Manual Toro DT34

12 pages 1.48 mb
Download

Go to site of 12

Summary
  • Toro DT34 - page 1

    Introduction ______________________________________________________________________ The DT34 and DT54 series full-circle rotary sprinklers are designed specifically for golf course applications. Manufactured from durable, high-strength engineering plastic and stainless-steel components, these sprinklers incorporate many innovative and time-proven f ...

  • Toro DT34 - page 2

    2 Precipitation Rate Formulas ❚ Square-spaced sprinklers in pattern: GPM of full circle x 96.3 (Spacing) 2 ❚ Triangular-spaced sprinklers in pattern: GPM of full circle x 96.3 (Spacing) 2 (0.866) ❚ Area and flow: Total GPM of zone x 96.3 Total irrigated square feet of zone ❚ Single row: GPM of full circle x 96.3 (Spacing) (Scallop) Sprinkle ...

  • Toro DT34 - page 3

    Installation Procedure ___________________________________________________ To assure maximum performance from your 800S series sprinklers, read these instructions completely prior to installation or service. Constructing Swing Joints 1. Construct or provide triple swing joints for each sprinkler as shown in Figure 1 . Use PVC or ABS pipe nipple for ...

  • Toro DT34 - page 4

    System Start Up _________________________________________________________ The following is a recommended procedure that will protect system components during system start-up. The procedure is based on a velocity fill rate of less than 2' (.61 m) per second. See Table 3 below. Table 3: Recommended System Fill Rate 1. Use a jockey pump only to f ...

  • Toro DT34 - page 5

    Nozzle T rajectory Adjustment Procedure _______________________________________ Note: The nozzle trajectory is factory pre-set at 25 degrees. 1. Insert the multi-purpose tool (P/N 995-83) into the slot provided in the top of the cap. Pull the riser assembly up, then grasp the assembly to hold it in the popped-up position. 2. Remove the cap retainin ...

  • Toro DT34 - page 6

    T roubleshooting _________________________________________________________ ■ Pilot V alve Possible equipment failures with causes and corrective action are listed below. PROBLEM POSSIBLE CAUSE – CORRECTIVE ACTION SPRINKLER WILL (a) No 24 VAC to coil assembly. (Electric Models) NOT TURN ON – Measure voltage with a Digital Volt Meter (DVM). Che ...

  • Toro DT34 - page 7

    VALVE WON'T CLOSE (a) Leak in control tubing. (Hydraulic) – Isolate and repair. (b) Pilot valve leak in controller. – Confirm by observing constant dripping from discharge line of controller. Refer to Controller Service Manual. (c) Valve cylinder misaligned with sprinkler body communication tube. – Remove valve assembly and install corre ...

  • Toro DT34 - page 8

    Servicing Procedures ____________________________________________________ The DT series sprinklers are designed to provide the user trouble-free operation for many years without scheduled maintenance. If it becomes necessary to disassemble the sprinkler to correct a malfunction or replace a component, all internal parts of the sprinkler can be acce ...

  • Toro DT34 - page 9

    Servicing Main V alve 1. See WARNING above. To remove valve assembly, squeeze snap ring ears together with snap ring pliers (P/N 995-100) and remove snap ring from sprinkler body. See Figure 7 . 2. Use valve removal tool P/N 995-08 for DT34 or 995-09 for DT54 to remove valve assembly from base of sprinkler body. Valve removal tool is inserted into ...

  • Toro DT34 - page 10

    Servicing Pilot V alve Note: Refer to Figure 10 for the following procedure. 1. Make sure that the water supply to sprinkler is positively shut off and any residual pressure has been bled off. If the sprinkler is pressurized, main valve will open when the pilot valve is disconnected from control tube. 2. Carefully remove turf and soil from the side ...

  • Toro DT34 - page 11

    Notes: 11 ...

  • Toro DT34 - page 12

    Notes: © 2007 The Toro Company • Irrigation Division • www.toro.com Form Number 373-0423 Rev. 2 ...

Manufacturer Toro Category Sprinkler

Documents that we receive from a manufacturer of a Toro DT34 can be divided into several groups. They are, among others:
- Toro technical drawings
- DT34 manuals
- Toro product data sheets
- information booklets
- or energy labels Toro DT34
All of them are important, but the most important information from the point of view of use of the device are in the user manual Toro DT34.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Toro DT34, service manual, brief instructions and user manuals Toro DT34. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Toro DT34.

Similar manuals

A complete manual for the device Toro DT34, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Toro DT34 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Toro DT34.

A complete Toro manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Toro DT34 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Toro DT34, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Toro DT34, that we can find in the current document
3. Tips how to use the basic functions of the device Toro DT34 - which should help us in our first steps of using Toro DT34
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Toro DT34
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Toro DT34 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Toro DT34?

Use the form below

If you did not solve your problem by using a manual Toro DT34, ask a question using the form below. If a user had a similar problem with Toro DT34 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Comments (0)