English dropdown-ico

Manual Harman Stove Company R6

13 pages 0.44 mb
Download

Go to site of 13

Summary
  • Harman Stove Company R6 - page 1

    1 R6 INVINCIBLE "RS" OWNERS MANUAL ...

  • Harman Stove Company R6 - page 2

    2 Contents Manufactur ed by Harman Stove Company 352 Mountain House Road Halifax Pa. 17032 (717) 362-9080 Packing List 3 Installation & Assembly 3 V enting 5 Operation 9 ESP Control 1 2 Maintenance 1 3 W iring Diagram 1 6 Feeder Parts 1 7 T r ouble Shooting 18 Specifications 1 9 W arnings 2 0 ...

  • Harman Stove Company R6 - page 3

    3 Packing List Assembly and Installation Final Assembly Remove parts from ash pan. Install W ooden Door Handle with 1/4 x 20 x 2 1/2 bolt. Install Brass Hopper Knob with 10-32 x 1/2 bolt. Install the two Firebricks on the angle iron behind the burn pot as shown in fig. 1. Remove tape from Flame Guide and make sure it is resting on the burn pot as s ...

  • Harman Stove Company R6 - page 4

    4 Installing Place the stove on a noncombustible floor pro- tector and away from combustible walls at least as far as shown in figure 2 and 3. Note that the clear- ances shown are minimum for safety but do not leave much room for access when cleaning or servicing. Please take this into account when placing the stove. Place the Room Sensing Probe in ...

  • Harman Stove Company R6 - page 5

    5 V enting A combustion blower is used to extract the com- bustion gases from the firebox. This causes a nega- tive pressure in the firebox and a positive pressure in the venting system as shown in fig. 4. The longer the vent pipe and more elbows used in the system, the greater the flow resistance. Because of these facts we recommend using as few e ...

  • Harman Stove Company R6 - page 6

    6 #2 Preferr ed method This method also provides excellent venting for normal operation but requires the stove to be installed farther from the wall. The vertical portion of the vent should be three to five feet high and at least three inches from a combustible wall. This vertical section will provide natural draft in the event of a power fail- ure ...

  • Harman Stove Company R6 - page 7

    7 #4 Installing into an existing chimney ( US only ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure. If the chimney condition is questionable you may want to install a liner as in method #7. #5 Installing into an existing fireplace chimney ( US only ) This metho ...

  • Harman Stove Company R6 - page 8

    8 #6 Installing into an existing fireplace chimney ( US and Canada ) This method provides excellent venting for nor- mal operation. This method also provides natural draft in the event of a power failure. In Canada and some places in the US it is re- quired that the vent pipe extend all the way to the top of the chimney . In this method a cap shoul ...

  • Harman Stove Company R6 - page 9

    9 DO NOT INST ALL A FLUE DAMPER IN THE EXHAUST VENTING SYSTEM OF THIS UNIT . DO NOT CONNECT THIS UNIT TO A CHIMNEY FLUE SER VING ANOTHER APPLIANCE. INST ALL VENT A T CLEARANCES SPECIFIED BY THE MANUF ACTURER Mobile home installation should be done in accordance with the Manufactured Home and Safety Standard (HUD), CFR 3280, Part 24. DO NOT INST ALL ...

  • Harman Stove Company R6 - page 10

    10 Operation Starting First Fir e Be sure the power cord is plugged into a 120 volt receptacle. This can be verified by the red power light on the control panel. Fill the hopper with pellets, fig. 12. Fill the burn pot with pellets to a level just short of overflowing, fig. 8. Adjust feed rate . If this is your first fire or you are trying differen ...

  • Harman Stove Company R6 - page 11

    11 Starting a fir e after pr oper Feed Rate is known. Clean burn pot with scraper (supplied). Fill the hopper with pellets. Fill the burn pot with pellets to a level just short of overflowing. Adjust feed rate to proper setting. After you know what feed rate works well, then use that setting. (For example a setting of "5" produces 1" ...

  • Harman Stove Company R6 - page 12

    12 When to use "Stove T emp Mode" In "Stove T emp Mode" the Stove T emp Dial determines the temperature of the stove. Heat output and fuel consumption will remain con- stant. This makes it possible to tell how long a hopper full of pellets will last. The distribution blower speed will vary according to the position of the mode s ...

  • Harman Stove Company R6 - page 13

    13 ESP CONTROL Feed adjuster Sets the maximum feed rate T est Runs all motors at full speed for two minutes to check operation. After two minutes the stove will go to minimum burn and the blowers will alternate fr om high to low every two minutes to remind you that you are still in "T est Mode". Distribution Blower speed adjustment range. ...

Manufacturer Harman Stove Company Category Cooktop

Documents that we receive from a manufacturer of a Harman Stove Company R6 can be divided into several groups. They are, among others:
- Harman Stove Company technical drawings
- R6 manuals
- Harman Stove Company product data sheets
- information booklets
- or energy labels Harman Stove Company R6
All of them are important, but the most important information from the point of view of use of the device are in the user manual Harman Stove Company R6.

A group of documents referred to as user manuals is also divided into more specific types, such as: Installation manuals Harman Stove Company R6, service manual, brief instructions and user manuals Harman Stove Company R6. Depending on your needs, you should look for the document you need. In our website you can view the most popular manual of the product Harman Stove Company R6.

Similar manuals

A complete manual for the device Harman Stove Company R6, how should it look like?
A manual, also referred to as a user manual, or simply "instructions" is a technical document designed to assist in the use Harman Stove Company R6 by users. Manuals are usually written by a technical writer, but in a language understandable to all users of Harman Stove Company R6.

A complete Harman Stove Company manual, should contain several basic components. Some of them are less important, such as: cover / title page or copyright page. However, the remaining part should provide us with information that is important from the point of view of the user.

1. Preface and tips on how to use the manual Harman Stove Company R6 - At the beginning of each manual we should find clues about how to use the guidelines. It should include information about the location of the Contents of the Harman Stove Company R6, FAQ or common problems, i.e. places that are most often searched by users in each manual
2. Contents - index of all tips concerning the Harman Stove Company R6, that we can find in the current document
3. Tips how to use the basic functions of the device Harman Stove Company R6 - which should help us in our first steps of using Harman Stove Company R6
4. Troubleshooting - systematic sequence of activities that will help us diagnose and subsequently solve the most important problems with Harman Stove Company R6
5. FAQ - Frequently Asked Questions
6. Contact detailsInformation about where to look for contact to the manufacturer/service of Harman Stove Company R6 in a specific country, if it was not possible to solve the problem on our own.

Do you have a question concerning Harman Stove Company R6?

Use the form below

If you did not solve your problem by using a manual Harman Stove Company R6, ask a question using the form below. If a user had a similar problem with Harman Stove Company R6 it is likely that he will want to share the way to solve it.

Copy the text from the picture

Captcha
New picture

Comments (0)