English dropdown-ico

Manual Tannoy Highline 500

20 pages 1.85 mb
Download

Go to site of 20

Summary
  • Tannoy Highline 500 - page 1

    OWNER’ S MANUAL ...

  • Tannoy Highline 500 - page 2

    CONTENTS INTRODUCTION 3 SA TELLITE What’ s in the box? 4 How to wall mount 5 ST AND MOUNT What's in the box? 8 How to stand mount 9 CENTRE CHANNEL What’ s in the box? 10 How to wall mount 1 1 TOWER What’ s in the box? 13 How to connect 14 ROOM SET UP 15 CONNECT TO RECEIVER 16 SPECIFICA TIONS 17 W ARRANTY This equipment has been produced ...

  • Tannoy Highline 500 - page 3

    INTRODUCTION Thank you for selecting T annoy loudspeakers developed in the UK by our dedicated team of design engineers. The T annoy Arena Highline 500™ speakers are designed to blend perfectly into your room and provide a sound stage which is at least as good as you would hear in a commercial movie theatre, but in the comfort of your own home. Y ...

  • Tannoy Highline 500 - page 4

    SA TELLITE Wha t’s in the box? 1 x Satellite speaker 1 x Long wall bracket 1 x Short bracket with pre-fitted cap 1 x Short bracket without pre-fitted cap 1 x Bracket cap 4 x 8mm Silver hex socket fixing screw + lock washers 1 x 5mm black cap head fixing screw + spring washer 1 x Ball nosed Allen key Required but not included: Sufficient cable for ...

  • Tannoy Highline 500 - page 5

    SATELLITE How to wall mount WARNING: It is your responsibility to ensure that the bracket to wall fixing screws or bolts and the walls themselves are strong enough to support the weight of the speaker – refer to the speaker weight specifications supplied in this manual. Particular care is needed when fixing to hollow or cavity walls - ‘'st ...

  • Tannoy Highline 500 - page 6

    SA TELLITE How to wall mount - continued Cut the speaker wire so that the (+) side is slightly longer than the (-) side and feed the speaker wire through spare bracket cap. Important Note: It is essential that the speakers are wired correctly at this stage. The (-) wire should have a solid black line, or similar , marked along it. Screw (+) wire in ...

  • Tannoy Highline 500 - page 7

    SATELLITE How to wall mount - continued Fix spare cap to bottom of bracket using cap screw and spring washer provided 7 ...

  • Tannoy Highline 500 - page 8

    8 ST AND MOUNT What’ s in the box? 1 x Stand mount 2 x Lock washers 2 x Fixing screws 6 x Spikes 6 x Rubber feet 6 x M6 nuts ...

  • Tannoy Highline 500 - page 9

    ST AND MOUNT How to stand mount Attach the spike kits, or rubber feet, to the bottom of the stand then thread the cable through the stand base and shaft. Cut the speaker wire so that the (+) wire is slightly longer than the (-) wire. Screw the (+) wire into the red terminal and screw (-) wire into black terminal. Important Note : It is essential th ...

  • Tannoy Highline 500 - page 10

    CENTRE CHANNEL What’s in the box? 1 x Centre speaker 1 x Long wall bracket 1 x Short bracket with pre-fitted cap 1 x Short bracket without pre-fitted cap 1 x Bracket cap 4 x 8mm Silver hex socket fixing screw + lock washers 1 x 5mm Black cap head fixing screw + spring washer 1 x Ball nosed allen key 1 x Small stand Required but not included: Suff ...

  • Tannoy Highline 500 - page 11

    CENTRE CHANNEL How to wall mount WARNING: It is your responsibility to ensure that the bracket to wall fixing screws or bolts and the walls themselves are strong enough to support the weight of the speaker - refer to the speaker weight specifications supplied in this manual. Particular care is needed when fixing to hollow or cavity walls - ‘&apos ...

  • Tannoy Highline 500 - page 12

    CENTRE CHANNEL How to wall mount - continued Offer the speaker up to the wall bracket half way along. Engage speaker with bracket and slide across. Ensure cap is fully engaged with the wall bracket. Fix spare cap to bottom of bracket using the cap screw and spring washer provided. 12 ...

  • Tannoy Highline 500 - page 13

    13 T OWER What’s in the box? 1 x Tower speaker 6 x Spikes 6 x Rubber Feet 6 x M6 Nuts Required but not included: Sufficient cable for your requirements ...

  • Tannoy Highline 500 - page 14

    TOWER How to connect Attach the spike kits or rubber feet to the base of the tower then thread the speaker cable through the base. Cut the speaker wire so that the (+) wire is slightly longer than the (-). Screw the (+) wire into the red terminal and screw (-) wire into the black terminal. Important Note : It is essential that the speakers are wire ...

  • Tannoy Highline 500 - page 15

    ROOM SETUP A 5.1 surround sound system consists of 5 separate speakers and 1 subwoofer. The centre channel is designed to reproduce most of the dialogue or solo performances. The front left and right speakers reproduce the left/right stereo information and special effects. The rear left and right speakers reproduce special effects. Try to get all 3 ...

  • Tannoy Highline 500 - page 16

    CONNECTING THE SYSTEM TO YOUR A V RECEIVER Wire up the system connecting each speaker to the appropriate terminals on the receiver or amplifier making sure that cables connect red to red terminals (+ to +) and black to black terminals (- to - ). Please note : (+) is shown as grey, (-) is shown as white. Take care to distinguish between left and rig ...

  • Tannoy Highline 500 - page 17

    TECHNICAL SPECIFICATIONS ARENA HIGHLINE 500, CENTRE & SATELLITE SPEAKER PERFORMANCE: Recommended amplifier power 25 - 100W RMS Maximum sensitivity (2.83V @ 1m) 88dB Nominal impedance 8 Ohm Frequency response (-6dB) 85Hz- 54kHz Drivers 1 x 100mm (4”) Dual Concentric TM with 19mm (0.75”) HF 1 x 100mm (4”) LF Crossover frequency 1.75kHz Magn ...

  • Tannoy Highline 500 - page 18

    209.0mm (8.23”) 197.0mm (7.76”) 759.5 (29.90”) 999.5 - 1 199.5mm (39.35” - 47.22”) TECHNICAL SPECIFICA TIONS ARENA HIGHLINE 500 SATELLITE ACCESSORY STAND Weight 5.9kg (13lbs) Dimensions H x W x D 760 x 209 x 197mm (29.90 x 8.23 x 7.76 ins) Finish Black gloss or silver gloss 18 ...

  • Tannoy Highline 500 - page 19

    209.0mm (8.23”) 197.0mm (7.76”) 1160.5mm (45.69”) TECHNICAL SPECIFICA TIONS ARENA HIGHLINE 500, TOWER SPEAKER PERFORMANCE: Recommended amplifier power 25 - 100W RMS Maximum sensitivity (2.83V @ 1m) 88dB Nominal impedance 8 Ohm s Frequency response (-6dB) 75Hz- 54kHz Drivers 1 x 100mm (4”) Dual Concentric TM with 19mm (0.75”) HF 1 x 100mm ...

  • Tannoy Highline 500 - page 20

    Check periodically for the latest manual revision that will always be available for download from www.tannoy.com The issue number of this manual is located below Part No. 6481 0481 / MAR 06 T annoy United Kingdom T : +44 (0) 1236 420199 F: +44 (0) 1236 428230 E: enquiries@tannoy .com T annoy North America T : (519) 745 1158 F: (519) 745 2364 E: inq ...

Manufacturer Tannoy Category Portable Speaker

Documents that we receive from a manufacturer of a Tannoy Highline 500 can be divided into several groups. They are, among others:
- Tannoy technical drawings
- Highline 500 manuals
- Tannoy product data sheets
- information booklets
- or energy labels Tannoy Highline 500
All of them are important, but the most important information from the point of view of use of the device are in the user manual Tannoy Highline 500.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Tannoy Highline 500, service manual, brief instructions and user manuals Tannoy Highline 500. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Tannoy Highline 500.

Similar manuals

A complete manual for the device Tannoy Highline 500, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Tannoy Highline 500 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Tannoy Highline 500.

A complete Tannoy manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Tannoy Highline 500 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Tannoy Highline 500, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Tannoy Highline 500, that we can find in the current document
3. Tips how to use the basic functions of the device Tannoy Highline 500 - which should help us in our first steps of using Tannoy Highline 500
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Tannoy Highline 500
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Tannoy Highline 500 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Tannoy Highline 500?

Use the form below

If you did not solve your problem by using a manual Tannoy Highline 500, ask a question using the form below. If a user had a similar problem with Tannoy Highline 500 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)