English dropdown-ico

Manual Stanley Black & Decker AL35

20 pages 3.1 mb
Download

Go to site of 20

Summary
  • Stanley Black & Decker AL35 - page 1

    © 2014 Stanley Black & Decker , Inc. New Britain, CT 06053 U.S.A. 16798 8/2014 V er . 6 USER MANUAL Safety , Operation and Maintenance AL35 HYDRAULIC AL TERNA T OR ...

  • Stanley Black & Decker AL35 - page 2

    ...

  • Stanley Black & Decker AL35 - page 3

    AL35 User Manual ◄ 3 SERVICING: This manual contains safety , operation, and routine maintenance instructions. Stanley Hydraulic T ools recommends that servicing of hydraulic tools, other than routine maintenance, must be performed by an authorized and certied dealer . Please read the following warning. For the nearest authorized and certie ...

  • Stanley Black & Decker AL35 - page 4

    4 ► AL35 User Manual Always observe safety symbols. They are included for your safety and for the protection of the tool. LOCAL SAFETY REGULA TIONS Enter any local safety regulations here. Keep these instructions in an area accessible to the operator and mainte- nance personnel. Safety symbols and signal words, as shown below , are used to emphas ...

  • Stanley Black & Decker AL35 - page 5

    AL35 User Manual ◄ 5 T ool operators and maintenance personnel must always comply with the safety precautions given in this manual and on the stickers and tags attached to the tool and hose. These safety precautions are given for your safety . Re- view them carefully before operating the tool and before performing general maintenance or repairs. ...

  • Stanley Black & Decker AL35 - page 6

    6 ► AL35 User Manual • Do not start the alternator with electrical loads con- nected and in a power “ON” state. • Ensure that the alternator is at operating speed/volt- age before connecting an electrical load. • Only use hydraulic hose labeled and certied as non-conductive when using hydraulic tools on or near electrical lines. Fail ...

  • Stanley Black & Decker AL35 - page 7

    AL35 User Manual ◄ 7 SAFETY T AG P/N 15875 (Shown smaller then actual size) DANGER DANGER READ OPERA TION MANUAL AND SAFETY INSTRUCTIONS FOR THIS TOOL BEFORE USING IT . USE ONL Y P ARTS AND REP AIR PROCEDURES APPROVED BY ST ANLEY AND DESCRIBED IN THE OPERA TION MANUAL. T AG TO BE REMOVED ONL Y BY TOOL OPERA TOR. SEE OTHER SIDE 1. FAILURE TO USE H ...

  • Stanley Black & Decker AL35 - page 8

    8 ► AL35 User Manual The rated working pressure of the hydraulic hose must be equal to or higher than the relief valve setting on the hy- draulic system. There are three types of hydraulic hose that meet this requirement and are authorized for use with Stanley Hydraulic T ools. They are: Certied non-conductive — constructed of thermoplastic ...

  • Stanley Black & Decker AL35 - page 9

    AL35 User Manual ◄ 9 Oil Flow Hose Lengths Inside Diameter USE ( Press/Return) Min. Working Pressure GPM LPM FEET METERS INCH MM PSI BAR Certied Non-Conductive Hose - Fiber Braid - for Utility Bucket T rucks 4-9 15-34 up to 10 up to 3 3/8 10 Both 2250 155 Conductive Hose - Wire Braid or Fiber Braid -DO NOT USE NEAR ELECTRICAL CONDUCT ORS 4-6 1 ...

  • Stanley Black & Decker AL35 - page 10

    10 ► AL35 User Manual Flow Range Nominal Operating Pressure (at the power supply outlet) System relief valve setting (at the power supply outlet) Maximum back pressure (at tool end of the return hose) Measured at a max. uid viscosity of: (at min. operating temperature) T emperature: Sufcient heat rejection capacity to limit max. uid temp ...

  • Stanley Black & Decker AL35 - page 11

    AL35 User Manual ◄ 1 1 OPERA TION PROCEDURES 1. Observe all safety precautions. 2. CA UTION Do not connect or otherwise apply power to an electrical load until the alternator has come up to speed. Move the hydraulic circuit control to the “ON” posi- tion. As the alternator comes up to speed, a maxi- mum electrical load of 3500 W , single‑ph ...

  • Stanley Black & Decker AL35 - page 12

    12 ► AL35 User Manual PREVENT A TIVE MAINTENANCE SCHEDULE IN DIRTY OR MOIST ENVIRONMENTS 90 DA Y INTERV ALS If the unit is operated or stored in a dirty , moist, or salt moisture environment, the electrical contacts, rotor and stator should be inspected and cleaned every 90 days or more frequently as deemed necessary . IN CLEAN, DR Y ENVIRONMENTS ...

  • Stanley Black & Decker AL35 - page 13

    AL35 User Manual ◄ 13 • Make sure all couplers are wiped clean before con- nection. • The hydraulic circuit control valve must be in the “OFF” position when coupling or uncoupling hydrau- lic tools. Failure to do so may result in damage to the quick couplers and cause overheating of the hy- draulic system. • Always store the tool in a c ...

  • Stanley Black & Decker AL35 - page 14

    14 ► AL35 User Manual PROBLEM CAUSE REMEDY T ool does not run. Power unit not functioning. Check power unit for power ow and pressure (7-9 gpm/26-34 lpm, 2000 psi/140 bar . Couplers or hoses blocked. Remove restriction. Hyrevz motor failure. Inspect and repair . Hydraulic lines not connected. Connect lines. No electrical output. Open circuit b ...

  • Stanley Black & Decker AL35 - page 15

    AL35 User Manual ◄ 15 The AL35 is a hydraulic motor powered electrical alternator , designed to provide power for lights, small power tools, and small appliances. It produces 3500 watts of power at a nominal 120/240 volts AC single phase at 60 Hz frequency . The unit requires hydraulic power delivered at 7–9 gallons per minute (gpm) with pressu ...

  • Stanley Black & Decker AL35 - page 16

    16 ► AL35 User Manual 2 4 3 2 5 21 22 16 1 7 8 9 3 14 13 12 6 15 17 18 19 20 22 21 23 25 24 27 40 36 37 35 42 39 21 22 20 32 43 31 10 28 30 26 41 38 AL35 ALTERNATOR August 1998 AL35 P ARTS ILLUSTRA TION ...

  • Stanley Black & Decker AL35 - page 17

    AL35 User Manual ◄ 17 ITEM P ART NO. QTY DESCRIPTION 1 15100 1 VOL TMETER 2 COM* 4 PHILLIPS HEAD MACHINE SCREW 3 COM* 4 W ASHER 4 1 RECEPT ACLE P ANEL 5 15101 1 RECEPT ACLE, 30 A, 120 V 6 15103 1 RECEPT ACLE, 15 A, 240 V 7 — — INCLUDED WITH ITEM 1 8 15106 1 CIRCUIT BREAKER, 30 A 9 35235 1 CAP ACITOR 10 05734 4 CAPSCREW , 3/8‑16 × 2 HEX HEA ...

  • Stanley Black & Decker AL35 - page 18

    18 ► AL35 User Manual ITEM P ART NO. QTY DESCRIPTION 1 00120 8 CAPSCREW, 1/4‑20 × 2-1/4 HSH 2 07386 1 GEAR HOUSING ASSEMBL Y (INCLUDES ITEMS 3 & 4) 3 00713 2 DOWEL PIN 4 06316 4 BUSHING 5 00178 1 O-RING * 6 73309 1 IDLER SHAFT 7 06853 2 DRIVE GEAR 9 21432 BEARING HOUSING ASSEMBL Y (INCLUDES ITEM 4) 10 00669 1 QUAD RING * 11 00171 1 O-RING ...

  • Stanley Black & Decker AL35 - page 19

    AL35 User Manual ◄ 19 CAPACITOR TO FRAME 6 GND 5 GOLD GOLD GOLD SILVER 4 3 2 2 1 1 1 2 3 4 5 6 7 8 9 14 AWG BLK(P) 1 14 AWG BLK(P) 2 14 AWG WHT(P) 3 14 AWG WHT(P) 4 14 AWG WHT(P) 5 14 AWG BLK(P) 6 14 AWG GRN(P) 8 14 AWG GRN J1 P1 16 AWG RED 16 AWG RED G X W 14 AWG GRN 14 AWG WHT 14 AWG BLK 14 AWG BLK 14 AWG GRN GND NEMA L530R 115V 30A 14 AWG BLK ...

  • Stanley Black & Decker AL35 - page 20

    Stanley Hydraulic T ools 3810 SE Naef Road Milwaukie, Oregon 97267-5698 USA (503) 659-5660 / Fax (503) 652-1780 www .stanleyhydraulics.com ...

Manufacturer Stanley Black & Decker Category Automobile Parts

Documents that we receive from a manufacturer of a Stanley Black & Decker AL35 can be divided into several groups. They are, among others:
- Stanley Black & Decker technical drawings
- AL35 manuals
- Stanley Black & Decker product data sheets
- information booklets
- or energy labels Stanley Black & Decker AL35
All of them are important, but the most important information from the point of view of use of the device are in the user manual Stanley Black & Decker AL35.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Stanley Black & Decker AL35, service manual, brief instructions and user manuals Stanley Black & Decker AL35. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Stanley Black & Decker AL35.

Similar manuals

A complete manual for the device Stanley Black & Decker AL35, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Stanley Black & Decker AL35 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Stanley Black & Decker AL35.

A complete Stanley Black & Decker manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Stanley Black & Decker AL35 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Stanley Black & Decker AL35, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Stanley Black & Decker AL35, that we can find in the current document
3. Tips how to use the basic functions of the device Stanley Black & Decker AL35 - which should help us in our first steps of using Stanley Black & Decker AL35
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Stanley Black & Decker AL35
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Stanley Black & Decker AL35 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Stanley Black & Decker AL35?

Use the form below

If you did not solve your problem by using a manual Stanley Black & Decker AL35, ask a question using the form below. If a user had a similar problem with Stanley Black & Decker AL35 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)