English dropdown-ico

Manual Alto Contractor Diesel

16 pages 0.18 mb
Download

Go to site of 16

Summary
  • Alto Contractor Diesel - page 1

    CONTRACT OR DIESEL Instruktionsbog ............................. 1 - 12 Instruksjonsbok ............................. 13 - 24 Instruktionsbok ............................. 25 - 36 DA SV NO Instruction manual ........................ 37 - 48 Betriebsanleitung .......................... 49 - 60 Manual d ’Instructions.................... 61 - 72 Geb ...

  • Alto Contractor Diesel - page 2

    37 Congratulations! We’d like to say, “Thank You” for choosing the CONTRACTOR DIESEL. This instruction ma- nual is provided with your new High Pressure Washer to ensure that you obtain the best results, in the safest manner, with your new machine. IMPOR T ANT This machine is a High Pressure Washer, capable of producing 2600 psi (180 bar). Rea ...

  • Alto Contractor Diesel - page 3

    38 1.0 Safety E N 11. The machine must not be used in surroundings with risk of fire or explosion. 12 . Exhaust from engine and burner contains poisonous carbon monoxide gases. Avoid inhalation of exhaust gases. Never run the machine in a closed garage or confined area. 13. To prevent fire hazards and to provide adequate ventilation, keep the engin ...

  • Alto Contractor Diesel - page 4

    39 2.0 Motor Protection Device 3.0 Ke y photo’s E N The diesel engine is equipped with a protection device called ”Oil Alert”, which stops the engine if the oil level is insufficient. If this occurs, check the engine for leaks, and after making sure the machine is level, refill it to the proper level. The engine can then be restarted. (See dr ...

  • Alto Contractor Diesel - page 5

    40 4. 0 Application E N 6.0 Accessories E N ALTO’s diesel powered high pressure washers can be used for all outdoor cleaning jobs for which steam, hot or cold water is used. Detergents can be used (see section 8.5) 4 .1 Handling and T ransport When handling the machine with a fork lift truck, be sure the forks extend completely under the machine ...

  • Alto Contractor Diesel - page 6

    41 a Inlet quick-connector b Water filter c High pressure pump d Unloader/regulator (recycling valve) e Flow switch f Throttle valve g Flow switch h Burner coil i Temperature sensor j Outlet quick-connector k Spray handle I Double spray lance m Fuel tank ”Jerry-can” n Burner fuel filter o Fuel pump p Magnetic solenoid valve q Fuel nozzle r Blow ...

  • Alto Contractor Diesel - page 7

    42 Functional description E N 7. 4 Spray lance The double spray lance is fitted with 2 nozzles, a high pressure nozzle and a low pressure nozzle. When the pressure adjustment valve (pos. 27) is completely closed only the high pressure nozzle is used. Both the high pres- sure nozzle and the low pressure nozzle are used when the pressure adjustment v ...

  • Alto Contractor Diesel - page 8

    43 8.0 Connections E N 8 . 4 Suction Mode The machine is self priming, when used from a tank or stream, etc. The inlet hose must be filled with water before starting up. The self priming height depends on the water temperature. Max. self priming height of 5 m (17 ft) is reached with cold water (up to 8°C/47°F). Foreign material in the water suppl ...

  • Alto Contractor Diesel - page 9

    44 9 .0 Operating instructions E N d ) Start the machine, if stopped, and activate the spray handle to start the burner. IMPORTANT: For safety reasons it is important that instruction (a), above, always be followed! Note: If the engine stops immediately after having been started up, it should be checked whether the throttle control is set at idle s ...

  • Alto Contractor Diesel - page 10

    45 10.0 Storage/frost proofing 11.0 Model tag It is advisable to store the machine in a frost proof place between operations. If this is not possible the machine should be protected in the following way: 1. Disconnect the inlet hose. Remove the lance (pos. 29) and empty it of water. 2. Ensure that the thermostat is set in the blue field, and start ...

  • Alto Contractor Diesel - page 11

    46 12.0 Maintenance E N 2. ENGINE OIL CHANGE Refer to the Ruggerini engine manual for break- in and normal operating oil change requirements. Carry out first oil change after i0 hours of operation and then every 100 hours. Not less than once every six months, however. NOTE: Protect the environment by properly disposing of used pump and engine oil. ...

  • Alto Contractor Diesel - page 12

    47 Maintenance E N 13.0 W arranty E N 5. Leave the machine for 20 minutes. 6. Start the machine and pump the used solution into a container for proper disposal. 7. Immediately connect a fresh water supply and turn it on. 8. Start the machine, let it work for 5-10 minutes, until all the scale remover is out of the system. 9. If necessary, repeat the ...

  • Alto Contractor Diesel - page 13

    14.0 T r oubleshooting E N Fault Cause Repair The engine fails to start Insufficient diesel supply Refill diesel tank. Battery run down Recharge the battery*) Fuse blown Exchange fuse. See section 3.0. The pump is frozen Let the pump thaw. Working pressure too high Nozzle partly blocked Clean the nozzle. See section 12.6. Working pressure Valve for ...

  • Alto Contractor Diesel - page 14

    ...

  • Alto Contractor Diesel - page 15

    ...

  • Alto Contractor Diesel - page 16

    AL T O Danmark A/S Industrikvar teret DK-9560 Hadsund T el.: +45 7218 2100 www .alto-online.dk Printed in Denmar k Copyright © 2003 AL TO Danmark A/S 6229952 (02.2003) ...

Manufacturer Alto Category Pressure Washer

Documents that we receive from a manufacturer of a Alto Contractor Diesel can be divided into several groups. They are, among others:
- Alto technical drawings
- Contractor Diesel manuals
- Alto product data sheets
- information booklets
- or energy labels Alto Contractor Diesel
All of them are important, but the most important information from the point of view of use of the device are in the user manual Alto Contractor Diesel.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Alto Contractor Diesel, service manual, brief instructions and user manuals Alto Contractor Diesel. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Alto Contractor Diesel.

Similar manuals

A complete manual for the device Alto Contractor Diesel, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Alto Contractor Diesel by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Alto Contractor Diesel.

A complete Alto manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Alto Contractor Diesel - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Alto Contractor Diesel, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Alto Contractor Diesel, that we can find in the current document
3. Tips how to use the basic functions of the device Alto Contractor Diesel - which should help us in our first steps of using Alto Contractor Diesel
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Alto Contractor Diesel
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Alto Contractor Diesel in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Alto Contractor Diesel?

Use the form below

If you did not solve your problem by using a manual Alto Contractor Diesel, ask a question using the form below. If a user had a similar problem with Alto Contractor Diesel it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)