loop water supply . The water is drawn from an open well or pond into the unit. A straining device is required with this application. Similar to the closed lo ...

  • Trane WSHP-DS-6 - page 17

    17 Earth Coupled Application  Ball valves should be installed in the supply and return lines for unit isolation.  Flexible hoses may be used to connect the water supply and return lines to the water inlets and outlet s. These hoses reduce possible vibration between the unit and the rigid system. Note: Hoses and or pipes should be braide ...

  • Trane WSHP-DS-6 - page 18

    18 Electrical Data Table E-1: Electrical Data Model: WPWD 024 036 042 048 060 072 Voltage 208-230/60hz/1phase Compressor RLA 11.4 15 18.4 20.4 28 32.1 Compressor LRA 56 73 95 109 169 169 Minimum Circuit Ampacity 16 21 25.8 28.6 39 45 Max Fuse Size 25 30 40 45 60 70 Aux Pump Amps 2.5 2.5 2.5 2.5 2.5 2.5 Desuperheater Min Cir Ampacity 14.3 18.8 23 25 ...

Manufacturer Trane Category Heat Pump

Documents that we receive from a manufacturer of a Trane WSHP-DS-6 can be divided into several groups. They are, among others:
- Trane technical drawings
- WSHP-DS-6 manuals
- Trane product data sheets
- information booklets
- or energy labels Trane WSHP-DS-6
All of them are important, but the most important information from the point of view of use of the device are in the user manual Trane WSHP-DS-6.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Trane WSHP-DS-6, service manual, brief instructions and user manuals Trane WSHP-DS-6. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Trane WSHP-DS-6.

Similar manuals

A complete manual for the device Trane WSHP-DS-6, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Trane WSHP-DS-6 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Trane WSHP-DS-6.

A complete Trane manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Trane WSHP-DS-6 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Trane WSHP-DS-6, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Trane WSHP-DS-6, that we can find in the current document
3. Tips how to use the basic functions of the device Trane WSHP-DS-6 - which should help us in our first steps of using Trane WSHP-DS-6
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Trane WSHP-DS-6
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Trane WSHP-DS-6 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Trane WSHP-DS-6?

Use the form below

If you did not solve your problem by using a manual Trane WSHP-DS-6, ask a question using the form below. If a user had a similar problem with Trane WSHP-DS-6 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)