Weil-McLain 105の取扱説明書

12ページ 0.49 mb
ダウンロード

ページに移動 of 12

Summary
  • Weil-McLain 105 - page 1

    V ent Supplement This document must only be used by a qualified heating installer/service technician. Read all instructions, including this Supplement and the Boiler Manual, before installing. P erform st eps in the order given. Failure to c omply could r esult in se ver e pe rsonal inju r y , d eath or substantial property damag e. Installation mu ...

  • Weil-McLain 105 - page 2

    Part number 550-101-235/0903 2 GAS - FIRED WA TER BOILER — V ent Supplement Please read before proceeding Installer Read all instructions before installing. Follow all instructions in proper order to prevent personal injury or death. • This document is intended only as a supplement to the Ultra Boiler Manual. It’ s purpose is fo r the install ...

  • Weil-McLain 105 - page 3

    Part number 550-101-235/0903 3 GAS - FIRED WA TER BOILER — V ent Supplement V ent and air piping materials Use only the materials listed in the table below for vent and air pipe and fittings. Failure to comply could result in sever e personal injur y , death or substantial pr opert y damage. 1 Installation must comply with local requirements and ...

  • Weil-McLain 105 - page 4

    Part number 550-101-235/0903 4 GAS - FIRED WA TER BOILER — V ent Supplement Pr epare boiler location V ent and air piping Vent and air system Installation must comply with local requir ements and with the National F uel Gas Code, ANSI Z223.1 fo r U.S. installations or CSA B149.1 or B149.2 for Canadian installations. The Ultra boiler requires a sp ...

  • Weil-McLain 105 - page 5

    Part number 550-101-235/0903 5 GAS - FIRED WA TER BOILER — V ent Supplement Pr epare boiler location (continued) Table 1 Corrosive contaminants 2 T o preve nt the p otential of severe personal injury or death, check for areas and pr oducts listed in T able 1 before installing the boiler or air inlet piping. If contaminants are found, you MUST : ? ...

  • Weil-McLain 105 - page 6

    Part number 550-101-235/0903 6 GAS - FIRED WA TER BOILER — V ent Supplement V ent/air ter mination — thr ough r oof 3 Figure 1 V er tical termination of air & vent Determine location Locate the vent/air terminations using the following guidelines: 1. The total length of piping for vent or air must not ex ceed the limits given in T able 2, p ...

  • Weil-McLain 105 - page 7

    Part number 550-101-235/0903 7 GAS - FIRED WA TER BOILER — V ent Supplement V ent/air ter mination — thr ough r oof (continued) 3 Prepare roof penetrations 1 . Air pipe penetration: a. Cut a hole for the air pipe. Size the air pipe hole as close as desired to the air pipe outside diamet er . 2 . V ent pipe p enetrat ion: a . Cut a hole for the ...

  • Weil-McLain 105 - page 8

    Part number 550-101-235/0903 8 GAS - FIRED WA TER BOILER — V ent Supplement V ent/air ter mination — sidewall 4 Determine location Locate the vent/air terminations using the following guidelines: 1. The total length of piping for vent or air must not ex ceed the limits given in T able 2, page 12. 2 . The air piping must terminate in a down-turn ...

  • Weil-McLain 105 - page 9

    Part number 550-101-235/0903 9 GAS - FIRED WA TER BOILER — V ent Supplement Prepare wall penetrations 1. Air pipe penetration: a. Cut a hole for the air pipe. Size the air pipe hole as close as desired to the air pipe outside diameter . 2. V ent pipe pene trat ion: a . Cut a hole for the vent pipe. For either combustible or noncombustible constru ...

  • Weil-McLain 105 - page 10

    Part number 550-101-235/0903 10 GAS - FIRED WA TER BOILER — V ent Supplement Figure 7 Multiple vent/air terminations (must also comply with Figure 4) Figure 8 Multiple vent/air terminations (must also comply with Figure 4) (Apply this method only where exit openings are too low to provide minimum 12 inch clearance above grade/snow line.) V ent/ai ...

  • Weil-McLain 105 - page 11

    Part number 550-101-235/0903 11 GAS - FIRED WA TER BOILER — V ent Supplement Installing vent & air piping 5 Inserting/securing vent or air pipe into boiler adapters 1 . Clean and chamfer insertion end of pipe. Deburr inside of insertion end. Clean and deburr inside and outside of other end of pipe. The pipe end must be smooth and chamfered to ...

  • Weil-McLain 105 - page 12

    Part number 550-101-235/0903 12 GAS - FIRED WA TER BOILER — V ent Supplement Installing vent & air piping (continued) 5 Figure 10 Piping to through-roof terminations Figure 9 Piping to sidewall terminations Ta b l e 2 Min/max lengths of either air piping or vent piping When a large number of elbows is needed with 3-inch piping, use long radiu ...

メーカー Weil-McLain カテゴリー Boiler

Weil-McLain 105のメーカーから受け取ることができるドキュメントは、いくつかのグループに分けられます。その一部は次の通りです:
- #BRANDの図面#
- 105の取扱説明書
- Weil-McLainの製品カード
- パンフレット
- またはWeil-McLain 105の消費電力シール
それらは全部重要ですが、デバイス使用の観点から最も重要な情報は、Weil-McLain 105の取扱説明書に含まれています。

取扱説明書と呼ばれる文書のグループは、Weil-McLain 105の取り付け説明書、サービスマニュアル、簡易説明書、またはWeil-McLain 105のユーザーマニュアル等、より具体的なカテゴリーに分類されます。ご必要に応じてドキュメントを検索しましょう。私たちのウェブサイトでは、Weil-McLain 105の製品を使用するにあたって最も人気のある説明書を閲覧できます。

関連する取扱説明書

Weil-McLain 105デバイスの取扱説明書はどのようなものですか?
取扱説明書は、ユーザーマニュアル又は単に「マニュアル」とも呼ばれ、ユーザーがWeil-McLain 105を使用するのを助ける技術的文書のことです。説明書は通常、全てのWeil-McLain 105ユーザーが容易に理解できる文章にて書かれており、その作成者はその分野の専門家です。

Weil-McLainの取扱説明書には、基本的な要素が記載されているはずです。その一部は、カバー/タイトルページ、著作権ページ等、比較的重要度の低いものです。ですが、その他の部分には、ユーザーにとって重要な情報が記載されているはずです。

1. Weil-McLain 105の説明書の概要と使用方法。説明書にはまず、その閲覧方法に関する手引きが書かれているはずです。そこにははWeil-McLain 105の目次に関する情報やよくある質問、最も一般的な問題に関する情報を見つけられるはずです。つまり、それらはユーザーが取扱説明書に最も期待する情報なのです。
2. 目次。Weil-McLain 105に関してこのドキュメントで見つけることができる全てのヒントの目次
3. Weil-McLain 105デバイスの基本機能を使うにあたってのヒント。 Weil-McLain 105のユーザーが使い始めるのを助けてくれるはずです。
4. トラブルシューティング。Weil-McLain 105に関する最も重要な問題を診断し、解決するために役立つ体系化された手続き
5. FAQ。よくある質問
6. 連絡先。一人では問題を解決できない場合に、その国におけるWeil-McLain 105のメーカー/サービスへの連絡先に関する情報。

Weil-McLain 105についてご質問がありますか?

次のフォームを使用してください

見つけた説明書を読んでもWeil-McLain 105の問題を解決できない場合、下記のフォームを使用して質問をしましょう。ユーザーのどなたかがWeil-McLain 105で同様の問題を抱えていた場合、その解決方法を共有したいと考えるかもしれません。

画像のテキストを入力してください

コメント (0)